RESUMEN
Terminalia argentea tree, native to Brazil, is widely used in landscaping, recovering degraded areas, its wood, coal production, and the bark or leaf extracts has medicinal use. Despite of its importance, the arthropod fauna associated to this plant and its interspecific relationships still needs further studies. The objectives of this study were to evaluate the arthropods, their ecological indices and the distribution in the leaf faces on T. argentea saplings. The numbers of phytophagous insects (e.g., Cephalocoema sp.), pollinators (e.g., Tetragonisca angustula), and natural enemies (e.g., Oxyopidae), and their ecological indices (e.g., species richness), were higher on the adaxial leaf faces on T. argentea saplings. Aggregated distribution of phytophagous insects (e.g., Aphis spiraecola), pollinators (e.g., Trigona spinipes), and natural enemies (e.g., Camponotus sp.) on T. argentea saplings was observed. Abundance, diversity, and species richness of natural enemies correlated, positively, with those of phytophagous and pollinators insects. Predators and tending ants followed their prey and sucking insects, respectively. Tending ants protected sucking insects against predators, and reduced chewing insects. The high number of Cephalocoema sp. on T. argentea saplings is a problem, because this insect can feed on leaves of this plant, but its preference for the adaxial leaf face favors its control. The aggregation behavior of arthropods on T. argentea saplings favors the control of potential pests of this plant. There seems to be competition between tending ants for space and food resources on T. argentea saplings.
Asunto(s)
Artrópodos , Hojas de la Planta , Terminalia , Animales , Hojas de la Planta/parasitología , Artrópodos/clasificación , Artrópodos/fisiología , Terminalia/clasificación , Densidad de Población , Biodiversidad , Brasil , Insectos/clasificación , Insectos/fisiologíaRESUMEN
The purpose was to evaluate the influence of dentin pretreatment with titanium tetrafluoride (TiF4) on the longevity of bond strength (BS) of an indirect composite to dentin, using conventional resin cementation strategy or a self-adhesive resin cement. Forty third human molars with exposed dentin surfaces were used. The teeth were divided into groups (n = 10), according to the cementation strategy and the presence or absence of pretreatment with TiF4. Microtensile strength testing and failure mode analysis were performed after 24 hours, 180 and 360 days of storage in water. Split-plot ANOVA and Tukey's test showed that BS was significantly higher when the conventional strategy was used, regardless of the time period, and of the application or no application of pretreatment with TiF4 (p ⟨0.0001). When TiF4 was used for both cementing strategies, BS was lower after 360 days (p = 0.0019). Both cementing strategies led to the formation of a shallow hybrid layer, regardless of the presence of TiF4. BS was higher when the conventional cementation strategy was used, regardless of TiF4 pretreatment. TiF4 used as a pretreatment agent associated with different types of resin cementation was unable to maintain adhesive bond strength in the long term.
Asunto(s)
Cementación , Recubrimiento Dental Adhesivo , Cementos Dentales , Fluoruros , Cementos de Resina , Titanio , Resinas Compuestas , Análisis del Estrés Dental , Dentina , Recubrimientos Dentinarios , Humanos , Ensayo de Materiales , Resistencia a la TracciónRESUMEN
The aim of this study was to evaluate the effect of a chlorhexidine and/or ethanol application on the bond strength of an etch-and-rinse, hydrophobic adhesive system either under in vitro aging or in situ cariogenic challenge. The dentin surface of 36 human third molars were flattened and allocated into four groups to be treated with chlorhexidine, ethanol, or chlorhexidine + ethanol or left unexposed to any solution (control) (n=9). Then, a resin composite restoration was made on the dentin surface and longitudinal sticks were obtained. Sticks from each tooth were assigned to three test conditions: stored in water in vitro for 24 hours, stored in water in vitro for 6 months, or worn in situ for 14 days. During in situ wear time, a high-cariogenic challenge condition was simulated. Specimens were tested for microtensile bond strength (µTBS). Multivariate analysis of variance and Tukey's test showed that chlorhexidine, ethanol, or chlorhexidine + ethanol did not affect the µTBS. The in vitro µTBS values were significantly lower for the specimens stored for 6 months than for those stored for 24 hours. Intermediate µTBS values were shown by the specimens worn in situ. Thus, use of chlorhexidine and/or ethanol was incapable of containing the degradation at the bond interface in the in vitro model. The in situ model was capable of reducing bond strength similarly to the in vitro/6 months model. Despite this, the in situ bond strength was still similar to that of the in vitro/24-hour model.
Asunto(s)
Clorhexidina/farmacología , Cementos Dentales/metabolismo , Grabado Dental/métodos , Dentina/efectos de los fármacos , Etanol/farmacología , Resinas Compuestas/uso terapéutico , Recubrimiento Dental Adhesivo , Análisis del Estrés Dental , Humanos , Técnicas In VitroRESUMEN
The aim of this study was to compare the effectiveness of and tooth sensitivity to 10% and 20% carbamide peroxide (CP) home-use bleaching agents and 35% and 38% hydrogen peroxide (HP) in-office bleaching agents, all of which contain desensitizing agents, in a clinical trial. Four agents were evaluated: 10% CP and 20% CP (Opalescence PF 10% and Opalescence PF 20%, Ultradent, both with 0.5% potassium nitrate and 0.11% fluoride ions), 38% HP (Opalescence Boost PF, Ultradent, with 3% potassium nitrate and 1.1% fluoride ions), and 35% HP (Pola Office, SDI, with potassium nitrate). The initial screening procedure included 100 volunteers, aged 18 to 42, with no previous sensitivity or bleaching treatment and with any tooth shade. Volunteers were randomly assigned among the technique/bleaching agent groups. A run-in period was performed 1 week before the beginning of the bleaching treatment. For the home-use bleaching technique, each volunteer was instructed to dispense gel (10% CP or 20% CP) into the trays and then insert them into his or her mouth for at least two hours per night for three weeks. For the in-office bleaching technique, the bleaching agents (38% HP or 35% HP) were prepared and used following the manufacturer's instructions, with three applications performed in each session. Three sessions were carried out with an interval of seven days between each session. The participants were evaluated before, at one week, two weeks, and three weeks after the beginning of the bleaching treatment, and again one and two weeks after the bleaching treatment ended. A shade guide (Vita Classical, Vita) was used by a blinded examiner to perform shade evaluations before bleaching and two weeks after the end of bleaching. At the time of the shade evaluations, tooth sensitivity was also recorded by asking the volunteers to classify the sensitivity during bleaching treatment as absent, mild, moderate, or severe. The present study found that 13.8% of the volunteers withdrew from the study due to tooth sensitivity, and 43.2% of the participants experienced some type of sensitivity during bleaching treatment. The χ(2) test showed that there was a significant prevalence of tooth sensitivity during bleaching treatment using the home-use 20% CP agent, with 71.4% of volunteers reporting any level of tooth sensitivity (p=0.0032). A low prevalence of tooth sensitivity was observed for volunteers who used the in-office 38% HP agent (15.0%). The Wilcoxon test (p<0.05) showed that all of the bleaching treatments were effective in bleaching teeth and that there were no differences between the final color shade results among the treatments (Kruskal-Wallis, p<0.05). This study showed that 43.2% of all the volunteers experienced mild or moderate tooth sensitivity during the treatment with bleaching agents. A higher prevalence of tooth sensitivity was observed for 71.4% of the volunteers who used the 20% CP home-use bleaching agent, which may be ascribed to the peroxide concentration and/or the time/length the agent was in contact with the dental structures.
Asunto(s)
Desensibilizantes Dentinarios/administración & dosificación , Sensibilidad de la Dentina/inducido químicamente , Peróxido de Hidrógeno/administración & dosificación , Peróxidos/administración & dosificación , Blanqueadores Dentales/administración & dosificación , Blanqueamiento de Dientes/métodos , Urea/análogos & derivados , Adolescente , Adulto , Peróxido de Carbamida , Color , Fluoruros/administración & dosificación , Estudios de Seguimiento , Humanos , Peróxido de Hidrógeno/efectos adversos , Nitratos/administración & dosificación , Peróxidos/efectos adversos , Compuestos de Potasio/administración & dosificación , Diente/efectos de los fármacos , Diente/patología , Blanqueadores Dentales/efectos adversos , Decoloración de Dientes/tratamiento farmacológico , Decoloración de Dientes/patología , Resultado del Tratamiento , Urea/administración & dosificación , Urea/efectos adversos , Adulto JovenRESUMEN
This study sought to evaluate the influence of thermocycling and water storage on the microtensile bond strength of composite resin bonded to erbium:yttrium-aluminum-garnet (Er:YAG)-irradiated and bur-prepared enamel. Eighty bovine incisors were selected and sectioned. Specimens were ground to produce a flat enamel surface. Samples were randomly assigned according to cavity preparation device: (I) Er:YAG laser and (II) high-speed turbine, and were subsequently restored with composite resin. They were subdivided according to the duration of water storage (WS)/number of thermocycles (TCs): 24 h WS/no TCs; 7 days WS/500 TCs; 1 month WS/2,000 TCs; 6 months WS/12,000 TCs. The teeth were sectioned into 1.0 mm(2)-thick slabs and subjected to tensile stress in a universal testing machine. Data were submitted to two-way analysis of variance (ANOVA) and Tukey's test at a 0.05 significance level. The different periods of water storage and thermocycling did not influence the microtensile bond strength (microTBS) values in the Er:YAG laser-prepared groups. In bur-prepared enamel, the group submitted to 12,000 TCs/6 months' WS (IID) showed a significant decrease in bond strength values when compared to the group stored in water for 24 h and not submitted to thermocycling (IIA), but values were statistically similar to those obtained in all Er:YAG laser groups and in the bur- prepared groups degraded with 500 TCs/1 week WS (IIB) or 2,000 TCs/1 month WS (IIC). It may be concluded that adhesion of an etch-and-rinse adhesive to Er:YAG laser-irradiated enamel was not affected by the methods used to simulate degradation of the adhesive interface and was similar to adhesion in the bur-prepared groups in all periods of water storage and thermocycling.