How to oxidize atmospheric CH(4)?--A challenge for the future.

Methane is an active Greenhouse effect gas whose concentration will likely increase in the future. The possible destabilisation of CH4 clathrates (hydrates) due to anthropogenic climate warming, and the resulting outgasing of methane, could lead to a major increase of the global Greenhouse effect, with dramatic consequences for Humanity. For these reasons, the study of possible countermeasures should be actively considered. Here, we suggest taking advantage of the thermodynamic instability of CH4 in air, and search for ways to oxidize it.

Instrumental stability requirements for exoplanet detection with a nulling interferometer: variability noise as a central issue.

We revisit the nulling interferometer performances that are needed for direct detection and the spectroscopic analysis of exoplanets, e.g., with the DARWIN [European Space Agency-SCI 12 (2000)] or TPF-I [JPL Publ. 05-5, (2005)] missions. Two types of requirement are found, one concerning the mean value of the instrumental nulling function (nl(lambda)) and another regarding its stability. The stress is usually put on the former. It is stringent at short wavelengths but somewhat relaxed at longer wavelengths. The latter, which we call the variability noise condition, does not usually receive enough attention. It is required regardless of telescope size and stellar distance. The results from three nulling experiments performed in laboratories around the world are reported and compared with the requirements. All three exhibit 1/f noise that is incompatible with the performances required by the mission. As pointed out by Lay [Appl. Opt. 43, 6100-6123 (2004)], this stability problem is not fully solved by modulation techniques. Adequate solutions must be found that are likely to include servo systems using the stellar signal itself as a reference and internal metrology with high stability.

Use of single-mode waveguides to correct the optical defects of a nulling interferometer.

In the area of long-baseline nulling interferometry, high rejection ratios are needed to cancel out the light of a bright central source and look for nearby faint structures or companions. These rejection requirements directly translate into drastic optical constraints. We discuss the possibility of using single-mode waveguides for such applications. Conversely to simple pinholes, single-mode waveguides efficiently correct wave-front defects of both high- and low-order spatial frequencies, ensure a perfect matching of the amplitude profiles coming from the various beams, and can be used with almost optimum coupling efficiency over a broad optical bandpass (typically an octave). They then appear to greatly enhance the feasibility of high-dynamic interferometric coronagraphs.