Between source and sea: The role of wastewater treatment in reducing marine microplastics.

Wastewater treatment plants (WWTPs) are a focal point for the removal of microplastic (MP) particles before they are discharged into aquatic environments. WWTPs are capable of removing substantial quantities of larger MP particles but are inefficient in removing particles with any one dimension of less than 100 µm, with influents and effluents tending to have similar quantities of these smaller particles. As a single WWTP may release >100 billion MP particles annually, collectively WWTPs are significant contributors to the problem of MP pollution of global surface waters. Currently, there are no policies or regulations requiring the removal of MPs during wastewater treatment, but as concern about MP pollution grows, the potential for wastewater technologies to capture particles before they reach surface waters has begun to attract attention. There are promising technologies in various stages of development that may improve the removal of MP particles from wastewater. Better incentivization could speed up the research, development and adoption of innovative practices. This paper describes the current state of knowledge regarding MPs, wastewater and relevant policies that could influence the development and deployment of new technologies within WWTPs. We review existing technologies for capturing very small MP particles and examine new developments that may have the potential to overcome the shortcomings of existing methods. The types of collaborations needed to encourage and incentivize innovation within the wastewater sector are also discussed, specifically strong partnerships among scientific and engineering researchers, industry stakeholders, and policy decision makers.

Mechanism of nanoplastics capture by jellyfish mucin and its potential as a sustainable water treatment technology.

The accumulation of nanoplastics (NPs) in the environment has raised concerns about their impact on human health and the biosphere. The main aim of this study is to understand the mechanism that governs the capture of NPs by jellyfish mucus extracted from the jellyfish Aurelia sp. (A.a.) and compare the capture/removal efficiency to that of conventional coagulants and mucus from other organisms. The efficacy of A.a mucus to capture polystyrene and acrylic NPs (∼100 nm) from spiked wastewater treatment plant (WWTP) effluent was evaluated. The mucus effect on capture kinetics and destabilization of NPs of different polymer compositions, sizes and concentrations was quantified by means of fluorescent NPs, dynamic light scattering and zeta potential measurements and visualized by scanning electron microscopy. A dosing of A.a. mucus equivalent to protein concentrations of ∼2-4 mg L-1 led to a rapid change in zeta potential from a baseline of -30 mV to values close to 0 mV, indicating a marked change from a stable to a non-stable dispersion leading to a rapid (<10 min) and significant removal of NPs (60 %-90 %) from a stable suspension. The A.a. mucus outperformed all other mucus types (0-37 %) and coagulants (0 %-32 % for ferric chloride; 23-40 % for poly aluminum chlorohydrate), highlighting the potential for jellyfish mucus to be used as bio-flocculant. The results indicate a mucus-particle interaction consisting of adsorption-bridging and "mesh" filtration. Further insight is provided by carbohydrate composition and protein disruption analysis. Total protein disruption resulted in a complete loss of the A.a. mucus capacity to capture NPs, while the breaking of disulfide bonds and protein unfolding resulted in improved capture capacity. The study demonstrates that natural jellyfish mucin can capture and remove NPs in water and wastewater treatment systems more efficiently than conventional coagulants, highlighting the potential for development of a new type of bio-flocculant.

Microplastic distributions in a domestic wastewater treatment plant: Removal efficiency, seasonal variation and influence of sampling technique.

Wastewater treatment plants (WWTPs) serve as an important route of microplastics (MPs) to the environment. Therefore, more effective MPs sampling and detection methodologies, as well as a better understanding of their influence on MPs occurrence and distributions in WWTP effluents, are needed for better removal and control. In this work, the efficiency of a municipal WWTP to remove MPs was assessed by collecting samples from raw to tertiary effluent during a 12-month sampling campaign (season-based) using different sampling methods (containers, 24-h composite and large grab samples). MPs retrieved from different treatment units within the WWTP were identified and quantified using plastic/non-plastic staining followed by optical microscopy, SEM and µ-Raman microscopy. Overall, the mean removal efficiency of MPs in the WWTP was 97%, with most MPs removed by the secondary stage and a mean effluent concentration of 1.97 MPs L-1 after sand filtration. The relative abundance of particles was lower than fibers in treated effluent compared with the raw wastewater, with MP fibers constituting 74% of the total MPs in raw wastewater and 91% in treated effluent. Taking seasonal variations into account is important as total MPs concentration in the effluent was notably higher in winter compared with the other seasons. Increasing the sampled volume using large samples or 24-h composite samples significantly reduced the variability between replicates. However, MPs concentration post the tertiary stage was significantly lower using morning sampling (9 am) by large grab sampling method (1.2 MPs L-1) compared to 24-h composite sampling (3.2 MPs L-1) possibly due to intra-daily changes. Using a finer mesh size (0.45 µm) to capture MPs beyond the size range typically studied (≥20 µm) effectively doubled the number of MPs detected in the tertiary effluent and highlights the importance of standardizing sampling procedures.

Assessment of the spatial distribution of soil microbial communities in patchy arid and semi-arid landscapes of the Negev Desert using combined PLFA and DGGE analyses.

Arid and semi-arid ecosystems are often characterized by vegetation patchiness and variable availability of resources. Phospholipid fatty acid (PLFA) and 16S rRNA gene fragment analyses were used to compare the bulk soil microbial community structure at patchy arid and semi-arid landscapes. Multivariate analyses of the PLFA data and the 16S rRNA gene fragments were in agreement with each other, suggesting that the differences between bulk soil microbial communities were primarily related to shrub vs intershrub patches, irrespective of climatic or site differences. This suggests that the mere presence of a living shrub is the dominant driving factor for the differential adaptation of the microbial communities. Lipid markers suggested as indicators of Gram-positive bacteria were higher in soils under the shrub canopies, while markers suggested as indicators of cyanobacteria and anaerobic bacteria were elevated in the intershrub soils. Secondary differences between soil microbial communities were associated with intershrub characteristics and to a lesser extent with the shrub species. This study provides an insight into the multifaceted nature of the factors that shape the microbial community structure in patchy desert landscapes. It further suggests that these drivers not only act in concert but also in a way that is dependent on the aridity level.