RESUMO
The combined pollution of heavy metals and organic compounds usually occurs simultaneously and induces high toxicity. The technology of simultaneous removal of combined pollution is lacking and the removal mechanism is not clear. Sulfadiazine (SD), a widely used antibiotic, was used as a model contaminant. Urea modified sludge-based biochar (USBC) was prepared and used to catalyze H2O2 to remove the combined pollution of Cu2+ and sulfadiazine (SD) without causing secondary pollution. After 2 h, the removal rates of SD and Cu2+ were 100 and 64.8%, respectively. Cu2+ adsorbed on the surface of USBC accelerated the activation of H2O2 by the USBC catalyzed by CO bond to produce hydroxyl radical (â¢OH) and single oxygen (1O2) to degrade SD. Twenty-three intermediate products were detected, most of which were completely decomposed into CO2 and H2O. The toxicity was significantly reduced in the combined polluted system. This study highlights the potential of the low-cost technology based on sludge reuse and its inherent significance in reducing the toxic risk of combined pollution in the environment.
Assuntos
Cobre , Peróxido de Hidrogênio , Cobre/química , Peróxido de Hidrogênio/química , Sulfadiazina , Esgotos , Ureia , Carvão Vegetal/química , Oxigênio , Catálise , Estresse OxidativoRESUMO
The propagation pattern of pressure drawdown effectively reflects the recoverable reserves range around the gas well and serves as a crucial basis for development strategies. However, it is not easy to detect the pressure propagation boundary near the producing well, especially in low-permeability reservoirs where the drainage radius is small. Physical simulation experiments can serve as a crucial method as the whole pressure profile and gas rate can be obtained in real time. Using long core plugs with permeabilities of 2.300 mD, 0.486 mD, and 0.046 mD, physical simulation experiments were carried out under varying initial water saturation (Swi) conditions of 0%, 20%, 40%, and 55% to observe the dynamic variations in pressure profiles of the core plugs during pressure depletion. Based on the material balance equation and pressure profile characteristics of the core plugs, a method for evaluating recoverable reserves within a well-spacing radius through laboratory experiments was proposed and performed. Mechanism analysis was conducted based on mercury injection tests, and suggestions for enhancing gas recovery were presented. Research findings indicate that lower permeability, higher initial water saturation, and higher abandonment gas rates result in reduced reserve utilization range and degree. Under abandoned gas rate conditions, for type I and II rocks, the pore radius is primarily distributed between 0.1 and 1 µm, the pressure drawdown can reach the well-spacing radius of 600 m, and the ultimate recovery efficiencies are more than 70.6%. For type III rocks, the pore radius mainly falls below 0.1 µm, the drainage radius is smaller than 10 m with Swi greater than 40%, and the ultimate recovery is below 10%. This paper provides an experimental method for recoverable reserves evaluation while formulating gas reservoir development strategies before well testing.
RESUMO
Sewage sludge-derived biochar (SBC) could remove organic contaminants in environment and reuse the sludge effectively. In this study, urea-doped SBC (NSBC) was prepared, characterized, and applied as heterogeneous catalytics to peroxydisulfate (PDS) activation. Sulfadiazine (SD), a widely used antibiotic, was used as a model pollutant to evaluate the efficiency and mechanism of this system. The degradation rate of SD increased to 100% after 4 h when 1 g/L of NSBC was added to the system with a SD concentration of 20 mg/L. In this study, it was confirmed that there were two important pathways in the degradation of SD by NSBC/PDS system: the free radical on the surface of NSBC and the nonradical (1O2) in the solution. The doping of N atoms makes neighboring C atoms positively charged, thereby making the direct transfer of electrons with S2O82- and the generation of 1O2 via nonradical pathway easy. In addition, the CO functional group formed during the pyrolysis of NSBC can produce 1O2 in a similar way. A total of 22 SD degradation products were identified, and 4 possible pathways were proposed. This study provide supplement for the degradation mechanism of organic compounds by carbon-based materials.