Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros

Base de dados
Ano de publicação
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
J Am Chem Soc ; 146(12): 8280-8297, 2024 Mar 27.
Artigo em Inglês | MEDLINE | ID: mdl-38467029

RESUMO

Single-site copper-based catalysts have shown remarkable activity and selectivity for a variety of reactions. However, deactivation by sintering in high-temperature reducing environments remains a challenge and often limits their use due to irreversible structural changes to the catalyst. Here, we report zeolite-based copper catalysts in which copper oxide agglomerates formed after reaction can be repeatedly redispersed back to single sites using an oxidative treatment in air at 550 °C. Under different environments, single-site copper in Cu-Zn-Y/deAlBeta undergoes dynamic changes in structure and oxidation state that can be tuned to promote the formation of key active sites while minimizing deactivation through Cu sintering. For example, single-site Cu2+ reduces to Cu1+ after catalyst pretreatment (270 °C, 101 kPa H2) and further to Cu0 nanoparticles under reaction conditions (270-350 °C, 7 kPa EtOH, 94 kPa H2) or accelerated aging (400-450 °C, 101 kPa H2). After regeneration at 550 °C in air, agglomerated CuO was dispersed back to single sites in the presence and absence of Zn and Y, which was verified by imaging, in situ spectroscopy, and catalytic rate measurements. Ab initio molecular dynamics simulations show that solvation of CuO monomers by water facilitates their transport through the zeolite pore, and condensation of the CuO monomer with a fully protonated silanol nest entraps copper and reforms the single-site structure. The capability of silanol nests to trap and stabilize copper single sites under oxidizing conditions could extend the use of single-site copper catalysts to a wider variety of reactions and allows for a simple regeneration strategy for copper single-site catalysts.

2.
PLoS One ; 19(4): e0295882, 2024.
Artigo em Inglês | MEDLINE | ID: mdl-38630763

RESUMO

Alpacas (Vicugna pacos) are reported to be the rare mammal in which the penis enters the uterus in mating. To date, however, only circumstantial evidence supports this assertion. Using female alpacas culled for meat, we determined that the alpaca penis penetrates to the very tips of the uterine horns, abrading the tract and breaking fine blood vessels. All female alpacas sacrificed one hour or 24 hours after mating showed conspicuous bleeding in the epithelium of some region of their reproductive tract, including the hymen, cervix and the tips of each uterine horn, but typically not in the vagina. Unmated females showed no evidence of conspicuous bleeding. Histological examination of mated females revealed widespread abrasion of the cervical and endometrial epithelium, injuries absent in unmated females. Within one hour of mating, sperm were already present in the oviduct. The male alpaca's cartilaginous penis tip with a hardened urethral process is likely responsible for the copulatory abrasion. The entire female reproductive tract interacts with the penis, functioning like a vagina. Alpacas are induced ovulators, and wounding may hasten delivery of the seminal ovulation-inducing factor beta-NGF into the female's blood stream. There is no evidence of sexual conflict in copulation in alpaca, and thus wounding may also be one of a variety of mechanisms devised by mammals to induce a beneficial, short-term inflammatory response that stimulates blastocyst implantation, the uterine remodeling associated with placental development, and thus the success of early pregnancy.


Assuntos
Camelídeos Americanos , Copulação , Animais , Feminino , Masculino , Gravidez , Copulação/fisiologia , Sêmen/fisiologia , Placenta , Espermatozoides , Inseminação
3.
J Phys Chem C Nanomater Interfaces ; 127(49): 23956-23965, 2023 Dec 14.
Artigo em Inglês | MEDLINE | ID: mdl-38115817

RESUMO

The tuning of micropore environments in zeolitic imidazolate frameworks (ZIFs) by mixed-linker synthesis has the potential for enabling new molecular separation properties. However, de novo synthesis of mixed-linker (hybrid) ZIFs is often challenging due to the disparate chemical properties of the different linkers. Here, we elucidate the structure and properties of an unconventional ZIF-8-7 hybrid material synthesized via a controlled-acid-gas-assisted degradation and reconstruction (solvent-assisted crystal redemption, SACRed) strategy. Selective insertion of benzimidazole (ZIF-7 linker) into ZIF-8 using SACRed is used as a facile method to generate a ZIF-8-7 hybrid material that is otherwise difficult to synthesize by de novo methods. Detailed crystal structure and textural characterizations clarify the significant differences in the microstructure of the SACRed-derived ZIF-8-7 hybrid material relative to a de novo synthesized hybrid of the same overall linker composition as well as the parent ZIF-8 material. Unary and binary adsorption measurements reveal the tunability of adsorption characteristics as well as the prevalence of nonideal cooperative mixture adsorption effects that lead to large deviations from predictions made with ideal adsorbed solution theory.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA