RESUMO
In situ immobilization is a widely used measure for passivating Cd-contaminated soils. Amendments need to be continuously applied to achieve stable remediation effects. However, few studies have evaluated the impact of consecutive application of amendments on soil health and the microecological environment. A field experiment was conducted in a Cd-contaminated paddy (available Cd concentration 0.40 mg kg-1) on the Chengdu Plain to investigate the changes in soil Cd availability and response characteristics of soil bacterial communities after consecutive application of rice straw biochar (SW), fly ash (FM) and marble powder (YH) amendments from 2018 to 2020. Compared with control treatment without amendments (CK), soil pH increased by 0.6, 0.5 and 1.5 under SW, FM and YH amendments, respectively, and the soil available Cd concentration decreased by 10.71%, 21.42% and 25.00%, respectively. The Cd concentration in rice grain was less than 0.2 mg kg-1 under YH amendment, which was within the Chinese Contaminant Limit in Food of National Food Safety Standards (GB2762-2022) in the second and third years. The three amendments had different effects on the transformation of Cd fractions in soil, which may be relevant to the specific bacterial communities shaped under different treatments. The proportion of Fe-Mn oxide-bound fraction Cd (OX-Cd) increased by 11% under YH treatment, which may be due to the promotion of Fe(III) and Cd binding by some enriched iron-oxidizing bacteria, such as Lysobacter, uncultured_Pelobacter sp. and Sulfurifusis. Candidatus_Tenderia and Sideroxydans were enriched under SW and FM amendments, respectively, and were likely beneficial for reducing Cd availability in soil through Cd immobilization. These results revealed the significance of the bacterial community in soil Cd immobilization after consecutive application of amendments and highlighted the potential of applying YH amendment to ensure the safe production of rice in Cd-contaminated soil.
RESUMO
Despite the fact that the high conductivity of two-dimensional laminated transition metal carbides/nitrides (MXenes) contributes to the outstanding electromagnetic interference (EMI) shielding by the reflection of electromagnetic waves (EWs), it is difficulty to improve EMI shielding by pursuing higher conductivity due to the limitation of intrinsic properties. Here, we achieve superior EMI shielding by introducing the absorption of EWs in MXenes with micro-sized wrinkles which are induced by abundant Ti vacancies under chemical etching. The shielding effectiveness is up to 107â dB at a thickness of 20â µm. Combining with atomic-scale structure observation and the first-principles calculations, it is concluded that the promotion of EMI shielding originates from the resonant absorption of formed electric dipoles induced by the asymmetrical distribution of charge densities near Ti vacancies. Our results could open a new vista for developing two-dimensional EMI shielding materials.
RESUMO
Polymer-derived carbon nitrides based photocatalysts are very promising for solar water splitting, CO2 reduction and environmental remediation. However, these photocatalysts still suffer from low visible light utilization efficiency, rapid recombination of photogenerated charge carriers and slow transfer kinetics. Herein, we report a hydrogen peroxide-assisted hydrothermal strategy to synthesize one-dimensional oxygen-doped carbon nitrides (OCN) for photocatalytic hydrogen evolution. A possible self-assembly mechanism is discussed. Experimental results and theoretical calculations indicate that the as-synthesized one-dimensional OCN possess narrowed band gap energy and optimized band structure, which may allow more effective visible-light harvesting and facilitate photogenerated electron-hole pair separation and transfer. As a result, the photocatalytic hydrogen evolution rates improve from 10.4 µmol h-1 to 74.0 µmol h-1 under visible light (λ > 400 nm), which is among the best of the reported CN-based photocatalysts for visible-light-driven hydrogen evolution. This study provides a new avenue toward the development of highly efficient carbon nitrides based photocatalysts for photocatalytic applications.
RESUMO
Strain within nanomaterials plays a crucial role in defining their physical and chemical properties. Geometrical phase analysis (GPA) was widely used to investigate deformation within nanomaterials. The traditional GPA method using geometric phases of two lattice fringes provides two-dimensional strain mapping, which is inapplicable to nanomaterials viewed along high-index zone axis. Herein using silicon nanoplate embedded in Si0.5Ge0.5 matrix as a test object, we illustrate a GPA method using single lattice fringes. The availability of this GPA method was testified by comparison with traditional GPA method. This work presents an opportunity to extend application of the GPA method.
RESUMO
Two-dimensional (2D) ultrathin silicon nanosheets (Si NSs) were synthesized by DC arc discharge method and investigated as anode material for Li-ion batteries. The 2D ultrathin characteristics of Si NSs is confirmed by means of transmission electron microscopy (TEM) and atomic force microscopy (AFM). The average size of Si NSs is about 20 nm, with thickness less than 2.5 nm. The characteristic Raman peak of Si NSs is found to have an appreciable (20 nm) shift to low frequency, presumably due to the size effect. The synergistic effects of Ar(+) and H(+) lead to 2D growth of Si NSs under high temperature and energy. Electrochemical analyses reveal that Si NSs anode possesses stable cycling performance and fast diffusion of Li-ions with insertion/extraction processes. Such Si NSs might be a promising candidate for anode of Li-ion batteries.