RESUMEN
2D semi-metallic hafnium ditelluride material is used in several applications such as solar steam generation, gas sensing, and catalysis owing to its strong near-infrared absorbance, high sensitivity, and distinctive electronic structure. The zero-bandgap characteristics, along with the thermal and dynamic stability of 2D-HfTe2, make it a desirable choice for developing long-wavelength-range photonics devices. Herein, the HfTe2 -nanosheets are prepared using the liquid-phase exfoliation method, and their superior nonlinear optical properties are demonstrated by the obtained modulation depth of 11.9% (800 nm) and 6.35% (1560 nm), respectively. In addition, the observed transition from saturable to reverse saturable absorption indicates adaptability of the prepared material in nonlinear optics. By utilizing a side polished fiber-based HfTe2 -saturable absorber (SA) inside an Er-doped fiber laser cavity, a mode-locked laser with 724 fs pulse width and 56.63 dB signal-to-noise ratio (SNR) is realized for the first time. The generated laser with this SA has the second lowest mode-locking pump threshold (18.35 mW), among the other 2D material based-SAs, thus paving the way for future laser development with improved efficiency and reduced thermal impact. Finally, employing this HfTe2 -SA, a highly stable single-frequency fiber laser (SNR ≈ 74.56 dB; linewidth ≈ 1.268 kHz) is generated for the first time, indicating its promising ultranarrow photonic application.
RESUMEN
The nonlinear optical (NLO) properties of two-dimensional (2D) materials are fascinating for fundamental physics and optoelectronic device development. However, relatively few investigations have been conducted to establish the combined NLO activities of a 2D material. Herein, a study of numerous NLO properties of 2D gallium sulfide (GaS), including second-harmonic generation (SHG), two-photon excited fluorescence (TPEF), and NLO absorption are presented. The layer-dependent SHG response of 2D GaS identifies the noncentrosymmetric nature of the odd layers, and the second-order susceptibility (χ2) value of 47.98 pm/V (three-layers of GaS) indicates the superior efficiency of the SHG signal. In addition, structural deformation induces the symmetry breaking and facilitates the SHG in the bulk samples, whereas a possible efficient symmetry breaking in the liquid-phase exfoliated samples results in an enhancement of the SHG signal, providing prospective fields of investigation for researchers. The generation of TPEF from 800 to 860 nm depicts the two-photon absorption characteristics of 2D GaS material. Moreover, the saturable absorption characteristics of 2D GaS are realized from the largest nonlinear absorption coefficient (ß) of -9.3 × 103, -91.0 × 103, and -6.05 × 103 cm/GW and giant modulation depths (Ts) of 24.4%, 35.3%, and 29.1% at three different wavelengths of 800, 1066, and 1560 nm, respectively. Hence, such NLO activities indicate that 2D GaS material can facilitate in the technical advancements of future nonlinear optoelectronic devices.
RESUMEN
With the advancement of civilization, water purification, as well as management and disposal of ever-increasing municipal solid waste (MSW), and e-waste, have become global concerns. To address these issues in a sustainable way, a 3D solar evaporator has been proposed in this paper by repurposing recycled paper from MSW in the form of egg trays and waste dry toner (e-waste) using a facile fabrication method. The unique 3D porous structure, fibrous surface, superior water absorbing capability as well as low thermal conductivity of wastepaper-derived egg trays make them an excellent candidate for an efficient solar evaporator, while the waste toner powder coating significantly enhances the optical absorbance capacity. Under 1 sun illumination, the proposed solar evaporator demonstrates an excellent evaporation rate and efficiency of 1.3 kg/m2 h and 78.5%, respectively. Moreover, the competitive advantage of the 3D structure in collecting solar irradiance at various light incident angles in comparison to a 2D structure, excellent cycle stability, low processing temperature, and the use of low-cost waste materials enable its use for large-scale water purification systems.
RESUMEN
Two-dimensional (2D) gallium sulfide (GaS) offers a plethora of exceptional electrical and optical properties, allowing it to be used in a wide range of applications, including photodetectors, hydrogen generation, and nonlinear optical devices. In this paper, ultrathin 2D GaS nanosheets are synthesized using the liquid-phase exfoliation method, and the structure, morphology, and chemical composition of the as-prepared nanosheets are extensively investigated. After depositing 2D GaS nanosheets on side polished fibers, successful saturable absorbers (SAs) are fabricated for the first time. The realized modulation depths are 10 and 5.3% at 1 and 1.5 µm, respectively, indicating the wideband saturable absorption performance of the prepared SAs. By integrating GaS-SAs into three different wavelength-based fiber laser cavities, stable mode-locked pulses are achieved, having pulse durations of 46.22 ps (1 µm), 614 fs (1.5 µm), and 1.02 ps (2 µm), respectively. Additionally, different orders of harmonic mode-locked pulses with the highest repetition rate of 0.55 GHz (45th order) and Q-switched pulses with the shortest pulse duration of 2.2 µs are obtained in the telecommunication waveband. These findings suggest that 2D GaS has a lot of potential for broadband ultrafast photonics in nonlinear photonics devices.
RESUMEN
In-plane anisotropic two-dimensional (2D) materials have gained considerable interest in the field of research, due to having the potential of being used in different device applications. Recently, among these 2D materials, group 10 transition metal dichalcogenides (TMDs) pentagonal Palladium diselenide (PdSe2) is utilized in various sections of researches like nanoelectronics, thermoelectric, spintronics, optoelectronics, and ultrafast photonics, owing to its high air stability and broad absorption spectrum properties. In this paper, it is demonstrated that by utilizing this novel 2D layered PdSe2 material as a saturable absorber (SA) in an EDF laser system, it is possible to obtain switchable laser pulse generation modes. At first, the Q-switching operation mode is attained at a threshold pump power of 56.8 mW at 1564 nm, where the modulation range of pulse duration and repetition rate is 18.5 µs-2.0 µs and 16.4 kHz-57.0 kHz, respectively. Afterward, the laser pulse generation mode is switched to the mode-locked state at a pump power of 63.1 mW (threshold value) by changing the polarization condition inside the laser cavity, and this phenomenon persists until the maximum pump power of 230.4 mW. For this mode-locking operation, the achieved pulse duration is 766 fs, corresponding to the central wavelength and 3 dB bandwidth of 1566 nm and 4.16 nm, respectively. Finally, it is illustrated that PdSe2 exhibits a modulation depth of 7.01%, which substantiates the high nonlinearity of the material. To the best of the authors' knowledge, this is the first time of switchable modes for laser pulse generation are achieved by using this PdSe2 SA. Therefore, this work will encourage the research community to carry out further studies with this PdSe2 material in the future.
RESUMEN
Two-dimensional (2D) transition metal dichalcogenide (TMD) materials have exceptional optoelectronic and structural properties, which allow them to be utilized in several significant applications in energy, catalyst, and high-performance optoelectronic devices. Among other properties, the nonlinear optical properties are gaining much attention in the research field. In this work, a unique pentagonal TMD material, palladium disulfide (PdS2), is employed as a saturable absorber (SA) in an ytterbium-doped fiber (YDF) laser cavity and mode-locked laser pulse is generated. At first, liquid phase exfoliation is performed to prepare PdS2 nanoflakes. Afterward, the PdS2-nanoflakes solution was incorporated in the side-polished fiber (SPF) to form SPF-based PdS2-SA. By utilizing this SA, a highly stable mode-locked laser pulse is realized at pump power of 160 mW, which has a center wavelength of 1033 nm and a 3-dB spectral bandwidth of 3.7 nm. Moreover, the pulse duration, maximum power output and corresponding single-pulse energy were determined as 375 ps, 15.7 mW and 0.64 nJ, respectively. During the experiment, the mode-locked pulse remained stable till the pump power reached a value of 400 mW and, for the regulation of power, the slope efficiency is calculated at about 4.99%. These results indicate that PdS2 material is a promising nonlinear optical material for ultrafast optical applications in the near-infrared (NIR) region.
