RESUMEN
Total adenosine triphosphate (tATP) was investigated for its potential as a rapid indicator of cyanobacterial growth and algaecide effectiveness. tATP and other common bloom monitoring parameters were measured over the growth cycles of cyanobacteria and green algae in laboratory cultures and examined at a drinking water source during an active bloom. Strong correlations (R2>0.78) were observed between tATP and chlorophyll-a in cyanobacteria cultures. tATP offered greater sensitivity by increasing two orders of magnitude approximately 7 d before changes in chlorophyll-a or optical density were observed in Lyngbya sp. and Dolichospermum sp. cultures. Increases in tATP per cell coincided with the onset of exponential growth phases in lab cultures and increase in cell abundance in field samples, suggesting that ATP/cell is a sensitive indicator that may be used to identify the development of blooms. Bench-scale trials using samples harvested during a bloom showed that tATP exhibited a clear dose-response during copper sulfate (CuSO4) and hydrogen peroxide (H2O2) treatment compared to chlorophyll-a and cell counts, indicating that cellular production and storage of ATP decreases even when live and dead cells cannot be distinguished. During Copper (Cu) algaecide application at a reservoir used as a drinking water source, tATP and cell counts decreased following initial algaecide application; however, the bloom rebounded within 10 d showing that the Cu algaecide only has limited effectiveness. In this case, tATP was a sensitive indicator to bloom rebounding after algaecide treatments and correlated positively with cell counts (R2=0.7). These results support the use of tATP as a valuable complementary bloom monitoring tool for drinking water utilities to implement during the monitoring and treatment of cyanobacterial blooms.
RESUMEN
Biofilms that colonize on the surface of microplastics (MPs) in freshwaters may pose a potential health risk. This study examined factors that influence MP-associated biofilm growth, including polymer type, degree of weathering, and source water quality. Weathered MPs produced in-lab were employed in biofilm trials conducted on site using a passive flow-through system with raw water at drinking water treatment facility intakes. Adenosine triphosphate (ATP) was used to quantify biofilm abundance; biofilm composition was assessed via metagenomic sequencing. Biofilm growth was observed on all polymer types examined and most prevalent on polyvinyl chloride (PVC), where ATP levels were 6 to 12 times higher when compared to other polymers. Pathogen-containing species including Salmonella enterica and Escherichia coli were present on all polymers with relative abundance up to 13.7%. S. enterica was selectively enriched on weathered MPs in specific water matrices. These findings support the need to research the potential accumulation of pathogenic organisms on microplastic surfaces.
