RESUMO
A laser-induced repetitively operated fast neutron source was developed for applications in laser-driven nuclear physics research. The developed neutron source, which has a neutron yield of approximately 4 × 10(5) n/pulse and can be operated up to a pulse repetition rate of 10 Hz, was applied for a gold activation analysis. Relatively strong delayed gamma spectra of the activated gold were measured at 333 keV and 355 keV, and proved the possibility of the neutron source for activation analyses. In addition, the nuclear reactions responsible for the measured gamma spectra of gold were elucidated by the 14 MeV fast neutrons resulting from the D(t,n)He(4) nuclear reaction, for which the required tritium originated from the primary fusion reaction, D(d,p)T(3).
RESUMO
A time-gating scintillation detector, in which a fast high voltage switch is used for gating a channel photomultiplier, was developed for a measurement of laser-induced fast neutrons. The x rays generated from the intense femtosecond laser and the solid target interactions were suppressed selectively and a time-of-flight signal of a laser-generated fast neutron was measured effectively. The detector was used successfully to measure the neutron yield of a femtosecond, deuterated, polystyrene plasma.
RESUMO
A new optical Doppler lidar receiving system which can measure Doppler-shifted incoherent scattering light has been proposed and tested. This system functions in a manner similar to two edge filters and consists of a single etalon, a polarization beam splitter, and mirrors that can guide scattered light into a single etalon with two different angles. These two incident angles are precisely adjusted by the polarization beam splitter and mirrors. Using this optical receiving system we can measure a moving target with a high sensitivity. Theoretical calculations show that this system will have a better optical sensitivity than a single edge system and will allow the use of incoherent Doppler lidar for wind velocity measurements.
RESUMO
Aerosols are important parameters in the meteorological and environmental fields, and remote aerosol identification is extremely desirable. We have proposed and designed a two-wavelength (355 and 532 nm) rotational Raman and elastic lidar that can measure the wavelength dependence of the aerosol backscattering coefficient without any assumptions about the Angström coefficient or the overlapping function from low (100 m) to high (10 km) altitude, depending on the weather conditions. We have measured the differences in the backscattering ratios (BRs) among a cloud, aerosol in the boundary layer, and Asian dust. The ratio of the aerosol backscattering coefficients between two wavelengths is a fingerprint of an aerosol, which is similar to the Angström coefficient. The BR value for a typical aerosol ranged from 0.56 to 0.4 in the boundary layer and from 0.5 to 0.1 for Asian dust. The BR value of water droplet was not unique but was spread over a wide range because of its size distributions.
RESUMO
Two-channel lidar signals that are composed of total rotational scattering and elastic signals provide good information about aerosol scattering coefficients. We can calculate the aerosol backscattering coefficient and extinction coefficient directly, without making any assumption or calibration. Generally, a high-spectral-resolution lidar is used for aerosol monitoring, but we have designed a new low-spectral-resolution lidar system that contains both kinds of scattering information simultaneously, and we have retrieved the aerosol scattering coefficient. The results show that there is no need to assume any relation between aerosol backscattering and extinction or to consider any wavelength calibration to determine the aerosol scattering coefficient.