RESUMO
Methane-based nitridation was employed to produce wurtzite zinc-gallium oxynitride (ZnGaNO) photocatalyst particles using Zn/Ga/CO3 layered double hydroxides (LDHs) as precursor. Introduction of methane to nitridation would promote the formation of Zn-O bonding and suppress shallow acceptor complexes such as V(Zn)-Ga(Zn) and Ga-Oi in ZnGaNO particles. On the other hand, high flow rate of methane would induce breaking of Ga-N bonding and enhance surface deposition of metallic Ga atoms. After loading with Rh and RuO2, ZnGaNO particles had free electron density in an order of S50 > S20 > S90 > S0, which correlated well with their photocatalytic performance upon visible-light irradiation. The best performance of the loaded S50 was ascribed to the relatively flat surface band bending of the particle. Methane-based nitridation of Zn/Ga/CO3 LDHs would provide a new route to tune the surface chemistry of ZnGaNO and enhance the photocatalytic performance to its full potential.
RESUMO
Microbial electrolysis cells (MECs) have demonstrated high-rate H2 production while concurrently treating wastewater, but the transition in scale from laboratory research to systems that can be practically applied has encountered challenges. It has been more than a decade since the first pilot-scale MEC was reported, and in recent years, many attempts have been made to overcome the barriers and move the technology to the market. This study provided a detailed analysis of MEC scale-up efforts and summarized the key factors that should be considered to further develop the technology. We compared the major scale-up configurations and systematically evaluated their performance from both technical and economic perspectives. We characterized how system scale-up impacts the key performance metrics such as volumetric current density and H2 production rate, and we proposed methods to evaluate and optimize system design and fabrication. In addition, preliminary techno-economic analysis indicates that MECs can be profitable in many different market scenarios with or without subsidies. We also provide perspectives on future development needed to transition MEC technology to the marketplace.
Assuntos
Fontes de Energia Bioelétrica , Águas Residuárias , Hidrogênio , Eletrólise , TecnologiaRESUMO
Cathode materials are critical for microbial electrolysis cell (MEC) development and its contribution to achieving a circular hydrogen economy. There are numerous reports on the progress in MEC cathode development during the past decade, but a comprehensive review on the quantitative comparisons and critical assessments of these works is lacking. This Review summarizes and analyzes the published literature on MEC cathode and catalyst development in the past decade, providing an overview of new materials examined during this time period and quantitative analyses on system performance and trends in materials development. Collected data indicate that hybrid materials have become the most popular catalyst candidate while nickel materials also attract increasing interest and exploration. However, the dilemma between higher H2 production rate and larger MEC volume remains and still requires more investigation of novel MEC cathode catalysts and configurations to offer a solution.
RESUMO
Biomorphic Mn3O4 nanocrystal/porous carbon microfiber composites were hydrothermally fabricated and subsequently calcined using cotton as a biotemplate. The as-prepared material exhibited a specific capacitance of 140.8 F·g-1 at 0.25 A·g-1 and an excellent cycle stability with a capacitance retention of 90.34% after 5000 cycles at 1 A·g-1. These characteristics were attributed to the introduction of carbon fiber, the high specific surface area, and the optimized microstructure inherited from the biomaterial.
RESUMO
InxGa1-xN nanowires (NWs) have drawn great attentions for their applications in optoelectronic and energy conversion devices. Compared to conventional substrates, metal substrates can offer InxGa1-xN NW devices with better thermal conductivity, electric conductivity, and mechanic flexibility. In this article, InxGa1-xN NWs were successfully grown on the surface of a tantalum (Ta) substrate via vapor-liquid-solid chemical vapor deposition (VLS-CVD), as characterized by X-ray diffraction (XRD), scanning electron microscope (SEM), scanning and transmission electron microscope (STEM), and photoluminescence spectroscopy (PL). It was found that the surface pretreatment of Ta and the composition of metallic catalysts played important roles in the formation of NWs. A dimpled nitrided Ta surface combined with a catalyst of nickle is suitable for VLS-CVD growth of the NWs. The obtained InxGa1-xN NWs grew along the [1100] direction with the presence of basal stacking faults and an enriched indium composition of ~3 at.%. The successful VLS-CVD preparation of InxGa1-xN nanowires on Ta substrates could pave the way for the large-scale manufacture of optoelectronic devices in a more cost-effective way.
RESUMO
This study demonstrates that by incorporating a microbial electrochemical unit into an anaerobic osmotic membrane bioreactor (AnOMBR), the system addressed several challenges faced by traditional anaerobic membrane bioreactors and recovered biogas, nitrogen, and phosphorus while maintaining high effluent quality with low dissolved methane. The microbial recovery cell (MRC)-AnOMBR system showed excellent organic (>93%) and phosphorus removal (>99%) and maintained effluent COD below 20 mg/L. Furthermore, the reactor effectively recovered up to 65% PO43- and 45% NH4+ from the influent, which can be further improved if membranes with higher selectivity are used. Nutrients removal from bulk solution mitigated NH4+ penetration to the draw solution and reduced scaling potential caused by PO43-. The maximum methane yield was 0.19 L CH4/g COD, and low methane (<2.5 mL CH4/L) was detected in the effluent. Further improvement can be made by increasing charge efficiency for better nutrient and energy recovery.
Assuntos
Membranas Artificiais , Purificação da Água , Anaerobiose , Reatores Biológicos , Osmose , Fósforo , Eliminação de Resíduos LíquidosRESUMO
Conventional wastewater purification technologies consume large amounts of energy, while the abundant chemical energy and nutrient resources contained in sewage are wasted in such treatment processes. A microbial nutrient recovery cell (MNRC) has been developed to take advantage of the energy contained in wastewater, in order to simultaneously purify wastewater and recover nutrient ions. When wastewater was circulated between the anode and cathode chambers of the MNRC, the organics (COD) were removed by bacteria while ammonium and phosphate (NH4(+)-N and PO4(3-)-P) were recovered by the electrical field that was produced using in situ energy in the wastewater without additional energy input. The removal efficiencies from wastewater were >82% for COD, >96% for NH4(+)-N, and >64% for PO4(3-)-P in all the operational cycles. Simultaneously, the concentrations of NH4(+) and PO4(3-) in the recovery chamber increased to more than 1.5 and 2.2 times, respectively, compared with the initial concentrations in wastewater. The MNRC provides proof-of-concept as a sustainable, self-driven approach to efficient wastewater purification and nutrient recovery in a comprehensive bioelectrochemical system.
Assuntos
Fontes de Energia Bioelétrica , Águas Residuárias/química , Purificação da Água/métodos , Compostos de Amônio/química , Compostos de Amônio/isolamento & purificação , Técnicas Eletroquímicas/instrumentação , Técnicas Eletroquímicas/métodos , Eletrodos , Troca Iônica , Fosfatos/química , Fosfatos/isolamento & purificação , Eliminação de Resíduos LíquidosRESUMO
A homogeneous carbon membrane with multi-functions of microfiltration, electron conduction, and oxygen reduction catalysis was fabricated without using noble metals. The produced carbon membrane has a pore size of 553nm, a resistance of 6.0±0.4Ωcm(2)/cm, and a specific surface area of 32.2m(2)/g. After it was assembled in microbial fuel cell (MFC) as filtration air cathode, a power density of 581.5mW/m(2) and a current density of 1671.4mA/m(2) were achieved, comparable with previous Pt air cathode MFCs. The filtration MFC was continuously operated for 20days and excellent wastewater treatment performance was also achieved with removal efficiencies of TOC (93.6%), NH4(+)-N (97.2%), and total nitrogen (91.6%). In addition, the carbon membrane was much cheaper than traditional microfiltration membrane, suggesting a promising multi-functional material in wastewater treatment field.