Time characteristics of aero-optical imaging degeneration of the ellipsoidal dome under variable operating conditions.

As a missile flies at high speed, the index and surface shape of the conformal dome will vary under the influence of the aero-optical effect, which will degenerate the performance of the seeker's imaging detection system. However, many previous studies on aero-optical imaging deterioration of optical domes were usually carried out under fixed operating conditions, which are not in line with the real flight scene of the missile. In addition, the aero-optical imaging degeneration of the dome is diverse as the flight time increases. Therefore, it is of great significance to study the time characteristics of aero-optical imaging degradation of optical domes under variable work conditions. In this study, taking an air-to-air missile as an example, the Zernike polynomials, wavefront aberration, Strehl ratio, and image simulation are applied to evaluate the aero-optical imaging deterioration of an ellipsoidal dome in the flight time range of 0-10 s under variable working conditions. The simulation results show that, as the flight time increases, (1) the dynamic range of tilt, defocus, astigmatism, coma, and wavefront aberration increase; and (2) the Strehl ratio and the peak signal-to-noise ratio (PSNR) of the simulated images decrease. Therefore, the influence of flight time on the aero-optical image degradation of the ellipsoidal dome gradually becomes more serious.

One step synthesis of PANI/Fe2O3 nanocomposites and flexible film for enhanced NH3 sensing performance at room temperature.

Novel sea cucumber-shaped polyaniline/ferric oxide (PANI/Fe2O3) nanocomposites were synthesized using a simple and efficient one step hydrothermal process, and the nanocomposites were further assembled onto a polyethylene terephthalate (PET) flexible substrate. Through the monitoring of the resistance of the PANI/Fe2O3 nanocomposites thick films and PANI/Fe2O3-PET flexible sensors, the responses of the sensors to various 100 ppm gases including methanol, triethylamine, aniline and another five gases were obtained. It was found that two kinds of sensors exhibit a high selectivity towards NH3. The PANI/Fe2O3 nanocomposites-based sensor has a good response and a low detection limit (0.3 ppm) at room temperature (20 ± 5 °C). It also shows a good linearity relationship in a certain concentration of NH3. After assembling into the PANI/Fe2O3-PET flexible film sensor, the response of the sensor is significantly increased to 6.12 for 100 ppm NH3, the detection limit is as low as 0.5 ppm, and the sensor shows good stability and linearity, which is more conducive to the application of such a material in wearable gas sensors.

Cu-Pt/CrN Fuel Cell Gas Sensor Achieves ppb-Level H2S Detection at Room Temperature.

Fuel cell gas sensors have emerged as promising advanced sensing devices owing to their advantageous features of low power consumption and cost-effectiveness. However, commercially available Pt/C electrodes pose significant challenges in terms of stability and accurate detection of low concentrations of target gases. Here, we introduce an efficient Cu-Pt/CrN-based fuel cell gas sensor, designed specifically for the ultrasensitive detection of hydrogen sulfide (H2S) at room temperature. Compared to the commercial Pt/C sensor, the Cu-Pt/CrN sensor exhibits excellent sensitivity (0.26 µA/ppm), with an increase in the selectivity by a factor of 2.5, and demonstrates good stability over a 2 month period. The enhanced sensing performance can be attributed to the modulation of the electronic arrangement of Pt by Cu, resulting in an augmentation of H2S adsorption. The Cu-Pt/CrN fuel cell gas sensor provides an opportunity for detecting parts per billion-level H2S in various applications.

Flexible Room-Temperature Ammonia Gas Sensors Based on PANI-MWCNTs/PDMS Film for Breathing Analysis and Food Safety.

Gas sensors have played a critical role in healthcare, atmospheric environmental monitoring, military applications and so on. In particular, flexible sensing devices are of great interest, benefitting from flexibility and wearability. However, developing flexible gas sensors with a high sensitivity, great stability and workability is still challenging. In this work, multi-walled carbon nanotubes (MWCNTs) were grown on polydimethylsiloxane (PDMS) films, which were further modified with polyaniline (PANI) using a simple chemical oxidation synthesis. The superior flexibility of the PANI-MWCNTs/PDMS film enabled a stable initial resistance value, even under bending conditions. The flexible sensor showed excellent NH3 sensing performances, including a high response (11.8 ± 0.2 for 40 ppm of NH3) and a low limit of detection (10 ppb) at room temperature. Moreover, the effect of a humid environment on the NH3 sensing performances was investigated. The results show that the response of the sensor is enhanced under high humidity conditions because water molecules can promote the adsorption of NH3 on the PANI-MWCNTs/PDMS films. In addition, the PANI-MWCNTs/PDMS film sensor had the abilities of detecting NH3 in the simulated breath of patients with kidney disease and the freshness of shrimp. These above results reveal the potential application of the PANI-MWCNTs/PDMS sensor for monitoring NH3 in human breath and food.

Nonenzymatic Flexible Wearable Biosensors for Vitamin C Monitoring in Sweat.

Nutritional status monitoring plays an important role in the maintenance of human health and disease prevention. Monitoring the intake of vitamins can support the improvement of diet behavior. In this work, a polyaniline (PANI) film-based nonenzymatic electrochemical sensor was prepared to track the vitamin C level in sweat. The PANI film was modified with organic acids (ethylformic acid, malic acid, tartaric acid, and phytic acid). The phytic acid-modified PANI film based on sensor has a wide detection range (0.5-500 µmol·L-1), high sensitivity (665.5 and 326.2 µA·(mmol·L-1)-1·cm-2), and low detection limit (0.17 µmol·L-1) toward vitamin C in sweat. The phytate enhances the band transport between PANI chains, which increases the electrical conductivity of the film to improve the electrochemical properties of the sensor. In addition, we monitored changes of vitamin C levels in human body after taking vitamin C pills by detecting sweat or saliva. The ability to track the pharmacological profile demonstrates the potential of PANI film-based sensors for applications in personalized nutritional intake and tracking. And a simple and portable vitamin C detection system was developed to improve the practicability of the sensor. This work provides an idea for the application of wearable electrochemical sensing devices in nutrition guidance.

A dual-functional polyaniline film-based flexible electrochemical sensor for the detection of pH and lactate in sweat of the human body.

A flexible dual functional electrochemical sensor based on macroscopic polyaniline (PANI) film is reported. The PANI film is prepared by interfacial synthesis without any additional templates and surfactants, and is easily transferred from the water surface to any substrate. The surface of PANI film is flat and has a certain degree of crystallization. The PANI film exhibits good electrochemical properties, which is attributed to the order structure of PANI. The flexible sensor based on PANI film exhibits good electrochemical performances to pH and lactate. And the flexible PANI sensor has good reproducibility, selectivity and long-term stability. Meanwhile, the PANI sensor is also applied to detect the actual sample (such as food and human sweat), and the results are in accordance with the commercial pH meter, indicating the reliability of the PANI sensor.

A flexible electrochemical biosensor based on functionalized poly(3,4-ethylenedioxythiophene) film to detect lactate in sweat of the human body.

Conductive polymers with good flexibility, conductivity and film-forming ability attract a lot of attention. In this work, a large-area and ordered structure poly(3,4-ethylenedioxythiophene) (PEDOT) film is fabricated at the air-water interface through interface synthesis method. The PEDOT film can be directly placed on a flexible screen-printed electrode, but also has good adhesion between them. The surface of the PEDOT film is relatively smooth, and has good electrical conductivity and flexibility. Lactate oxidase is immobilized on the surface of PEDOT film through a combination of cross-linking and adsorption method to enhance the lactate sensitive performances. The results show that the PEDOT film sensor has excellent stability and reproducibility. The PEDOT film sensor shows a good response to lactate, the working range is 0.25-40 mmol L-1, and the detection limit is 0.083 mmol L-1 (S/N = 3). Moreover, the electrochemical sensor has potential application in detecting lactate in sweat of the human body.

Enhanced Sub-ppm NH3 Gas Sensing Performance of PANI/TiO2 Nanocomposites at Room Temperature.

PANI/TiO2 nanocomposites spheres were synthesized using a simple and efficient one-step hydrothermal process. The morphology and structure of PANI/TiO2 nanocomposites spheres were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), and transmission electron microscopy (TEM) techniques. The PANI/TiO2 nanocomposite sphere-based sensor exhibits good selectivity, sensitivity (5.4 to 100 ppm), repeatability, long-term stability and low detection limit (0.5 ppm) to ammonia at room temperature (20 ± 5°C). It also shows a good linearity relationship in the range of 0.5-5 and 5-100 ppm. The excellent NH3 sensing performance is mainly due to the formation of the p-n heterostructure in the nanocomposites.