Design of van der Waals interfaces for broad-spectrum optoelectronics.

Van der Waals (vdW) interfaces based on 2D materials are promising for optoelectronics, as interlayer transitions between different compounds allow tailoring of the spectral response over a broad range. However, issues such as lattice mismatch or a small misalignment of the constituent layers can drastically suppress electron-photon coupling for these interlayer transitions. Here, we engineered type-II interfaces by assembling atomically thin crystals that have the bottom of the conduction band and the top of the valence band at the Γ point, and thus avoid any momentum mismatch. We found that these van der Waals interfaces exhibit radiative optical transitions irrespective of the lattice constant, the rotational and/or translational alignment of the two layers or whether the constituent materials are direct or indirect gap semiconductors. Being robust and of general validity, our results broaden the scope of future optoelectronics device applications based on two-dimensional materials.

In-plane staging in lithium-ion intercalation of bilayer graphene.

The ongoing efforts to optimize rechargeable Li-ion batteries led to the interest in intercalation of nanoscale layered compounds, including bilayer graphene. Its lithium intercalation has been demonstrated recently but the mechanisms underpinning the storage capacity remain poorly understood. Here, using magnetotransport measurements, we report in-operando intercalation dynamics of bilayer graphene. Unexpectedly, we find four distinct intercalation stages that correspond to well-defined Li-ion densities. Transitions between the stages occur rapidly (within 1 sec) over the entire device area. We refer to these stages as 'in-plane', with no in-plane analogues in bulk graphite. The fully intercalated bilayers represent a stoichiometric compound C14LiC14 with a Li density of ∼2.7·1014 cm-2, notably lower than fully intercalated graphite. Combining the experimental findings and DFT calculations, we show that the critical step in bilayer intercalation is a transition from AB to AA stacking which occurs at a density of ∼0.9·1014 cm-2. Our findings reveal the mechanism and limits for electrochemical intercalation of bilayer graphene and suggest possible avenues for increasing the Li storage capacity.

Full Control of Solid-State Electrolytes for Electrostatic Gating.

Ionic gating is a powerful technique to realize field-effect transistors (FETs) enabling experiments not possible otherwise. So far, ionic gating has relied on the use of top electrolyte gates, which pose experimental constraints and make device fabrication complex. Promising results obtained recently in FETs based on solid-state electrolytes remain plagued by spurious phenomena of unknown origin, preventing proper transistor operation, and causing limited control and reproducibility. Here, a class of solid-state electrolytes for gating (Lithium-ion conducting glass-ceramics, LICGCs) is explored, the processes responsible for the spurious phenomena and irreproducible behavior are identified, and properly functioning transistors exhibiting high density ambipolar operation with gate capacitance of ≈ 20   -   50 µ F c m - 2 \[20{\bm{ - }}50\;\mu F c{m^{{\bm{ - }}2}}\] (depending on the polarity of the accumulated charges) are demonstrated. Using 2D semiconducting transition-metal dichalcogenides, the ability to implement ionic-gate spectroscopy to determine the semiconducting bandgap, and to accumulate electron densities above 1014 cm-2 are demostrated, resulting in gate-induced superconductivity in MoS2 multilayers. As LICGCs are implemented in a back-gate configuration, they leave the surface of the material exposed, enabling the use of surface-sensitive techniques (such as scanning tunneling microscopy and photoemission spectroscopy) impossible so far in ionic-gated devices. They also allow double ionic gated devices providing independent control of charge density and electric field.

Quenching the bandgap of two-dimensional semiconductors with a perpendicular electric field.

Perpendicular electric fields can tune the electronic band structure of atomically thin semiconductors. In bilayer graphene, which is an intrinsic zero-gap semiconductor, a perpendicular electric field opens a finite bandgap. So far, however, the same principle could not be applied to control the properties of a broader class of 2D materials because the required electric fields are beyond reach in current devices. To overcome this limitation, we design double ionic gated transistors that enable the application of large electric fields of up to 3 V nm-1. Using such devices, we continuously suppress the bandgap of few-layer semiconducting transition metal dichalcogenides (that is, bilayer to heptalayer WSe2) from 1.6 V to zero. Our results illustrate an excellent level of control of the band structure of 2D semiconductors.

Light sources with bias tunable spectrum based on van der Waals interface transistors.

Light-emitting electronic devices are ubiquitous in key areas of current technology, such as data communications, solid-state lighting, displays, and optical interconnects. Controlling the spectrum of the emitted light electrically, by simply acting on the device bias conditions, is an important goal with potential technological repercussions. However, identifying a material platform enabling broad electrical tuning of the spectrum of electroluminescent devices remains challenging. Here, we propose light-emitting field-effect transistors based on van der Waals interfaces of atomically thin semiconductors as a promising class of devices to achieve this goal. We demonstrate that large spectral changes in room-temperature electroluminescence can be controlled both at the device assembly stage -by suitably selecting the material forming the interfaces- and on-chip, by changing the bias to modify the device operation point. Even though the precise relation between device bias and kinetics of the radiative transitions remains to be understood, our experiments show that the physical mechanism responsible for light emission is robust, making these devices compatible with simple large areas device production methods.