A graphene-oxide-based aptasensor for fluorometric determination of chloramphenicol in milk and honey samples utilizing exonuclease III-assisted target recycling and Nb.BbvCI-powered DNA walker cascade amplification.

Herein, a graphene oxide (GO)-based fluorescence aptasensor was developed for the sensitive and selective detection of chloramphenicol (CAP), based on exonuclease III (Exo III)-assisted target recycling and Nb.BbvCI-driven DNA walker cascade amplification. Interactions between CAP, hairpin1(HP1), hairpin2 (HP2), and 3'-amino modified hairpin3 (HP3) labeled with carboxyfluorescein (FAM) and covalently coupled to GO enabled efficient CAP detection. CAP was quantitatively assayed by measuring fluorescence at excitation/emission wavelengths of 480/514 nm, resulting from the accumulation of released FAM. A good linear range of 1 fM to 1 nM and a limit of detection (LOD) of 0.875 fM (signal-to-noise (S/N)= 3) were achieved. This aptasensor can distinguish the CAP from interference antibiotics with good specificity and selectivity, even if the concentration of the interfering substance is ten-fold higher than the target concentration. Moreover, the developed fluorescence aptasensor was successfully applied for the detection of CAP in spiked milk and honey samples. Thus, this method is potentially applicable for assaying CAP in foods and provides a promising strategy for the development of fluorescence aptasensors for environmental sample analysis.

New insight into the role of lipid metabolism-related proteins in rheumatic heart valve disease.

PURPOSE: The aim of this study was to determine the expression of lipid metabolism-related proteins in rheumatic heart valve disease (RHVD). METHODS: This retrospective study involved a total of 20 cases of moderate or severe rheumatic mitral valve stenosis and 4 cases of mitral regurgitation due to secondary causes from September 2018 to September 2021. The patients enrolled included 12 males and 12 females who underwent surgical excision of the mitral valve at the cardiac surgery department of Hainan General Hospital. The samples of mitral valve were collected during surgery treatment as the study group, and mitral valves collected from patients with ischemic heart disease were allocated into the control group. Hematoxylin-eosin (HE), oil red staining and immunohistochemical (IHC) staining were conducted to compare the expression of lipid metabolism-related proteins (ATP-binding cassette transporter A1 and acyl-coenzyme A: cholesterol acyltransferase-1), and real-time polymerase chain reaction (RT-PCR) was applied to compare the mRNA levels of ABCA1, ACAT1, and the inflammatory cytokines TNF-α, IL-10, and MCP-1. RESULTS: In general, the rheumatic mitral valve showed leaflet thickening along with border adhesions and visible yellow fats. Oil red O staining also revealed the abovementioned results as well as fat cells. Both ABCA1 and ACAT1 were expressed in the rheumatic mitral valve via IHC, whereas only ACAT1 showed a faint level of expression in the ischemic mitral valve with no expression of ABCA1. In addition, compared with the ischemic mitral valve, RT-PCT showed increased mRNA expression levels of ABCA1, ACAT1, and the inflammatory cytokines TNF-α, IL-10, and MCP-1 (P < 0.05). After dividing the RMs into two groups for RT-PCR, we found that the higher the expression of ABCA1 and ACAT1 was, the lower the relative expression of inflammatory factors. CONCLUSION: This study showed that adipose tissue, adipose cells, and lipid transport-related proteins were expressed strongly in the rheumatic mitral valve, suggesting that adipose tissue formation might be one of the important pathways in the pathology of rheumatic heart disease. In addition, adipose tissue and adipocytes were also involved in the inflammatory process. These data provide new insight into pathological mechanisms in rheumatic heart disease.

A graphene-oxide-based fluorometric assay for norA gene transcription in MRSA using Nb.BbvCI-assisted target recycling and T7 exonuclease-triggered cascade dual recycling signal amplification.

We describe a graphene oxide (GO)-based bioassay for the fluorometric determination of norA gene transcription (mRNA) in methicillin-resistant Staphylococcus aureus (MRSA). This approach is based on Nb.BbvCI-assisted target recycling (NATR) and T7 exonuclease (T7 Exo)-triggered cascade dual-recycling signal amplification (TTCDRSA). The system included GO, a capture probe (CP), an assistant probe (AP), two carboxyfluorescein (FAM)-labeled hairpins (HP1 and HP2), endonuclease Nb.BbvcI, and exonuclease T7. In the presence of a target, AP, together with the target RNA, can hybridise with CP via partial complementarity to one another and open its hairpin structure to form a triple complex that is recognised by Nb.BbvCI. Once the CP is cleaved, the released AP and target RNA can walk on the carboxylated graphene oxide (CGO) surface to bind with another CP which induces the next round of cleavage, accumulating many trigger probes (TPs). The TPs then activate TTCDRSA with the assistance of T7 Exo, HP1, and HP2 to produce large amounts of free FAMs. These free FAMs are repelled by GO and exhibit enhanced fluorescence signals at excitation/emission wavelengths of 480/514 nm. The limit of detection (LOD) of the bioassay was calculated to be 0.37 fM, and the linear range of the method ranged from 1 fM to 1 nM. More importantly, the bioassay also exhibited high sensitivity and selectivity for target RNA detection in real samples, which may open a new promising avenue for monitoring drug efflux and studying the mechanisms of drug actions.

Targeted inhibition of methicillin-resistant Staphylococcus aureus biofilm formation by a graphene oxide-loaded aptamer/berberine bifunctional complex.

Biofilm formation is known to promote drug resistance in methicillin-resistant Staphylococcus aureus (MRSA), which is closely related to persistent infections in hospital settings. In this study, a DNA aptamer specific to penicillin-binding protein 2a (PBP2a) with a dissociation constant (Kd) of 82.97 ± 8.86 nM was obtained after 14 cycles of systematic evolution of ligands by exponential enrichment (SELEX). Next, a bifunctional complex containing the aptamer intercalated by berberine into the double-strand region was prepared and adsorbed onto the surface of graphene oxide (GO) by π-stacking interactions. The GO-loaded aptamer/berberine bifunctional complex showed significantly higher inhibition of MRSA biofilm formation than the control. Furthermore, this study shows that the complex possesses anti-biofilm activity, which can be attributed to the ability of the aptamer to reduce cell-surface attachment by blocking the function of PBP2a and berberine to attenuate the level of the accessory gene regulator (agr) system, which plays an important role in mediating MRSA biofilm formation. Therefore, the simultaneous delivery of berberine and PBP2a-targted aptamer using GO may have potential for the treatment of chronic infections caused by MRSA biofilms. It also provides a new avenue for multitarget treatment of bacterial biofilms.

Graphene-oxide-based bioassay for the fluorometric determination of agrC gene transcription in methicillin-resistant Staphylococcus aureus that uses nicking-enzyme-assisted target recycling and a hybridization chain reaction.

Herein, we report the development of a graphene-oxide-based (GO-based) fluorescent bioassay for determining agrC gene transcription (mRNA) in methicillin-resistant Staphylococcus aureus (MRSA). The design is based on nicking-enzyme-assisted (Nb.BbvcI-assisted) target recycling amplification (NATR) and a hybridization chain reaction (HCR). The system consists of a helper probe (HP), a molecular beacon (MB) probe, four hairpins, and endonuclease Nb.BbvcI, which plays a role in target recycling and signal amplification. In the absence of the target, all of the carboxyfluorescein-labeled (FAM-labeled) hairpins are adsorbed through π-stacking interactions onto the surface of GO, resulting in FAM signal quenching. When the target is added, three nucleic acid chains hybridize together to form a triple complex that is recognized by Nb.BbvCI. The MB probe is then cleaved by Nb.BbvCI to generate an HP/target complex and two new DNA fragments; the former is hybridized to another MB probe and enters the next round of reaction. The two newly reproduced DNA fragments induce a HCR with the assistance of hairpins 1-4 to create double-stranded DNA (dsDNA) products. These dsDNA products are repelled by GO and generate strong fluorescence at excitation/emission wavelengths of 480/514 nm. Importantly, synergy between FAM and the dsDNA-SYBR Green I duplex structure led to significantly amplified fluorescence and enhanced sensitivity. The bioassay showed a detection limit of 7.5 fM toward the target and a good linearity in the 10 fM to 100 pM range. The developed method was applied to monitor biofilm formation and study the mechanism of drug action, with satisfactory results obtained.