Substitutionally Doped MoSe2 for High-Performance Electronics and Optoelectronics.

2D materials, of which the carrier type and concentration are easily tuned, show tremendous superiority in electronic and optoelectronic applications. However, the achievements are still quite far away from practical applications. Much more effort should be made to further improve their performance. Here, p-type MoSe2 is successfully achieved via substitutional doping of Ta atoms, which is confirmed experimentally and theoretically, and outstanding homojunction photodetectors and inverters are fabricated. MoSe2 p-n homojunction device with a low reverse current (300 pA) exhibits a high rectification ratio (104 ). The analysis of dark current reveals the domination of the Shockley-Read-Hall (SRH) and band-to-band tunneling (BTB) current. The homojunction photodetector exhibits a large open-circuit voltage (0.68 V) and short-circuit currents (1 µA), which is suitable for micro-solar cells. Furthermore, it possesses outstanding responsivity (0.28 A W-1 ), large external quantum efficiency (42%), and a high signal-to-noise ratio (≈107 ). Benefiting from the continuous energy band of homojunction, the response speed reaches up to 20 µs. Besides, the Ta-doped MoSe2 inverter exhibits a high voltage gain (34) and low power consumption (127 nW). This work lays a foundation for the practical application of 2D material devices.

Extrinsic Photoconduction Induced Short-Wavelength Infrared Photodetectors Based on Ge-Based Chalcogenides.

2D layered photodetectors have been widely researched for intriguing optoelectronic properties but their application fields are limited by the bandgap. Extending the detection waveband can significantly enrich functionalities and applications of photodetectors. For example, after breaking through bandgap limitation, extrinsic Si photodetectors are used for short-wavelength infrared or even long-wavelength infrared detection. Utilizing extrinsic photoconduction to extend the detection waveband of 2D layered photodetectors is attractive and desirable. However, extrinsic photoconduction has yet not been observed in 2D layered materials. Here, extrinsic photoconduction-induced short-wavelength infrared photodetectors based on Ge-based chalcogenides are reported for the first time and the effectiveness of intrinsic point defects are demonstrated. The detection waveband of room-temperature extrinsic GeSe photodetectors with the assistance of Ge vacancies is broadened to 1.6 µm. Extrinsic GeSe photodetectors have an excellent external quantum efficiency (0.5%) at the communication band of 1.31 µm and polarization-resolved capability to subwaveband radiation. Moreover, room-temperature extrinsic GeS photodetectors with a detection waveband to the communication band of 1.55 µm further verify the versatility of intrinsic point defects. This approach provides design strategies to enrich the functionalities of 2D layered photodetectors.

Ferromagnetic CoSe broadband photodetector at room temperature.

Broadband infrared photodetectors based on two-dimensional (2D) materials which are the research focus in the infrared field, have wide applications in remote sensing, thermal imaging, and astronomy observation. In this article, the photodetector based on 2D ferromagnetic material CoSe is studied at room temperature, demonstrating the air-stable, broadband, and up to long wavelength properties. The CoSe material is applied to infrared photodetectors for the first time. The 2D material CoSe is synthesized by using the chemical vapor deposition method. The size of the as-grown CoSe is up to 71.8 µm. The photoresponse of the CoSe photodetector ranges from 450 nm to 10.6 µm. The photoresponsivity of this photodetector is up to 2.58 A W-1 under the 10.6 µm illumination at room temperature. This work provides a new material for broadband photodetector at room temperature and builds a bridge for the magnetoelectronic and broadband photoelectric fields.

[Association of VKORC1 gene -1639G/A polymorphism with atrial fibrillation in ethnic Uygurs and Hans from Xinjiang].

OBJECTIVE: To assess the association of VKORC1 gene -1639G/A polymorphism with atrial fibrillation (AF) in ethnic Uygurs and Hans from Xinjiang. METHODS: The above polymorphism was detected among 100 Uygur and 102 Han AF patients and 103 Uygur and 111 Han subjects that have no AF with polymerase chain reaction-restriction fragment length polymorphism (PCR-RFLP) method. RESULTS: A statistically significant difference was detected between the patient and control groups of Uygur origin in terms of genotypic and allelic frequencies (P<0.05). Logistic regression analysis also indicated the -1639G/A polymorphism as an independent risk factor for AF in Uygur population (OR=2.085, 95% CI: 1.067-4.072, P=0.031). No similar statistical difference was found between the patient and control groups of Han origin (P>0.05). CONCLUSION: The -1639G/A polymorphism of VKORC1 gene is associated with AF in the Uygur population but not in Hans.

Prion-like Proteins in Plants: Key Regulators of Development and Environmental Adaptation via Phase Separation.

Prion-like domains (PrLDs), a unique type of low-complexity domain (LCD) or intrinsically disordered region (IDR), have been shown to mediate protein liquid-liquid phase separation (LLPS). Recent research has increasingly focused on how prion-like proteins (PrLPs) regulate plant growth, development, and stress responses. This review provides a comprehensive overview of plant PrLPs. We analyze the structural features of PrLPs and the mechanisms by which PrLPs undergo LLPS. Through gene ontology (GO) analysis, we highlight the diverse molecular functions of PrLPs and explore how PrLPs influence plant development and stress responses via phase separation. Finally, we address unresolved questions about PrLP regulatory mechanisms, offering prospects for future research.

Van der Waals two-color infrared photodetector.

With the increasing demand for multispectral information acquisition, infrared multispectral imaging technology that is inexpensive and can be miniaturized and integrated into other devices has received extensive attention. However, the widespread usage of such photodetectors is still limited by the high cost of epitaxial semiconductors and complex cryogenic cooling systems. Here, we demonstrate a noncooled two-color infrared photodetector that can provide temporal-spatial coexisting spectral blackbody detection at both near-infrared and mid-infrared wavelengths. This photodetector consists of vertically stacked back-to-back diode structures. The two-color signals can be effectively separated to achieve ultralow crosstalk of ~0.05% by controlling the built-in electric field depending on the intermediate layer, which acts as an electron-collecting layer and hole-blocking barrier. The impressive performance of the two-color photodetector is verified by the specific detectivity (D*) of 6.4 × 109 cm Hz1/2 W-1 at 3.5 µm and room temperature, as well as the promising NIR/MWIR two-color infrared imaging and absolute temperature detection.

Fast Uncooled Mid-Wavelength Infrared Photodetectors with Heterostructures of van der Waals on Epitaxial HgCdTe.

Uncooled infrared photodetectors have evoked widespread interest in basic research and military manufacturing because of their low-cost, compact detection systems. However, existing uncooled infrared photodetectors utilize the photothermoelectric effect of infrared radiation operating at 8-12 µm, with a slow response time in the millisecond range. Hence, the exploration of new uncooled mid-wavelength infrared (MWIR) heterostructures is conducive to the development of ultrafast and high-performance nano-optoelectronics. This study explores a van der Waals heterojunction on epitaxial HgCdTe (vdWs-on-MCT) as an uncooled MWIR photodetector, which achieves fast response as well as high detectivity for spectral blackbody detection. Specifically, the vdWs-on-MCT photodetector has a fast response time of 13 ns (77 MHz), which is approximately an order of magnitude faster than commercial uncooled MCT photovoltaic photodetectors. Importantly, the device exhibits a photoresponsivity of 2.5 A W-1 , quantum efficiency as high as 85%, peak detectivity of 2 × 1010  cm Hz1/2 W-1 under blackbody radiation at room temperature, and peak detectivity of up to 1011  cm Hz1/2 W-1 at 77 K. Thereby, this work facilitates the effective design of high-speed and high-performance heterojunction uncooled MWIR photodetectors.

Hole-dominated Fowler-Nordheim tunneling in 2D heterojunctions for infrared imaging.

Heterostructures based on diverse two-dimensional (2D) materials are effective for tailoring and further promoting device performance and exhibit considerable potential in photodetection. However, the problem of high-density thermionic carriers can be hardly overcome in most reported heterostructure devices based on type I and type II band alignment, which leads to an unacceptably small Iphoto/Idark and strong temperature dependence that limit the performance of photodetectors. Here, using the MoTe2/h-BN/MoTe2/h-BN heterostructure, we report the hole-dominated Fowler-Nordheim quantum tunneling transport in both on and off states. The state-of-the-art device operating at room temperature shows high detectivity of >108 Jones at a laser power density of <0.3 nW µm-2 from the visible to near infrared range. In addition, the fast on-off switching and highly sensitive photodetection properties promise superior imaging capabilities. The tunneling mechanism, in combination with other unique properties of 2D materials, is significant for novel photodetection.

Direct observation and manipulation of hot electrons at room temperature.

In modern electronics and optoelectronics, hot electron behaviors are highly concerned, as they determine the performance limit of a device or system, like the associated thermal or power constraint of chips and the Shockley-Queisser limit for solar cell efficiency. To date, however, the manipulation of hot electrons has been mostly based on conceptual interpretations rather than a direct observation. The problem arises from a fundamental fact that energy-differential electrons are mixed up in real-space, making it hard to distinguish them from each other by standard measurements. Here we demonstrate a distinct approach to artificially (spatially) separate hot electrons from cold ones in semiconductor nanowire transistors, which thus offers a unique opportunity to observe and modulate electron occupied state, energy, mobility and even path. Such a process is accomplished through the scanning-photocurrent-microscopy measurements by activating the intervalley-scattering events and 1D charge-neutrality rule. Findings here may provide a new degree of freedom in manipulating non-equilibrium electrons for both electronic and optoelectronic applications.

Controllable Doping in 2D Layered Materials.

For each generation of semiconductors, the issue of doping techniques is always placed at the top of the priority list since it determines whether a material can be used in the electronic and optoelectronic industry or not. When it comes to 2D materials, significant challenges have been found in controllably doping 2D semiconductors into p- or n-type, let alone developing a continuous control of this process. Here, a unique self-modulated doping characteristic in 2D layered materials such as PtSSe, PtS0.8 Se1.2 , PdSe2 , and WSe2 is reported. The varying number of vertically stacked-monolayers is the critical factor for controllably tuning the same material from p-type to intrinsic, and to n-type doping. Importantly, it is found that the thickness-induced lattice deformation makes defects in PtSSe transit from Pt vacancies to anion vacancies based on dynamic and thermodynamic analyses, which leads to p- and n-type conductance, respectively. By thickness-modulated doping, WSe2 diode exhibits a high rectification ratio of 4400 and a large open-circuit voltage of 0.38 V. Meanwhile, the PtSSe detector overcomes the shortcoming of large dark-current in narrow-bandgap optoelectronic devices. All these findings provide a brand-new perspective for fundamental scientific studies and applications.

Blackbody-sensitive room-temperature infrared photodetectors based on low-dimensional tellurium grown by chemical vapor deposition.

Blackbody-sensitive room-temperature infrared detection is a notable development direction for future low-dimensional infrared photodetectors. However, because of the limitations of responsivity and spectral response range for low-dimensional narrow bandgap semiconductors, few low-dimensional infrared photodetectors exhibit blackbody sensitivity. Here, highly crystalline tellurium (Te) nanowires and two-dimensional nanosheets were synthesized by using chemical vapor deposition. The low-dimensional Te shows high hole mobility and broadband detection. The blackbody-sensitive infrared detection of Te devices was demonstrated. A high responsivity of 6650 A W-1 (at 1550-nm laser) and the blackbody responsivity of 5.19 A W-1 were achieved. High-resolution imaging based on Te photodetectors was successfully obtained. All the results suggest that the chemical vapor deposition-grown low-dimensional Te is one of the competitive candidates for sensitive focal-plane-array infrared photodetectors at room temperature.

Air-Stable Low-Symmetry Narrow-Bandgap 2D Sulfide Niobium for Polarization Photodetection.

Low-symmetry 2D materials with unique anisotropic optical and optoelectronic characteristics have attracted a lot of interest in fundamental research and manufacturing of novel optoelectronic devices. Exploring new and low-symmetry narrow-bandgap 2D materials will be rewarding for the development of nanoelectronics and nano-optoelectronics. Herein, sulfide niobium (NbS3 ), a novel transition metal trichalcogenide semiconductor with low-symmetry structure, is introduced into a narrowband 2D material with strong anisotropic physical properties both experimentally and theoretically. The indirect bandgap of NbS3 with highly anisotropic band structures slowly decreases from 0.42 eV (monolayer) to 0.26 eV (bulk). Moreover, NbS3 Schottky photodetectors have excellent photoelectric performance, which enables fast photoresponse (11.6 µs), low specific noise current (4.6 × 10-25 A2 Hz-1 ), photoelectrical dichroic ratio (1.84) and high-quality reflective polarization imaging (637 nm and 830 nm). A room-temperature specific detectivity exceeding 107 Jones can be obtained at the wavelength of 3 µm. These excellent unique characteristics will make low-symmetry narrow-bandgap 2D materials become highly competitive candidates for future anisotropic optical investigations and mid-infrared optoelectronic applications.