The Hydrothermal-Assisted Approach Improves the Photocatalytic and Energy Storage Performance of Novel CuSe-TiO2-GO Composite.

This study reports a novel CuSe-TiO2-GO composite, synthesized by a facile hydrothermal method at a controlled temperature, and investigates its electrochemical performance for supercapacitors (SCs) and photocatalytic behavior for degrading methylene blue (MB) dye. The compositional phase structure and chemical bond interaction were thoroughly investigated. The as-fabricated pristine, binary, and ternary composites underwent comprehensive characterization employing spectroscopic techniques and electrochemical analysis. Compared with pure and binary compounds (CuSe, TiO2, and binary CuSe-TiO2 composites), the ternary CuSe-TiO2-GO composites demonstrated a high degradation efficiency while degrading MB in less than just 80 min (240 min, 100 min, and 140 min, respectively). The photocatalytic activity of the ternary CuSe-TiO2-GO composites is enhanced due to the highly positive conduction band of CuSe, leading to the quick excitation of electrons to the conduction band of CuSe. Subsequently, graphene oxide (GO) left holes on the photocatalyst surface for MB, as GO assisted the photoexcited electron-hole pairs, resulting in enhanced photocatalytic performance. The CuSe-TiO2-GO electrode for the supercapacitor indicates a 310.6 F/g and 135.2 F/g capacitance when the discharge current upsurges from 1 to 12 A/g. The good photocatalytic and energy storage performance is due to the smaller charge transfer resistance, which promotes efficient separation of electron-hole pairs.

Phytoassisted synthesis of CuO and Ag-CuO nanocomposite, characterization, chemical sensing of ammonia, degradation of methylene blue.

The elimination of hazardous industrial pollutants from aqueous solutions is an emerging area of scientific research and a worldwide problem. An efficient catalyst, Ag-CuO was synthesized for the degradation of methylene blue, the chemical sensing of ammonia. A simple novel synthetic method was reported in which new plant material Capparis decidua was used for the reduction and stabilization of the synthesized nanocatalyst. A Varying amount of Ag was doped into CuO to optimize the best catalyst that met the required objectives. Through this, the Ag-CuO nanocomposite was characterized by XRD, SEM, HR-TEM, EDX, and FTIR techniques. The mechanism of increased catalytic activity with Ag doping involves the formation of charge sink and suppression of drop back probability of charge from conduction to valance band. Herein, 2.7 mol % Ag-CuO exhibited better catalytic activities and it was used through subsequent catalytic experiments. The experimental conditions such as pH, catalyst dose, analyte initial concentration, and contact time were optimized. The as-synthesized nanocomposite demonstrates an excellent degradation efficacy of MB which is 97% at pH 9. More interestingly, the as-synthesized catalyst was successfully applied for the chemical sensing of ammonia even at very low concentrations. The lower limit of detection (LLOD) also called analytic sensitivity was calculated for ammonia sensing and found to be 1.37 ppm.

The construction of novel CuO/SnO2@g-C3N4 photocatalyst for efficient degradation of ciprofloxacin, methylene blue and photoinhibition of bacteria through efficient production of reactive oxygen species.

Water pollution due to organic waste and various microorganisms cause severe health problems. Numbers of techniques are used to eliminate organic waste and microorganisms from water because water pollution is a substantial issue in the current era. In the present study, sustainable and effective CuO/SnO2@g-C3N4 nanocomposites were prepared via green and chemical approach. The photo degradation of ciprofloxacin (CIP) and methylene blue (MB) by the green synthesized nanocomposite were tested. Visible and dark conditions both were used to conduct this test. The results showed that the nanocomposite is much more effective in light than in dark conditions. The synthesized nanocomposite was also tested both in light and dark against highly drug resistant microorganisms' Bacillus subtilis (B.subtilis) and Escherichia coli (E.coli). As a result, the antibacterial evaluation revealed substantial antibacterial activity in the presence of light, with a zone of inhibition covering an area of 19 (±0.5) mm and 20 (±0.1) mm, respectively, against gram negative and gram positive bacteria such as E. coli and B. subtilis. The results showed that the CuO/SnO2@g-C3N4 nanocomposite is a stable, eco-friendly photocatalyst with significant resistance to CIP and MB degradation and a substantial inhibitory effect towards microorganisms in visible light.

Rapid photodegradation of toxic organic compounds and photo inhibition of bacteria in the presence of novel hydrothermally synthesized Ag/Mn-ZnO nanomaterial.

Purified water is the most concerning issue these days, and utmost conventional practices are allied with various downsides. Therefore, an ecologically benign and easily amicable therapeutic approach is the requirement. In this wonder, nanometer phenomena bring an innovative change to the material world. It has the potential to produce nanosized materials for wide-ranging applications. The subsequent research highlights the synthesis of Ag/Mn-ZnO nanomaterial via a one-pot hydrothermal route with an efficient photocatalytic activity against organic dyes and bacteria. The outcomes revealed that the size of the particle (4-5 nm) and dispersion of spherically shaped silver nanoparticles intensely affected by employing Mn-ZnO as a support material. Use of silver NPs as a dopant activates the active sites of the support medium and provides a higher surface area to upsurge the degradation rate. The synthesized nanomaterial was evaluated against photocatalytic activity using Methyl orange and alizarin red as model dyes and confided that more than 70% of both the dyes degraded under 100 min duration. It is well recognize that the modified nanomaterial recreates an essential role in every light-based reaction, and virtually produced highly reactive oxygen species. The synthesized nanomaterial was also evaluated against E. coli bacterium both in light and dark. The zone of inhibition in the presence of Ag/Mn-ZnO was observed both in light (18 ± 0.2 mm) and dark (12 ± 0.4 mm). The hemolytic activity shows that Ag/Mn-ZnO has very low toxicity. Hence, the prepared Ag/Mn-ZnO nanomaterial might be an effective tool against the depletion of further harmful environmental pollutants and microbes.

Correlation between Magnetic and Dielectric Response of CoFe2O4:Li1+/Zn2+ Nanopowders Having Improved Structural and Morphological Properties.

The vast applicability of spinel cobalt ferrite due to its unique characteristics implies the need for further exploration of its properties. In this regard, structural modification at the O-site of spinel with Li1+/Zn2+ was studied in detail for exploration of the correlation between structural, magnetic, and dielectric properties of the doped derivatives. The CTAB-assisted coprecipitation method was adopted for the synthesis of the desired compositions owing to its cost effectiveness and size controlling ability. Redistribution of cations at T- and O-sites resulted in the expansion of the crystal lattice, but no distortion of the cubic structure was observed, which further supports the flexible crystal structure of spinel for accommodating larger Li1+/Zn2+ cations. Moreover, an XPS analysis confirmed the co-existence of the most stable oxidation states of Zn2+, Li1+, Co2+, and Fe3+ ions with unstable Co3+ and Fe2+ ions as well, which induces the probability of hopping mechanisms to a certain extent and is a well-established behavior of cobalt ferrite nanoparticles. The experimental results showed that Li1+/Zn2+ co-doped samples exhibit the best magnetic properties at dopant concentration x = 0.3. However, increasing the dopant content causes disturbance at both sites, resulting in decreasing magnetic parameters. It is quite evident from the results that dielectric parameters are closely associated with each other. Therefore, dopant content at x = 0.1 is considered the threshold value exhibiting the highest dielectric parameters, whereas any further increase would result in decreasing the dielectric parameters. The reduced dielectric properties and enhanced magnetic properties make the investigated samples a potential candidate for magnetic recording devices.

A membrane-free cation selective water-gated transistor.

Sensors for the detection of waterborne cations are of great practical interest, and chemistry has synthesised a formidable catalogue of cation selective complexation agents ('ionophores') as selective sensitisers. Current ionophore-based sensors separate the complexation of the cation by the ionophore, and the transduction of complexation into an electrical signal, into separate components. We here unite both functions into a single, sensitised semiconducting layer of a water-gated organic thin film transistor (OTFT). The resulting OTFT transduces waterborne cations into an electrical signal with same selectivity, sensitivity, and limit of detection as established sensors at much simplified preparation and operation. This opens a new route to apply the 'ionophore' family of functional organic materials in practical cation sensors.

Innate cation sensitivity in a semiconducting polymer.

Water-gated organic thin film transistors (OTFTs) using the hole transporting semiconducting polymer, poly(2,5-bis(3-hexadecylthiophen-2-yl)thieno[3,2-b]thiophene) (PBTTT), show an innate response of their threshold voltage to the addition of divalent metal cations to the gating water, without deliberately introducing an ion-sensitive component. A similar threshold response is shown for several divalent cations, but is absent for monovalent cations. Response is absent for transistors using the inorganic semiconductor ZnO, or the similar organic semiconductor poly(3-hexylthiophene) (rrP3HT), instead of PBTTT. We assign innate cation sensitivity to residues of the organometallic Pd(0) complex used as catalyst in PBTTT synthesis which bears strong resemblance to typical metal chelating agents. Organometallic Pd(0) residues are absent from ZnO, and also from rrP3HT which is polymerised with a different type of catalyst. However, when Pd(0) complex is deliberately added to rrP3HT casting solutions, resulting OTFTs also display threshold response to a divalent cation.

A water-gated organic thin film transistor as a sensor for water-borne amines.

The p-type semiconducting polymer Poly(2,5-bis(3-hexadecylthiophen-2-yl)thieno[3,2-b]thiophene) (PBTTT) displays innate sensitivity to water-borne amines. We demonstrate this with the help of water-gated PBTTT thin film transistors (TFTs). When octylamine is added to the gating water, TFTs respond with a significantly reduced saturated drain current. Underlying TFT drift is minimised by initial conditioning, and remaining drift can be accounted for by normalising current response to the current level under purge immediately before exposure. Normalised current response vs. amine concentration is reproducible between different transistors, and can be modelled by a Langmuir surface adsorption isotherm, which suggests physisorption of analyte at the PBTTT surface, rather than bulk penetration. Same PBTTT transistors do not respond to 1- octanol, confirming the specific affinity between amines and thiophene- based organic semiconductors.

Precursor-route ZnO films from a mixed casting solvent for high performance aqueous electrolyte-gated transistors.

We significantly improved the performance of precursor-route semiconducting zinc oxide (ZnO) films in electrolyte-gated thin film transistors (TFTs). We find that the organic precursor to ZnO, zinc acetate (ZnAc), dissolves more readily in a 1 : 1 mixture of ethanol (EtOH) and acetone than in pure EtOH, pure acetone, or pure isopropanol. XPS and SEM characterisation show improved morphology of ZnO films converted from a mixed solvent cast ZnAc precursor compared to the EtOH cast precursor. When gated with a biocompatible electrolyte, phosphate buffered saline (PBS), ZnO thin film transistors (TFTs) derived from mixed solvent cast ZnAc give 4 times larger field effect current than similar films derived from ZnAc cast from pure EtOH. The sheet resistance at VG = VD = 1 V is 30 kΩ â–¡(-1), lower than for any organic TFT, and lower than for any electrolyte-gated ZnO TFT reported to date.