A Simple Two-Step Cloud Point Extraction Process for Removing Fluorescent Whitening Agents VBL in Industrial Wastewater and Recycling of Surfactant.

With the enhancement of people's environmental consciousness, the treatment of wastewater was studied as the focus of this paper. Here we present a simple two-step extraction to realize efficient separation of fluorescent whitening agents VBL and cyclic utilization of surfactant to reduce the cost of wastewater treatment and environmental pollution. Firstly, the removal of VBL has been achieved by CPE using TX-114 as nonionic surfactant. The results showed that complete extraction was possible using 1% (w/w) TX-114 for VBL concentration not exceeding 17.5 mg/L, otherwise using a higher concentration of 1.5% (w/w) TX-114. Then the surfactant from the coacervate phase was recycled by changing the potential difference between phases. The morphology of micelles and solubilization mechanism of VBL were demonstrated through the observation of a fluorescent microscope. This method was successfully used to remove the VBL from wastewater sample and the surfactant could be reused several times.

A comparative study of adsorption of an anionic and a non-ionic surfactant by soils based on physicochemical and mineralogical properties of soils.

In the present work we performed a comparative study on the adsorption of the surfactants sodium dodecyl sulphate (SDS) (anionic), and octylphenoxypolyethoxyethanol (Triton X-100) (non-ionic) to 18 soils with organic matter (OM) and clay fraction contents varying over a broad range. The objective of the study was to gain further insight into the influence of the physicochemical and mineralogical properties of soils on the adsorption of surfactants by soils. Adsorption isotherms were obtained using concentrations below the critical micellar concentration (cmc) of the surfactants. The adsorption coefficients, Kf, determined from the Freundlich equation were lower for SDS (range 1.77-82.1, mean value 36.3) than for Triton X-100 (range 0.01-913, mean value 257). Simple and multiple correlation coefficients were obtained between Kf values and soil characteristics. The results obtained indicate the influence of the OM content on the adsorption of SDS (r=0.64, p<0.01) and of the clay fraction content on that of Triton X-100 (r=0.83, p<0.001). Additionally, we observed a preferential adsorption of SDS by the 1:1 mineral kaolinite (r=0.54, p<0.05), while Triton X-100 was adsorbed mainly by the 2:1 minerals, montmorillonite (r=0.66, p<0.01) and illite (r=0.87, p<0.001). According to the influence of different soil parameters on adsorption, different mechanisms of adsorption are proposed for each surfactant. Our findings point to the interest of considering the physicochemical properties of soils and also the mineralogy of the soil clay fraction when selecting a surfactant in technologies involving enhanced solubilization and removal of contaminants from soils and sediments.

Effect of amphiphilic polyurethane nanoparticles on sorption-desorption of phenanthrene in aquifer material.

Micelle-like amphiphilic nano-sized polyurethane (APU) nanoparticles were synthesized via chemical cross-linking reaction of nano-aggregates of urethane acrylate nonionomer (UAN) chain and were tested for extraction efficiency of sorbed phenanthrene from aquifer material. Even though the solubilizing performance and interfacial activity of APU nanoparticles were inferior to that of Triton X-100, in the low concentration region, APU nanoparticles could effectively reduce phenanthrene sorption on the aquifer material and extracted sorbed phenanthrene from the aquifer material, whereas Triton X-100 could not extract sorbed phenanthrene and rather increased phenanthrene sorption onto the aquifer materials. At higher concentrations, APU nanoparticles and Triton X-100 had almost the same soil washing effectiveness. This interesting result is mainly due to a lower degree of sorption of APU nanoparticles onto the aquifer material. The sorption of APU nanoparticles onto aquifer sand is largely hindered by their chemically cross-linked nature, resulting in better soil-washing performance of APU nanoparticles than Triton X-100.

Comparison of amphiphilic polyurethane nanoparticles to nonionic surfactants for flushing phenanthrene from soil.

Amphiphilic polyurethane (APU) nanoparticles were synthesized through crosslinking polymerization of nano-aggregates of urethane acrylate nonionomer (UAN). The efficiency of in situ extraction of sorbed phenanthrene from aquifer material was tested using soil columns and compared with that of surfactants such as Triton X-100, Brij 30, and Tween 80. The extraction efficiency of those washing materials strongly depended on their concentration, flow rate, and the degree of sorption within soil column. That is, the extraction efficiency increased with the decrease of flow rate and the degree of sorption and the increase of the concentration. Even though the surfactants are superior to APU nanoparticles at solubilizing phenanthrene, at the same flow rate (0.02 mL/min) and concentration (4000 mg/L), the effectiveness of in situ soil washing of APU nanoparticles was about two times higher than those of surfactants. This is because, at the lower flow rates, the degree of sorption of APU nanoparticles was lower than that of surfactants, owing to the chemically crosslinked nature of APU nanoparticles.

Micellar partitioning and its effects on Henry's law constants of chlorinated solvents in anionic and nonionic surfactant solutions.

Micellar partitioning of volatile chlorinated hydrocarbons in surfactant solutions and its effects on vapor-liquid equilibrium is fundamental to the overall design and implementation of surfactant-enhanced aquifer remediation. Surfactant micelles greatly enhance contaminant recovery from the subsurface; however, the reduced volatility of organic compounds compromises the aboveground treatment of surfactant-laden wastewaters using air-stripping process. Batch equilibrium tests were performed to acquire micellar partition coefficients (Km) and apparent Henry's law constants (H*) of three prominent groundwater contaminants (tetrachloroethylene, trichloroethylene, cis-dichlorethylene) in the presence of two anionic surfactants (sodium dodecyl sulfate, SDS; sodium dodecylbenzene sulfonate, SDBS) and two nonionic surfactants (Triton X-100 and Tween 80). The H* values were significantly reduced in the presence of all four surfactants over their critical micelle concentrations (cmc's). On a cmc basis, the anionic surfactant SDS had the greatest effect on H*, followed by SDBS, Triton X-100, and Tween 80. Anionic surfactants decreased H* to an order of magnitude lower than nonionic surfactants, although nonionic surfactants decreased the H* at concentrations significantly lower than the anionic surfactants due to their lower cmc's. Nonionic surfactants present higher Km and molar solubilization ratio than anionic surfactants. Tetrachloroethylene has the highest Km values among three chlorinated solvents, which agrees well with the hydrophobicity (Kow) of these chemicals. An empirical correlation between log Km and log Kow is developed on the basis of data from this study and the Km values reported for a number of chlorinated and nonchlorinated hydrocarbons. Equilibrium data were also tested against three sets of models that describe the partitioning of volatile compounds in vapor-water-micelle phases. Applications of these models in experimentally determining Km from batch vapor-water equilibrium data are discussed.

Regulation of kinase and intermolecular bonding in intact and truncated epidermal growth factor receptor.

Tyrosine kinase activity of the epidermal growth factor (EGF) receptor can be regulated by its state of association. Studies done with the purified receptor solubilized in Triton X-100 indicate that dimer formation results in negative regulation of kinase, whereas successive binding of EGF and ATP shift the association equilibrium toward the catalytically active monomeric form. The promotion of the monomeric state by ATP can be mimicked by various nonphosphorylating analogs indicating that nucleotide binding rather than autophosphorylation is responsible for stabilizing the monomeric receptor form. Truncated receptor forms, lacking either the external EGF-binding domain or the internal kinase (ATP-binding) domain, are unable to form stable dimers. These results suggest that both intra- and extracellular domains of the receptor act to stabilize the kinase-regulatory dimer.