Effect of electrolyte bleaching on the stability and performance of dye solar cells.

Degradation of dye solar cells (DSCs) under severe ageing conditions may lead to loss of the tri-iodide in the electrolyte - a phenomenon known as electrolyte bleaching. Monitoring changes in the tri-iodide concentration as a result of degradation mechanisms and understanding their causes and effects are fundamental for improving the long-term stability of DSCs. In this contribution a strongly accelerated ageing test (1 Sun visible light, 1.5 Suns UV light, T = 110 °C for 12 h) was performed on DSCs in a double-sealed masterplate configuration to purposely induce severe electrolyte bleaching, and its effects on the performance and stability of DSCs with different initial tri-iodide concentrations [I3(-)]0 were investigated. The cells with low [I3(-)]0 suffered a severe loss in short circuit current density JSC (up to 85%). Also a significant loss of open circuit voltage VOC was observed and this loss was proportional to [I3(-)]0 with the highest VOC drop observed with the highest [I3(-)]0. Non-destructive analysis techniques based on the limited current density, JSCvs. light intensity, and photographic image analysis, were used to quantify the [I3(-)] loss, which was found to be ca. 50 mM and independent of [I3(-)]0. Quantitative model based VOC analysis in terms of changing [I3(-)] revealed that the degradation responsible for the VOC drop was dominated by an unknown mechanism that is unrelated to [I3(-)]0. The methods and results reported here help separating and identifying different degradation mechanisms related to electrolyte bleaching in DSCs.

Physical and electrochemical analysis of an indoor-outdoor ageing test of large-area dye solar cell devices.

A long-term life test (3200 h) on large-area dye-sensitized cells is performed both under outdoor conditions, in the sunny Mediterranean climate in Rome (Italy), and under continuous light soaking (1 Sun, 85 °C). Different degradation rates are investigated for the outdoor samples with horizontally and vertically oriented cells (azimuth South, tilt angle 25°). Thirty identical photocells (active area=3.6 cm(2), conversion efficiencies=(4.8±0.2)%) are aged using a robust master-plate configuration. After the first 1000 h of testing in open-circuit conditions, some of the test samples are set near the maximum power point (MPP) and the life test continued further until 3200 h. A detailed analysis of the physical parameters obtained by electrochemical impedance is given together with electrolyte transmittance variation with time as a function of the ageing conditions. Faster degradation in devices working at the MPP is observed, due mainly to a progressive decrease of the triiodide concentration in the electrolyte and a likely alteration at the titania/electrolyte interface. Outdoor devices working with vertically oriented cells show clearly that the orientation of long-striped cells can affect the lifetime. The aged cells suffer an increase of recombination rate, change in the chemical capacitance, and positive shift of the titania conduction band level. A strong correlation between the increase of the electrolyte diffusion resistance and degradation phenomena is found.