The effect of flow-responsive pulsation on teat tissue condition and milking performance in Holstein dairy cows.

The objectives of this study were to assess the effect of a reduced liner-open phase applied through flow-responsive pulsation (FRP), as a method to provide supplemental stimulation, on teat tissue conditions and milking characteristics in dairy cows. In 2 switch-back trials, 156 Holstein cows milked 3 times daily were assigned to the FRP or conventional (CON) group in alternating sequences. Trial I lasted for 35 d and was split into 5 alternating 1-week periods of FRP and CON. The duration of Trial II was 84 d, consisting of 4 alternating 3-week periods of FRP and CON. Premilking udder preparation for both groups consisted of predipping, forestripping and wiping the teats. Upon milking unit attachment, the FRP cows were milked at a pulsation rate of 50 cycles/min and a pulsation ratio of 30:70 until the preset milk flow threshold of 0.5 kg/min was reached. When the threshold value of 0.5 kg/min was reached, the pulsation was automatically switched to milking mode, which consisted of a pulsation rate of 60 cycles/min and a pulsation ratio of 70:30. Cows in the CON group were milked by milking mode (pulsation rate, 60 cycles/min; pulsation ratio, 70:30) immediately after attachment of the milking unit. We assessed machine milking-induced short-term changes to the teat tissue by palpation and visual inspection during Trial I, and we assessed teat-end hyperkeratosis in Trial II. Electronic on-farm milk meters were used to assess milking characteristics [milk yield (kg/milking session), milking unit-on time (s), 2-min milk yield (kg), peak milk flow rate (kg/min), and duration of low milk flow rate (s)]. Generalized linear mixed models were used to analyze the effect of treatment on the outcome variables. The odds of machine milking-induced short-term changes to the teat tissue were lower for cows in the FRP group than for those in the CON group [odds ratio (95% confidence interval; 95% CI) = 0.41 (0.31-0.55)]. There were no meaningful differences in the odds of teat-end hyperkeratosis between the FRP and CON groups [odds ratio (95% CI) = 1.05 (0.38-2.89)]. The least squares means (95% CI) of milking characteristics in the FRP and CON groups were 14.3 (13.8-14.7) and 14.3 (13.8-14.7) kg for milk yield, respectively; 272 (264-281) and 270 (262-278) s for milking unit-on time, respectively; and 5.0 (4.8-5.1) and 4.9 (4.7-5.1) kg/min for peak milk flow rate, respectively. The FRP group had lower odds of bimodality than the CON group [odds ratio (95% CI) = 0.67 (0.61-0.74)]. In reference to CON, the odds ratios (95% CI) in FRP were 1.05 (0.76-1.46) for kick-off, and 1.02 (0.85-1.23) for milking unit reattachment. In this study, cows that were milked using FRP had lower odds of postmilking short-term changes to the teat tissue and lower odds of bimodal milk flow. We conclude that FRP may foster adequate teat stimulation in cows before the initiation of milk harvest and has the potential to improve teat tissue conditions.

The association between teat shape and bimodal milk ejection in Holstein dairy cows.

Our objectives were to investigate the association of teat shape with (1) bimodality, (2) incremental milk flow rates (average flow rates during the first 15 s, 15-30 s, 30-60 s, and 60-120 s of milking), and (3) peak milk flow rate in Holstein dairy cows milked 3 times/d. In this prospective cohort study, we analyzed 220,928 milking observations that were collected from 2,520 cows from a single dairy herd over a period of 31 d. Teat shape was visually assessed and classified into 1 of 4 categories as follows: (1) triangular barrel and pointed teat end (TP), (2) square barrel and round teat end (SR), (3) square barrel, round teat end, and flat in the area of the teat orifice (SRF), and (4) square barrel and flat teat end (SF). Individual cow-level milk flow rates were obtained using electronic on-farm milk meters. We considered bimodality to be present if any of the incremental milk flow rates (flow rates during 15-30 s, 30-60 s, or 60-120 s) were lower than any of the previous rates (flow rates during the first 15 s, 15-30 s, or 30-60 s). The frequency distribution of cows with different teat shapes was as follows: TP, 96 (3.8%); SR, 1,751 (69.5%); SRF, 617 (24.5%); and SF, 56 (2.2%). A generalized linear mixed model revealed differences in the odds of bimodality among cows with different teat shapes. Compared with cows in category SR, the odds (95% CI) of bimodality of cows in other categories were as follows: TP, 0.68 (0.48-0.97); SF, 1.96 (1.21-3.19); and SRF, 1.46 (1.23-1.72). General linear mixed models indicated an association between teat shape and all incremental milk flow rates, with higher milk flow rates being present for cows with teat shapes in the SRF and SF categories. The general linear mixed model for the dependent variable peak milk flow rate indicated an association between teat shape and peak milk flow rate. Least squares means and 95% CI were 5.1 (4.9-5.3) kg/min for TP, 5.8 (5.5-6.1) kg/min for SF, 5.6 (5.5-5.7) for SRF, and 5.3 (5.3-5.4) for SR, respectively. We conclude that in this study cohort, bimodality is more likely to occur in cows with flat teat ends compared with those with a round teat ends. We attribute this relationship to the difference in milking speed across cows with different teat shapes. Teat shape may serve as a useful phenotype to identify cows that are more likely to exhibit bimodality. Because our study population was unique, future studies considering different circumstances such as breed, milking system, and milking routine are needed before results can be extrapolated.

The effect of 2 different premilking stimulation regimens, with and without a latency period, on teat tissue condition and milking performance in Holstein dairy cows.

The objectives of this study were to assess the effect of 2 different premilking stimulation regimens, with and without a latency period between tactile stimulation and the attachment of the milking unit, on the teat tissue condition and milking performance of dairy cows. In a randomized controlled crossover study, 145 Holstein cows milked 3 times daily were assigned to treatment (TRT) or control (CON) groups. Premilking udder preparation for the TRT group consisted of the application of a latency period resulting in a preparation lag time of 90 s. The only difference in the premilking udder preparation of the CON group was the absence of latency period; the milking unit was attached immediately after completion of the tactile stimulation. The average duration of total tactile stimulation in TRT and CON group was 8 ± 2 and 9 ± 2 s, respectively. The study lasted for 14 d and was split into 2 periods, each consisting of a 2-d adjustment period followed by 5 d of data collection. We assessed machine milking-induced short-term changes to the teat tissue by palpation and visual inspection postmilking. Electronic on-farm milk meters were used to assess milking characteristics (milk yield [kg/milking session], machine-on time [s], 2-min milk yield [kg], and duration of low milk flow rate [s]). Generalized linear mixed models were used to analyze the effect of treatment on the outcome variables. The odds of machine milking-induced short-term changes to the teat tissue were lower for cows that received a 90-s preparation lag time (TRT cows) compared with cows in the CON group (odds ratio [95% confidence interval; 95% CI] = 0.13 [0.08-0.20]). The least squares means (95% CI) values of cows in the TRT and CON groups were 15.4 (14.9-15.9) and 15.3 (14.8-15.8) kg, respectively, for milk yield, and 246 (239-253) and 253 (247-260) s for machine-on time. The 2-min milk yield was higher for the TRT compared with CON group cows at all the parity levels. The 2-min milk yields of animals in lactation 1, 2, and ≥3 were 5.7, 5.7, and 6.5 kg, respectively, in the TRT group and 4.6, 5.0, and 5.9 kg in the CON group. The TRT cows spent less time in low milk flow rate compared with CON cows at all parity levels. The durations of low milk flow rate of cows in lactation 1, 2, and ≥3 in the TRT group were 19, 17 and 13 s, respectively, and those in the CON group were 31, 22, and 15 s. In this study, cows that received a latency period, and thus were subjected to a 90-s preparation lag time had lower odds of exhibiting short-term changes to the teat tissue after machine milking, shorter machine-on time, higher 2-min milk yields, and lower durations of low milk flow rates. We conclude that consideration of latency period leading to a 90-s preparation lag time in the premilking stimulation regimen facilitated cows' milk-ejection reflex. This latency period can alleviate the adverse effects of vacuum-induced forces on teat tissue during machine milking, improve udder health, and promote animal well-being.