Comparison of patient positions without traction table for proximal femoral nailing: Supine, semilithotomy and lateral decubitus positions.

BACKGROUND: Femur intertrochanteric fractures are performed commonly in a supine position with a traction table. There is a challenge in obtaining traction tables, especially in low- and middle-income countries. However, there is still a debate on which position should be preferred if the traction table cannot be obtained. METHODS: A total of 123 patients who were treated for femur intertrochanteric fracture (AO/OTA A1 or A2) using cephalomedullary nail (CN) were retrospectively analyzed. All three positions without traction table (supine:25 patients, semilithotomy:36 patients and lateral decubitus:62 patients) were compared according to preparation time, surgical time, Tip-Apex distance (TAD), zones of lag screw placement, collodiaphyseal angle (CDA), CDA difference (∆ CDA), postoperative posterior sag, medial cortical support and Baumgardner reduction quality criteria. RESULTS: The preparation time was longer in the semilithotomy group, and surgery time was longer in the supine position group. There was no difference according to total time, surgical time, TAD, CDA difference (∆ CDA), postoperative posterior sag, medial cortical support and Baumgardner reduction quality criteria. Target lag screw placement is superior in supine and semilithotomy group than lateral decubitus. CONCLUSION: This study concluded that there was a difference in preparation time, surgery time and optimal lag screw placement in the lateral plane between groups. The surgeon may prefer all three methods according to patient benefit and surgeon familiarity.

Variations of cross-sectional meniscal morphology between similar-sized menisci: implications on donor selection for meniscal allograft transplantation.

PURPOSE: This study aimed to investigate the morphological variations in the cross-sectional anatomy of the meniscus between similar-sized matched menisci. MATERIALS AND METHODS: Knee MRI of 329 patients with intact menisci were retrospectively reviewed, and the meniscal length (ML), meniscal width (MW), and cross-sectional dimensions (meniscal height and width) of the anterior, posterior horns, and the corpus were measured. Patients with similar-sized menisci who had less than 1 mm difference in ML and MW were matched. 330 male-to-male medial menisci (MM), 623 male-to-male lateral menisci (LM), 82 female-to-female MM, 233 female-to-female LM, 176 cross-gender MM, and 265 cross-gender LM unique combination of ideally matched pairs (total: 1709) were generated. The disparity in the cross-sectional dimensions, absolute difference, and the paired percent differences was statistically analyzed. RESULTS: The ML and MW in all groups were statistically similar, with a predefined absolute difference of 1 mm both for ML and MW (paired percent difference < 5%). The cross-sectional segmental meniscal dimensions were similar within all groups, but the paired percent differences showed high variations between a mean of 12.1-21.5% and up to 150.9%. The paired percent difference of MM in each segmental dimension was similar among different gender combinations. However, segmental paired percent differences of LM showed statistical differences in anterior horn width (AHW) (p: 0.001) and posterior horn width (PHW) (p: 0.001). In subgroup comparisons, the paired percent difference of AHW was higher in the female-to-female group compared to cross-gender (p: 0.023) and male-to-male groups (p: 0.001). The paired percent difference of PHW was smaller in the male-to-male group compared to female-to-female and cross-gender groups (p: 0.001 for both). CONCLUSIONS: Segmental cross-sectional anatomy showed wide variations despite strict matching in ML and MW. These variations were present in all gender combinations. The meniscal 3D shape is unique, but acceptable limits of similarity need further research. LEVEL OF EVIDENCE: Retrospective study, Level III.

Is There a Role of Meniscal Morphology in the Risk of Noncontact Anterior Cruciate Ligament Rupture? A Case-Control Study.

The purpose of this study was to identify the anatomical risk factors and determine the role of meniscal morphology in noncontact anterior cruciate ligament (ACL) rupture. A total of 126 patients (63 with noncontact ACL rupture and 63 age- and sex-matched controls) with intact menisci were included in this retrospective case-control study. On knee magnetic resonance imaging (MRI), meniscal morphometry (anterior, corpus, and posterior heights and widths of each meniscus), tibial slope (medial and lateral separately), notch width index, roof inclination angle, anteromedial bony ridge, tibial eminence area, and Q-angle measurements were assessed. The data were analyzed using multiple regression analyses to identify independent risk factors associated with ACL rupture. Using a univariate analysis, medial and lateral menisci anterior horn heights (p < 0.001; p < 0.003), medial and lateral menisci posterior horn heights (p < 0.001; p < 0.001), lateral meniscus corpus width (p < 0.004), and notch width index (p < 0.001) were significantly higher in the control group. Lateral tibial slope (p < 0.001) and anteromedial bony ridge thickness (p < 0.001) were significantly higher in the ACL rupture group. Multivariate analysis revealed that decreased medial meniscus posterior horn height (odds ratio [OR]: 0.242; p < 0.001), increased lateral meniscus corpus width (OR: 2.118; p < 0.002), increased lateral tibial slope (OR: 1.95; p < 0.001), and decreased notch width index (OR: 0.071; p = 0.046) were independent risk factors for ACL rupture. Notch stenosis, increased lateral tibial slope, decreased medial meniscus posterior horn height, and increased lateral meniscus corpus width are independent anatomical risk factors for ACL rupture. Meniscal morphological variations also play a role in ACL injury. This is a Level III, retrospective case-control study.

Radiographic analysis of anatomic risk factors for scaphoid fractures; A case-control study.

AIM: The purpose of this study was to investigate the role of anatomic variations in distal radius radiographic indices in patients with or without scaphoid fractures. MATERIALS AND METHODS: Radial inclination (RI), volar tilt (VT), radial height (RH) and ulnar variance (UV) were measured on wrist radiographs of 320 patients with (Group I, n = 167) or without (Group II, n = 153) scaphoid fracture, fall on outstretched hand (FOOSH). Receiver operating characteristics (ROC) curve analysis was used to assess the diagnostic performance for each variable. Sensitivity (Sn), specificity (Sp), cutoff value, and area under the ROC curve were analyzed. Odds ratio was calculated for defined cutoff values. RESULTS: The mean age of the groups was similar (29.3 ±â€¯10.2 vs 31.1 ±â€¯9.9 years, p = 0.060). RI (30.0 ±â€¯2.9 vs 26.8 ±â€¯2.3°) VT (11.4 ±â€¯2.4 vs 10.5 ±â€¯2.2°), RH (14.8 ±â€¯2.1 vs 13.2 ±â€¯1.9 mm), UV (-0.46 ±â€¯1.7 vs 0.00 ±â€¯1.5 mm) were higher in scaphoid fracture group (Gr I vs Gr II, p = 0.000, p = 0.000, p = 0.001, p = 0.012 respectively). Ulna minus variant was more prevalent in fracture group (p = 0.001). Optimal cutoff points for RI, VT, RH and UV in differentiating fractured and intact scaphoid were 28.6° (Sn = 81.0%, Sp = 26.3%), 12.2° (Sn = 80.4%, Sp = 67.1%), 14.85 mm (Sn = 80.4%, Sp = 52.1%) and 0 mm (Sn = 88.6%, Sp = 75.8%), respectively. Odds ratios for defined cutoff points for RI, VT, RH and UV were 10.4 (95% CI, 6.2-17.4), 1.8 (95% CI, 1.1-3.0), 3.7 (95% CI, 2.3-6.2) and 2.2 (95% CI, 1.3-3.7) respectively. CONCLUSION: Increased RI, VT, RH and negative UV were found to be predisposing anatomical risk factors for scaphoid fracture when FOOSH.

Fixation of Small Osteochondral Fragments in a Comminuted Distal Humerus Fracture with Magnesium Bioabsorbable Screws: A Case Report.

The treatment of comminuted distal humeral fractures with free osteochondral fragments is challenging. Osteochondral fragments should be retained whenever possible and secured with implants buried beneath the articular surface to obtain a uniform articular surface. Headless compression screws and K wires are commonly used for this purpose. However, certain complications have been reported with these fixation implants in case of the non-union and osteolysis of the fragments such as migration and cartilage damage. Fixation of osteochondral fractures in distal humeral fractures using bioabsorbable implants has been rarely reported in the current literature. Herein, a patient who sustained a comminuted distal humeral fracture with multi-fragmentary osteochondral fragments is presented, and treatment with magnesium bioabsorbable compression screws is discussed.

Intraarticular Entrapment of Os Subfibulare Following a Severe Inversion Injury of the Ankle: A Case Report.

INTRODUCTION: Anterior Talofibular Ligament (ATFL) rupture is the most commonly injured anatomic structure in lateral ankle sprain. In some cases, ATFL avulsion fracture from the lateral malleolus may occur instead of purely ligamentous injuries. The ATFL avulsion fracture is detected as a small ossicle at the tip of lateral malleolus on direct radiographs, which is called os subfibulare in chronic cases. CASE PRESENTATION: Severe displacement of this ossicle to the tibiotalar joint space is an extremely rare injury. Herein, a case of intra-articular entrapment of os subfibulare following a severe inversion injury of the ankle, which caused a diagnostic challenge was presented. CONCLUSIONS: To the best of our knowledge, this is the first case of entrapment of os subfibulare in the talotibial joint space. Fixation of the os subfibulare to lateral malleolus resulted in union and excellent functional results.