Highly Efficient Solar Water Splitting from Transferred TiO2 Nanotube Arrays.

We report a synergistic effect of flame and chemical reduction methods to maximize the efficiency of solar water splitting in transferred TiO2 nanotube (TNT) arrays on a transparent conducting oxide (TCO) substrate. The flame reduction method (>1000 °C) leads to few oxygen vacancies in the anatase TNT arrays, but it exhibits unique advantages for excellent interfacial characteristics between transferred TNT arrays and TCO substrates, which subsequently induce a cathodic on-set potential shift and sharp photocurrent evolution. By contrast, the employed chemical reduction method for TNT arrays/TCO gives rise to an abrupt increase in photocurrent density, which results from the efficient formation of oxygen vacancies in the anatase TiO2 phase, but a decrease in charge transport efficiency with increasing chemical reduction time. We show that flame reduction followed by chemical reduction could significantly improve the saturation photocurrent density and interfacial property of TNT arrays/TCO photoanodes simultaneously without mechanical fracture via the synergistic effects of coreducing methods.

Dual Oxygen and Tungsten Vacancies on a WO3 Photoanode for Enhanced Water Oxidation.

Alleviating charge recombination at the electrode/electrolyte interface by introducing an overlayer is considered an efficient approach to improve photoelectrochemical (PEC) water oxidation. A WO3 overlayer with dual oxygen and tungsten vacancies was prepared by using a solution-based reducing agent, LEDA (lithium dissolved in ethylenediamine), which improved the PEC performance of the mesoporous WO3 photoanode dramatically. In comparison to the pristine samples, the interconnected WO3 nanoparticles surrounded by a 2-2.5 nm thick overlayer exhibited a photocurrent density approximately 2.4 times higher and a marked cathodic shift of the onset potential, which is mainly attributed to the facilitative effect on interface charge transfer and the improved conductivity by enhanced charge carrier density. This simple and effective strategy may provide a new path to improve the PEC performance of other photoanodes.

Enhanced learning and memory in mice lacking Na+/Ca2+ exchanger 2.

The plasma membrane Na(+)/Ca(2+) exchanger (NCX) plays a role in regulation of intracellular Ca(2+) concentration via the forward mode (Ca(2+) efflux) or the reverse mode (Ca(2+) influx). To define the physiological function of the exchanger in vivo, we generated mice deficient for NCX2, the major isoform in the brain. Mutant hippocampal neurons exhibited a significantly delayed clearance of elevated Ca(2+) following depolarization. The frequency threshold for LTP and LTD in the hippocampal CA1 region was shifted to a lowered frequency in the mutant mice, thereby favoring LTP. Behaviorally, the mutant mice exhibited enhanced performance in several hippocampus-dependent learning and memory tasks. These results demonstrate that NCX2 can be a temporal regulator of Ca(2+) homeostasis and as such is essential for the control of synaptic plasticity and cognition.

Rapid Formation of a Disordered Layer on Monoclinic BiVO4 : Co-Catalyst-Free Photoelectrochemical Solar Water Splitting.

A surface disordered layer is a plausible approach to improve the photoelectrochemical performance of TiO2 . However, the formation of a crystalline disordered layer in BiVO4 and its effectiveness towards photoelectrochemical water splitting has remained a big challenge. Here, we report a rapid solution process (within 5 s) that is able to form a disordered layer of a few nanometers thick on the surface of BiVO4 nanoparticles using a specific solution with a controllable reducing power. The disordered layer on BiVO4 alleviates charge recombination at the electrode-electrolyte interface and reduces the onset potential greatly, which in turn results in a photocurrent density of approximately 2.3 mA cm-2 at 1.23 V versus the reversible hydrogen electrode (RHE). This value is 2.1 times higher than that of bare BiVO4 . The enhanced photoactivity is attributed to the increased charge separation and transfer efficiencies, which resolve the intrinsic drawbacks of bare BiVO4 such as the short hole diffusion length of around 100 nm and poor surface oxygen evolution reactivity.

Plasmon-Sensitized Graphene/TiO2 Inverse Opal Nanostructures with Enhanced Charge Collection Efficiency for Water Splitting.

In this contribution we have developed TiO2 inverse opal based photoelectrodes for photoelectrochemical (PEC) water splitting devices, in which Au nanoparticles (NPs) and reduced graphene oxide (rGO) have been strategically incorporated (TiO2@rGO@Au). The periodic hybrid nanostructure showed a photocurrent density of 1.29 mA cm-2 at 1.23 V vs RHE, uncovering a 2-fold enhancement compared to a pristine TiO2 reference. The Au NPs were confirmed to extensively broaden the absorption spectrum of TiO2 into the visible range and to reduce the onset potential of these photoelectrodes. Most importantly, TiO2@rGO@Au hybrid exhibited a 14-fold enhanced PEC efficiency under visible light and a 2.5-fold enrichment in the applied bias photon-to-current efficiency at much lower bias potential compared with pristine TiO2. Incident photon-to-electron conversion efficiency measurements highlighted a synergetic effect between Au plasmon sensitization and rGO-mediated facile charge separation/transportation, which is believed to significantly enhance the PEC activity of these nanostructures under simulated and visible light irradiation. Under the selected operating conditions the incorporation of Au NPs and rGO into TiO2 resulted in a remarkable boost in the H2 evolution rate (17.8 µmol/cm2) compared to a pristine TiO2 photoelectrode reference (7.6 µmol/cm2). In line with these results and by showing excellent stability as a photoelectrode, these materials are herin underlined to be of promising interest in the PEC water splitting reaction.

Solution processable formation of a few nanometer thick-disordered overlayer on the surface of open-ended TiO2 nanotubes.

Herein, we designed vertically aligned TiO2 nanotube arrays, in which a very thin disordered overlayer approximately a few nm thick was formed via a room-temperature solution process. At the optimal overlayer thickness, the TiO2 nanotube arrays yielded a photocurrent density of up to ∼1.75 mA cm-2 at 1.23 V vs. RHE, approximately twice that of the pristine one.