RESUMEN
The enhancement of heat transfer between parallel surfaces, including parallel plates, parallel disks, and two concentric pipes, is vital because of their wide applications ranging from lubrication systems to water purification processes. Various techniques can be utilized to enhance heat transfer in such systems. Adding nanoparticles to the conventional working fluids is an effective solution that could remarkably enhance the heat transfer rate. No published review article focuses on the recent advances in nanofluid flow between parallel surfaces; therefore, the present paper aims to review the latest experimental and numerical studies on the flow and heat transfer of nanofluids (mixtures of nanoparticles and conventional working fluids) in such configurations. For the performance analysis of thermal systems composed of parallel surfaces and operating with nanofluids, it is necessary to know the physical phenomena and parameters that influence the flow and heat transfer characteristics in these systems. Significant results obtained from this review indicate that, in most cases, the heat transfer rate between parallel surfaces is enhanced with an increase in the Rayleigh number, the Reynolds number, the magnetic number, and Brownian motion. On the other hand, an increase in thermophoresis parameter, as well as flow parameters, including the Eckert number, buoyancy ratio, Hartmann number, and Lewis number, leads to heat transfer rate reduction.
RESUMEN
This paper reviews the application of conventional and hybrid nano cutting fluids with different additives in various machining processes, namely turning, milling, drilling, and grinding ones. The literature states that using nanofluids, as cutting fluids, improves the lubrication and cooling in comparison with conventional cutting liquids, while the level of improvement depends on some parameters. In turning process, for each nanofluid, there is a specific pressure, flow rate, and nanoparticle volume fraction to reach optimum performance. Nanoparticle concentration in the range of 0.25%-0.5% (low and economical concentrations) is the most repetitive for optimal case in most of machining processes. Also, hybrid nanofluids show more positive effects compared with conventional nanofluids and base fluids. According to the reports, important parameters such as cutting temperature, cutting force, tool wear, and surface roughness experience 10%-40% and in some cases 50%-70% positive change after applying nanoparticles in turning processes. On the other hand, for the milling process, the SiO2, MoS2 and graphene nanoparticles are reported as most applied and effective ones in the literature. For the drilling process, the Cu and diamond nanoparticles are the most applied nanoparticles with positive effect. Moreover, the most utilized nanoparticles for grinding process are MoS2, Al2O3 and diamond families. The corresponding challenges in this field are also examined and directions for future research are recommended.
RESUMEN
Hydrothermal characteristics of a temperature-sensitive magnetic nanofluid between two parallel plates are investigated in the presence of magnetic field produced by one or multiple line dipole(s) using the two-phase mixture model. As the nanofluid reaches the region where the magnetic field is applied, a rotation is developed due to the dependency of magnetization on temperature. This can lead to mixing in the flow and more uniform distribution of temperature due to the disturbance caused in the boundary layer, and consequently, enhancement in convective heat transfer. The results indicate that the disturbance in boundary layer adjacent to the lower wall is more significant than the upper wall. By application of the magnetic field, the convective heat transfer increases locally for both walls. Due to the intensified mixing, a sudden pressure drop occurs when the fluid reaches the region where the magnetic field is applied. For greater magnetic field strengths and lower Reynolds numbers, the improvement in convective heat transfer is more significant. For small magnetic field strengths, the effect of applying magnetic field on the upper wall is much smaller than that on the lower wall; however, this effect becomes almost the same for both walls at great magnetic field strengths.
