RESUMEN
In this study, as a product from the efficient Achmatowicz rearrangement and mild subsequent hydrogenation-reduction reactions of biorenewable C5 alcohols derived from lignocellulose, pentane-1,2,5-triol was successfully used after oxypropylation in the preparation of rigid polyurethane foams-one of the most important classes of polymeric materials. Despite the broad range of applications, the production of polyurethanes is still highly dependent on petrochemical materials considering the need of renewable raw materials and new process technologies for the production of polyol or isocyanate components as a key point for the sustainable development of polyurethane foams. The synthesized oxypropylated pentane-1,2,5-triol was analyzed using proton NMR spectroscopy, hydroxyl number, and viscosity, whereas the newly obtained foams incorporated with up to 30% biorenewable polyol were characterized using compressive stress, thermogravimetry, dynamic mechanical analysis, and scanning electron microscopy. The modified rigid polyurethanes showed better compressive strength (>400.0 kPa), a comparable thermal degradation range at 325-450 °C, and similar morphological properties to those of commercial polyurethane formulations.
RESUMEN
The authors would like to correct a mistake in Figure 3 as published in the original publication [...].
RESUMEN
In this study, some crucial parameters were determined of flexible polymer-organic solar cells prepared from an active layer blend of poly(3-hexylthiophene) (P3HT) and the fullerene derivative [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) mixed in 1:1 mass ratio and deposited from chlorobenzene solution by spin-coating on poly(ethylene terephthalate) (PET)/ITO substrates. Additionally, the positive effect of an electron transport layer (ETL) prepared from zinc oxide nanoparticles (ZnO np) on flexible photovoltaic elements' performance and stability was investigated. Test devices with above normal architecture and silver back electrodes deposed by magnetron sputtering were constructed under environmental conditions. They were characterized by current-voltage (I-V) measurements, quantum efficiency, impedance spectroscopy, surface morphology, and time-degradation experiments. The control over morphology of active layer thin film was achieved by post-deposition thermal treatment at temperatures of 110-120 °C, which led to optimization of device morphology and electrical parameters. The impedance spectroscopy results of flexible photovoltaic elements were fitted using two R||CPE circuits in series. Polymer-organic solar cells prepared on plastic substrates showed comparable current-voltage characteristics and structural properties but need further device stability improvement according to traditionally constructed cells on glass substrates.
