Design, fabrication and characterization of a distributed Bragg reflector for reducing the étendue of a wavelength converting system.

In this work, the design, fabrication and characterization are reported for a distributed Bragg reflector (DBR) filter with a specific wavelength and angular dependency, which aims to improve the light collection from a wavelength-converter-based light source into a smaller angle than the full angle Lambertian emission. The desired design is obtained by optimizing the transmission characteristics of a multi-layer structure. Titania (TiO2) and silica (SiO2) are used as high and low refractive index materials, respectively. The deposition is made by electron beam evaporation without substrate heating, followed by a post-annealing procedure. The optical properties of the evaporated layers are analyzed by ellipsometer and spectrometer measurements. The angular and wavelength dependency of the fabricated DBR is in good agreement with simulations for the designed structure.

Improvement of liquid crystal tunable lenses with weakly conductive layers using multifrequency driving.

A common technique to realize the gradient electric field profile that is required in liquid crystal tunable lenses is the use of a weakly conductive layer. Thanks to this layer, an applied voltage with a certain frequency allows us to obtain a refractive index profile that is required for the lens operation. Due to the limited degrees of freedom, however, it is not possible to avoid aberrations in a weakly conductive layer-based tunable lens for a continuously tunable focal length. In this work, we discuss the use of additional higher frequency components in the voltage signal to reduce the lens aberrations drastically.

Multi-electrode tunable liquid crystal lenses with one lithography step.

Electrically tunable lenses offer the possibility to control the focal distance by applying an electric field. Different liquid crystal tunable lenses have been demonstrated. In order to minimize lens aberrations, multi-electrode designs allow us to fine-tune the applied voltages for every possible focal distance. In this Letter, we provide a novel multi-electrode design in which only one lithography step is necessary, thereby offering a greatly simplified fabrication procedure compared to earlier proposed designs. The key factor is the use of a high-permittivity layer, in combination with floating electrodes.

Ferroelectric thin films with liquid crystal for gradient index applications.

We report on the first ever combination of a thin film of lead zirconate titanate (PZT) with a liquid crystal (LC) layer. Many liquid crystal applications use a transparent conductive oxide to switch the liquid crystal. Our proposed processing does not, instead relying on the extremely high dielectric constant of the ferroelectric layer to extend the electric field from widely spaced electrodes over the liquid crystal. It eliminates almost entirely the fringe field problems that arise in nearly all the liquid crystal devices that use multiple addressing electrodes. We show, both via rigorous simulations as well as experiments, that the addition of a PZT layer over the addressing electrodes leads to a markedly improved LC switching performance at distances of up to 30 µm from the addressing electrodes with the current PZT-layer thickness of 0.84 µm. This improvement in switching is used to tune the focal length of the microlens with electrodes spaced at 30 µm.