RESUMEN
Introduction: Although kissing spine syndrome in the lumbar spinal region is a relatively common condition in older adults, no study examining its biomechanical characteristics has been reported. We hypothesized that kissing of the spinous processes during extension causes an increase in the flexural rigidity of the spine and significantly limits the deformation behavior of extension, which in turn might cause lower back pain. Methods: Three test models (human cadavers A, B, and C) were prepared by removing supraspinal/interspinous ligaments between L4 and L5. The dental resin was attached to the cephalocaudal spinous process so that the spinous processes between L4 and L5 were almost in contact with each other to simulate the condition of a kissing spine. The flexion-extension direction's torque-range-of-motion (torque-ROM) curve was generated with a six-axis material tester for biomechanical measurements. Results: In all three models, the maximum ROMs at the time of extension were smaller than those at the time of flexion, and no sudden increase in torque was observed during extension. Conclusion: The results indicated no apparent biomechanical effects of kissing between the spinous processes, suggesting that the contact between the spinous processes has little involvement in the onset of lower back pain.
RESUMEN
Background Many studies have been conducted on the biomechanics of the spine to elucidate the fixation properties of spinal fusion surgery and the causes of instrumentation failure. Among these studies, there are some studies on load sharing in the spine and measurement using strain gauges and pressure gauges, but there is a lack of research on axial compressive loads. Methods Axial compressive load tests were performed on human cadaveric injured lumbar vertebrae fixed with pedicle screws (PS). Both the strain generated in the PS rod and the intradiscal pressure were measured. Subsequently, the stress generated in the PS rod and the load sharing of the spine and instrumentation were calculated. Results Even when only compressive load is applied, bending stress of more than 10 times the compression stress was generated in the rod, and the stress tended to concentrate on one rod. Rod deformation becomes kyphotic, in contrast to the lordotic deformation behavior of the lumbar spine. The stress shielding rate was approximately 40%, less than half. Conclusions This study obtained basic data useful for constructing and verifying numerical simulations that are effective for predicting and elucidating the causes of dislodgement and failure of spinal implants.
