Pyrene-Based Cationic Fluorophores with High Affinity for BF4-, PF6-, and ClO4- Anions: Detection and Removal.

Anions play an indispensable role in the balance and regulation of the ecological environment and human health; however, excess anions can cause serious ecological and environment problems. Therefore, the detection and removal of excess anions in aqueous solution is not only a technological problem but also crucial for environmental protection. Herein, a set of water-soluble pyrene-based cationic fluorophores were synthesized, which exhibit high sensitivity for the detection of the anions BF4-, PF6-, and ClO4- via electrostatic interactions. Such fluorescent probes exhibit "turn-on" emission characteristics even at low concentrations of anions due to anion-π+ interactions. Moreover, these fluorescence probes act as efficient precipitating agents for the removal of the BF4-, PF6-, and ClO4- anions from an aqueous environment. This work opens up new avenues for future research on pyrene-based fluorophores as turn-on fluorescence probes for anion detection and as excellent precipitating agents in environmental settings.

Dynamic Coordination between a Triphenylamine-Functionalized Salicylaldehyde Schiff Base and a Copper(II) Ion.

The coordination between a ligand and a metal is a spontaneous and uncontrollable process. In this Article, we successfully observe the formation of metal coordination in a triphenylamine-functionalized salicylaldehyde Schiff base with a copper(II) ion. The ligand TPA-Py first reacts with Cu2+ in a stepwise process to afford the dynamic complex TPA-Py@Cu2+ ([ligand]:[Cu2+] = 1:1), which further reacts with an extra copper(II) ion to afford 2TPA-Py@4Cu2+ with the following stepwise (or cumulative) stability constants: K1 = 4.0694 × 103 and K2 = 1.0761 × 106, respectively. The entire metal coordination process can be visualized, and the coordination mode of the probe toward copper was further evaluated by ultraviolet-visible/fluorescence spectra, single-crystal X-ray diffraction, density functional theory calculations, high-resolution mass spectra, and nuclear magnetic resonance spectroscopic titrations. Compound TPA-Py exhibited excellent sensitivity and specificity toward copper(II) ions in THF/water media with a low limit of detection of 2.687 × 10-7 mol L-1. In addition, TPI-An-Py can be applied to the detection of Cu2+ in real samples with satisfactory recoveries in the range of 100-112% in lake water and 98-101% in tap water. This Article not only reports an excellent fluorescence probe for copper(II) ion detection but also presents an instance for more fully understanding the metal coordination process.

A Highly Selective Turn-On Fluorescent Probe for the Detection of Zinc.

A novel turn-on fluorescence probe L has been designed that exhibits high selectivity and sensitivity with a detection limit of 9.53 × 10-8 mol/L for the quantification of Zn2+. 1H-NMR spectroscopy and single crystal X-ray diffraction analysis revealed the unsymmetrical nature of the structure of the Schiff base probe L. An emission titration experiment in the presence of different molar fractions of Zn2+ was used to perform a Job's plot analysis. The results showed that the stoichiometric ratio of the complex formed by L and Zn2+ was 1:1. Moreover, the molecular structure of the mononuclear Cu complex reveals one ligand L coordinates with one Cu atom in the asymmetric unit. On adding CuCl2 to the ZnCl2/L system, a Cu-Zn complex was formed and a strong quenching behavior was observed, which inferred that the Cu2+ displaced Zn2+ to coordinate with the imine nitrogen atoms and hydroxyl oxygen atoms of probe L.

A 1-Hydroxy-2,4-Diformylnaphthalene-Based Fluorescent Probe and Its Detection of Sulfites/Bisulfite.

A novel 1-hydroxy-2,4-diformylnaphthalene-based fluorescent probe L was synthesized by a Knoevenagel reaction and exhibited excellent sensitivity and selectivity towards sulfite ions (SO32-) and bisulfite ions (HSO3-). The detection limits of the probe L were 0.24 µM using UV-Vis spectroscopy and 9.93 nM using fluorescence spectroscopy, respectively. Furthermore, the fluorescent probe L could be utilized for detection in real water samples with satisfactory recoveries in the range 99.20%~104.30% in lake water and 100.00%~104.80% in tap water by UV-Vis absorption spectrometry, and in the range 100.50%~108.60% in lake water and 102.70%~103.80% in tap water by fluorescence spectrophotometry.

A Simple Turn-off Schiff Base Fluorescent Sensor for Copper (II) Ion and Its Application in Water Analysis.

An aniline-functionalized naphthalene dialdehyde Schiff base fluorescent probe L with aggregation-induced enhanced emission (AIEE) characteristics was synthesized via a simple one-step condensation reaction and exhibited excellent sensitivity and selectivity towards copper(II) ions in aqueous media with a fluorescence " turn-off " phenomenon. The detection limit of the probe is 1.64 × 10-8 mol·L-1. Furthermore, according to the results of the UV-vis/fluorescence titrations, Job's plot method and 1H-NMR titrations, a 1:2 stoichiometry was identified. The binding constant between L and Cu2+ was calculated to be Ka = 1.222 × 103. In addition, the AIEE fluorescent probe L could be applied to detection in real water samples with satisfactory recoveries in the range 99.10-102.90% in lake water and 98.49-102.37% in tap water.

A Turn-On Fluorescent Chemosensor for Cyanide Ion Detection in Real Water Samples.

We have designed and synthesized a novel simple colorimetric fluorescent probe with aggregation-induced emission (AIE) properties. Probe 5-(4-(diphenylamine)phenyl) thiophen-2-formaldehyde W exhibited a turn-on fluorescent response to cyanide ion (CN-), which induces distinct visual color changes. Probe W exhibited a highly selective and sensitive ratiometric fluorescence response for the detection of CN- over a wide pH range (4-11) and in the presence of common interferents. The linear detection of CN- over the concentration range of 4.00-38.00 µM (R 2 = 0.9916, RSD = 0.02) was monitored by UV-Vis absorption spectrometry (UV-Vis) with the limit of detection determined to be 0.48 µM. The linear detection of CN- over the concentration range of 8.00-38.00 µM was examined by fluorescence spectrophotometry (R 2 = 0.99086, RSD = 0.031), and the detection limit was found to be 68.00 nM. The sensing mechanisms were confirmed by 1H NMR spectroscopic titrations, X-ray crystallographic analysis, and HRMS. Importantly, probe W was found to show rapid response, high selectivity, and sensitivity for cyanide anions in real water samples, over the range of 100.17∼100.86% in artificial lake water and 100.54∼101.64% in running water by UV-Vis absorption spectrometry, and over the range of 99.42∼100.71% in artificial lake water and 100.59∼101.17% in running water by fluorescence spectrophotometry. Importantly, this work provides a simple and effective approach which uses an economically cheap and uncomplicated synthetic route for the selective, sensitive, and quantitative detection of CN- ions in systems relevant to the environment and health.