Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 12 de 12
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
Microsc Microanal ; 25(4): 866-873, 2019 Aug.
Artigo em Inglês | MEDLINE | ID: mdl-31122303

RESUMO

A technique to characterize the native passivation layer (NPL) on pure lithium metal foils in a scanning electron microscope (SEM) is described in this paper. Lithium is a very reactive metal, and consequently, observing and quantifying its properties in a SEM is often compromised by rapid oxidation. In this work, a pure lithium energy-dispersive x-ray spectrum is obtained for the first time in a high vacuum SEM using a cold stage/cold trap with liquid nitrogen reservoir outside the SEM chamber. A nanomanipulator (OmniProbe 400) inside the microscope combined with x-ray microanalysis and windowless energy dispersive spectrometer is used to fully characterize the NPL of lithium metal and some of its alloys by a mechanical removal procedure. The results show that the native films of pure lithium and its alloys are composed of a thin (25 nm) outer layer that is carbon-rich and an inner layer containing a significant amount of oxygen. Differences in thickness between laminated and extruded samples are observed and vary depending on the alloy composition.

2.
Nano Lett ; 18(12): 7583-7589, 2018 12 12.
Artigo em Inglês | MEDLINE | ID: mdl-30462516

RESUMO

Li metal batteries suffer from dendrite formation which causes short circuit of the battery. Therefore, it is important to understand the chemical composition and growth mechanism of dendrites that limit battery efficiency and cycle life. In this study, in situ scanning electron microscopy was employed to monitor the cycling behavior of all-solid Li metal batteries with LiFePO4 cathodes. Chemical analyses of the dendrites were conducted using a windowless energy dispersive spectroscopy detector, which showed that the dendrites are not metallic lithium as universally recognized. Our results revealed the carbide nature of the dendrites with a hollow morphology and hardness greater than that of pure lithium. These carbide-based dendrites were able to perforate through the polymer, which was confirmed by milling the polymer using focused ion beam. It was also shown that applying pressure on the battery can suppress growth of the dendrites.

3.
Nano Lett ; 17(7): 4489-4496, 2017 07 12.
Artigo em Inglês | MEDLINE | ID: mdl-28627889

RESUMO

One of the main challenges in improving fast charging lithium-ion batteries is the development of suitable active materials for cathodes and anodes. Many materials suffer from unacceptable structural changes under high currents and/or low intrinsic conductivities. Experimental measurements are required to optimize these properties, but few techniques are able to spatially resolve ionic transport properties at small length scales. Here we demonstrate an atomic force microscope (AFM)-based technique to measure local ionic transport on LiFePO4 to correlate with the structural and compositional analysis of the same region. By comparing the measured values with density functional theory (DFT) calculations, we demonstrate that Coulomb interactions between ions give rise to a collective activation energy for ionic transport that is dominated by large phase boundary hopping barriers. We successfully measure both the collective activation energy and the smaller single-ion bulk hopping barrier and obtain excellent agreement with values obtained from our DFT calculations.

4.
Nano Lett ; 16(4): 2692-7, 2016 Apr 13.
Artigo em Inglês | MEDLINE | ID: mdl-26966938

RESUMO

Based on neutron powder diffraction (NPD) and high angle annular dark field scanning transmission electron microscopy (HAADF-STEM), we show that calcium ions help eliminate the Fe-antisite defects by controlling the nucleation and evolution of the LiFePO4 particles during their hydrothermal synthesis. This Ca-regulated formation of LiFePO4 particles has an overwhelming impact on the removal of their iron antisite defects during the subsequent carbon-coating step since (i) almost all the Fe-antisite defects aggregate at the surface of the LiFePO4 crystal when the crystals are small enough and (ii) the concomitant increase of the surface area, which further exposes the Fe-antisite defects. Our results not only justify a low-cost, efficient and reliable hydrothermal synthesis method for LiFePO4 but also provide a promising alternative viewpoint on the mechanism controlling the nanosizing of LiFePO4, which leads to improved electrochemical performances.


Assuntos
Cálcio/química , Ferro/química , Compostos de Lítio/química , Nanopartículas/química , Fosfatos/química , Nanopartículas/ultraestrutura , Propriedades de Superfície
5.
Nat Commun ; 15(1): 3898, 2024 May 09.
Artigo em Inglês | MEDLINE | ID: mdl-38724490

RESUMO

In 2021, Svante, in collaboration with BASF, reported successful scale up of CALF-20 production, a stable MOF with high capacity for post-combustion CO2 capture which exhibits remarkable stability towards water. CALF-20's success story in the MOF commercialisation space provides new thinking about appropriate structural and adsorptive metrics important for CO2 capture. Here, we combine atomistic-level simulations with experiments to study adsorptive properties of CALF-20 and shed light on its flexible crystal structure. We compare measured and predicted CO2 and water adsorption isotherms and explain the role of water-framework interactions and hydrogen bonding networks in CALF-20's hydrophobic behaviour. Furthermore, regular and enhanced sampling molecular dynamics simulations are performed with both density-functional theory (DFT) and machine learning potentials (MLPs) trained to DFT energies and forces. From these simulations, the effects of adsorption-induced flexibility in CALF-20 are uncovered. We envisage this work would encourage development of other MOF materials useful for CO2 capture applications in humid conditions.

6.
Microsc Microanal ; 17(3): 374-85, 2011 Jun.
Artigo em Inglês | MEDLINE | ID: mdl-21554830

RESUMO

An open source software package dedicated to processing stored electron backscatter patterns is presented. The package gives users full control over the type and order of operations that are performed on electron backscatter diffraction (EBSD) patterns as well as the results obtained. The current version of EBSD-Image (www.ebsd-image.org) offers a flexible and structured interface to calculate various quality metrics over large datasets. It includes unique features such as practical file formats for storing diffraction patterns and analysis results, stitching of mappings with automatic reorganization of their diffraction patterns, and routines for processing data on a distributed computer grid. Implementations of the algorithms used in the software are described and benchmarked using simulated diffraction patterns. Using those simulated EBSD patterns, the detection of Kikuchi bands in EBSD-Image was found to be comparable to commercially available EBSD systems. In addition, 24 quality metrics were evaluated based on the ability to assess the level of deformation in two samples (copper and iron) deformed using 220 grit SiC grinding paper. Fourteen metrics were able to properly measure the deformation gradient of the samples.

7.
Science ; 374(6574): 1464-1469, 2021 Dec 17.
Artigo em Inglês | MEDLINE | ID: mdl-34914501

RESUMO

Metal-organic frameworks (MOFs) as solid sorbents for carbon dioxide (CO2) capture face the challenge of merging efficient capture with economical regeneration in a durable, scalable material. Zinc-based Calgary Framework 20 (CALF-20) physisorbs CO2 with high capacity but is also selective over water. Competitive separations on structured CALF-20 show not just preferential CO2 physisorption below 40% relative humidity but also suppression of water sorption by CO2, which was corroborated by computational modeling. CALF-20 has a low enthalpic regeneration penalty and shows durability to steam (>450,000 cycles) and wet acid gases. It can be prepared in one step, formed as composite materials, and its synthesis can be scaled to multikilogram batches.

8.
Sci Rep ; 8(1): 17575, 2018 Dec 04.
Artigo em Inglês | MEDLINE | ID: mdl-30514866

RESUMO

Time-of-flight secondary ion mass spectrometry (TOF-SIMS) using a focused ion-beam scanning electron microscope (FIB-SEM) is a promising and economical technique for lithium detection and quantification in battery materials because it overcomes the limitations with detecting low Li content by energy dispersive spectroscopy (EDS). In this work, an experimental calibration curve was produced, which to our best knowledge allowed for the first time, the quantification of lithium in standard nickel manganese cobalt oxide (NMC-532) cathodes using 20 nm resolution. The technique overcomes matrix effects and edges effects that makes quantification complex. This work shows the high potential of TOF-SIMS tool for analytical characterization of battery materials, and demonstrates its tremendous capabilities towards identification of various chemical or electrochemical phenomena in the cathodes via high-resolution ion distributions. Various phenomena in the ion distributions are also assessed, such as edge effects or measurement artifacts from real signal variations.

9.
ACS Appl Mater Interfaces ; 9(47): 41371-41377, 2017 Nov 29.
Artigo em Inglês | MEDLINE | ID: mdl-29110452

RESUMO

Lithium titanium oxide (Li4Ti5O12)-based electrodes are very promising for long-life cycle batteries. However, the surface reactivity of Li4Ti5O12 in organic electrolytes leading to gas evolution is still a problem that may cause expansion of pouch cells. In this study, we report the use of Schiff base (1,8-diazabicyclo[5.4.0]undec-7-ene) as an additive that prevents gas evolution during cell aging by a new mechanism involving the solid electrolyte interface on the anode surface. The in situ ring opening polymerization of cyclic carbonates occurs during the first cycles to decrease gas evolution by 9.7 vol % without increasing the internal resistance of the battery.

10.
Nat Commun ; 8: 14643, 2017 04 10.
Artigo em Inglês | MEDLINE | ID: mdl-28393912

RESUMO

Recently, intensive efforts are dedicated to convert and store the solar energy in a single device. Herein, dye-synthesized solar cell technology is combined with lithium-ion materials to investigate light-assisted battery charging. In particular we report the direct photo-oxidation of lithium iron phosphate nanocrystals in the presence of a dye as a hybrid photo-cathode in a two-electrode system, with lithium metal as anode and lithium hexafluorophosphate in carbonate-based electrolyte; a configuration corresponding to lithium ion battery charging. Dye-sensitization generates electron-hole pairs with the holes aiding the delithiation of lithium iron phosphate at the cathode and electrons utilized in the formation of a solid electrolyte interface at the anode via oxygen reduction. Lithium iron phosphate acts effectively as a reversible redox agent for the regeneration of the dye. Our findings provide possibilities in advancing the design principles for photo-rechargeable lithium ion batteries.

11.
Scanning ; 38(6): 571-578, 2016 Nov.
Artigo em Inglês | MEDLINE | ID: mdl-26840888

RESUMO

Lithium is the key element for the development of battery and new technology and the development of an analytical technique to spatially and quantitatively resolve this element is of key importance. Detection of Li K in pure metallic lithium is now possible in the Scanning Electron Microscope (SEM) with newly designed Energy Dispersive Spectroscopy (EDS). However, this work is clearly showing, for the first time using EDS, the detection of Li K in several binary lithium compounds (LiH, Li3 N, Li2 S, LiF and LiCl). Experimental Li K X-rays intensity is compared with a specially modified Monte Carlo simulation program showing discrepancies between theoretical and experimental Li K measurements. The effect of chemical bounding on the X-rays emission using density functional theory with the all-electron linearized augmented plane wave is showing that the emission of Li K from the binary compounds studied should be, at least, 12 times lower than in metallic Li. SCANNING 38:571-578, 2016. © 2016 Wiley Periodicals, Inc.

12.
Sci Rep ; 5: 8599, 2015 Feb 26.
Artigo em Inglês | MEDLINE | ID: mdl-25715655

RESUMO

Nanostructured lithium metal orthosilicate materials hold a lot of promise as next generation cathodes but their full potential realization is hampered by complex crystal and electrochemical behavior. In this work Li2FeSiO4 crystals are synthesized using organic-assisted precipitation method. By varying the annealing temperature different structures are obtained, namely the monoclinic phase at 400°C, the orthorhombic phase at 900°C, and a mixed phase at 700°C. The three Li2FeSiO4 crystal phases exhibit totally different charge/discharge profiles upon delithiation/lithiation. Thus the 400°C monoclinic nanocrystals exhibit initially one Li extraction via typical solid solution reaction, while the 900°C orthorhombic crystals are characterized by unacceptably high cell polarization. In the meantime the mixed phase Li2FeSiO4 crystals reveal a mixed cycling profile. We have found that the monoclinic nanocrystals undergo phase transition to orthorhombic structure resulting in significant progressive deterioration of the material's Li storage capability. By contrast, we discovered when the monoclinic nanocrystals are cycled initially at higher rate (C/20) and subsequently subjected to low rate (C/50) cycling the material's intercalation performance is stabilized. The discovered rate-dependent electrochemically-induced phase transition and stabilization of lithium metal silicate structure provides a novel and potentially rewarding avenue towards the development of high capacity Li-ion cathodes.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA