[Chemical Spatiotemporal Characteristics and Environmental Driving Factors of Groundwater in Hetao Irrigation Area].

To explore the chemical characteristics and environmental factors of groundwater in the Hetao Irrigation Area of Inner Mongolia, five irrigation fields, including UulanBuh, Jiefangzha, Yongji, Yichang, and Wulat, were selected as the research area. From 72 groundwater observation wells, a total of 216 groundwater samples were collected throughout three typical periods： the end of freeze-thaw （March）, the middle of irrigation （July）, and the end of autumn watering （November）. Comprehensive methods were utilized, such as statistical analysis, Piper three-line diagram, Gibbs diagram, ion ratio, and principal component analysis, to explore the changes in the groundwater chemical environment and the environmental driving factors of groundwater component formation. The groundwater drinking suitability was evaluated using the water quality index （WQI）, and the irrigation suitability was analyzed using the USSL and Wilcox plots. The results indicated that the groundwater in the research areas was generally saline, and the total anion and cation concentrations in each period in ascending order were as follows： late freeze-thaw stage, late autumn irrigation stage, and mid-irrigation stage, with Na+ and Cl- being the major contributing ions. The chemical type of groundwater was dominated by Cl-Na, followed by Cl·SO4-Ca·Mg and a coexistence with SO4-Ca·Mg, HCO3·Cl-Na, HCO3-Na, and HCO3-Ca·Mg. Based on WQI values, the shallow groundwater in Hetao Irrigation District was mainly classified as Class IV and Class V, and the quality was poor in general. According to the USSL diagram and Wilcox diagram, the comprehensive evaluation results showed that the salinity and sodium concentration of shallow groundwater in the irrigation area were generally high. A total of 80.6% of the water samples during the late freeze-thaw period, 76.1% during the mid-irrigation period, and 77.6% during the late autumn irrigation period lacked irrigation suitability. Two major controlling factors of groundwater chemical characteristics were present in the study area, namely, evaporation and rock weathering, and Na+ and Cl- mainly came from the dissolution and cation exchange of salt rocks. Agricultural irrigation and drought were the chief driving factors of groundwater chemical evolution in the Hetao Irrigation Area. The study provides technical support for optimizing agricultural management measures and a theoretical reference for rational utilization of groundwater resources in the Yellow River irrigation area of Inner Mongolia.

Geopolymer bricks prepared by MSWI fly ash and other solid wastes: Moulding pressure and curing method optimisation.

The preparation of geopolymer from alkaline solid waste instead of strong alkali presents the disadvantage of low early strength. However, improving the early mechanical properties of the geopolymer to meet the engineering requirements is challenging. In this paper, the effects of different moulding pressures and curing methods on the properties of red mud-ground granulated blast furnace slag activated by municipal solid waste incineration fly ash (MSWIFA)-carbide slag (CRMG) were studied and evaluated in terms of compressive strength and XRD, FTIR, SEM, and MIP techniques analysis. The results showed that the moulding pressure of 30 MPa could increase the compressive strength at 3 d by 182% and decrease the porosity from 30.28% to 27.38%. These results are attributable to the fact that the moulding pressure causes the particles to be tightly bound and promotes the geopolymerisation reaction. High-temperature (HT) curing could accelerate the hydration reaction and increase the compressive strength at 3 d by 133.7% and 141.6% compared with those obtained by water curing (WC) and room-temperature (RT) curing, respectively. Microscopic analyses showed that HT curing can promote the generation of C-(A)-S-H gel, geopolymer gel and hydrate calcium chloroaluminate (HCC), fill the pores, and increase the structure's compactness. Finally, the proposed method was verified by synthesising geopolymer pavement bricks (GPB), and the compressive strength at 3 d was found to reach 54 MPa under an optimal curing method (moulding pressure of 30 MPa, 90 °C for 12 h). Compared with concrete pavement bricks, GPB presents broad application prospects for saving economic costs and protecting the environment. The results provide a theoretical basis and technical support for the application of CRMG in rapid demoulding projects such as unfired bricks.

The transformation and outcome of traditional cassava starch processing in Guangxi, China.

To improve the resource utilization, reduce the pollution generation, and increase the economic benefits of enterprises, a cleaner process to produce cassava starch was proposed based on potato starch processing, and it was applied to the transformation of a traditional cassava starch processing factory in the Guangxi Province in China. The transformation involves the implementation of several new techniques/facilities, including a rasper, horizontal centrifuge, and hydrocyclone. Based on the transformation, typical cassava starch factories in Guangxi were evaluated. The results show that, through the application of a series of cleaner techniques/facilities, the starch recovery rate increased to 84.5%. The water consumption, wastewater generation, and chemical oxygen demand generation decreased by 53.8%, 49.0%, and 20.7%, respectively. Based on the cleaner process, the wastewater can be treated to meet the national discharge standard by using common wastewater treatment technology.

Remediation status and practices for contaminated sites in China: survey-based analysis.

This study aims to determine the current remediation status of contaminated sites in China to support future decision-making for the cleanup of contaminated sites. A survey was conducted in which a questionnaire was administered to 76 remediation practitioners working across China. The major driving force behind remediation was the redevelopment of contaminated brownfield land for residential purposes, mostly funded by profit-driven developers, particularly in Beijing. A large proportion of brownfield sites have been contaminated with organic compounds, reflecting past land use by chemical plants. Risk assessments of contaminated sites are typically based on the guidelines from China's Ministry of Ecology and Environment, the United States Environmental Protection Agency, and local governments. The most frequently used criteria to assess site contamination in China are environmental quality standards, screening values, or both. The majority of remediation efforts use low-technology approaches to treat contaminated soil (e.g., cement kiln, in situ and ex situ solidification/stabilization, landfill, and mechanical soil aeration), while sophisticated, high-technology approaches (e.g., in situ and ex situ thermal desorption, in situ chemical treatment, and bioventing) are less often used. The implementation of the latter, while limited, illustrates that the necessary technology exists to support optimal land remediation in China. In addition to high-technology remediation methods, 6W/1H ideology can be employed when assessing contaminated site for remediation. Graphical abstract ᅟ.

Estimation of GHG Emissions from Water Reclamation Plants in Beijing.

A procedure for estimating Greenhouse gas (GHG) emissions from a wastewater reclamation plant in Beijing was developed based on the process chain model. GHG emissions under two typical water reclamation treatment processes, the coagulation-sedimentation-filtration traditional process and advanced biological treatment process, were examined. The total on-site GHG emissions were estimated to be 0.0056 kg/m3 and 0.6765 kg/m3 respectively, while total off-site GHG emissions were estimated to be 0.3699 kg/m3 and 0.4816 kg/m3. The overall GHG emissions were 0.3755 kg/m3 under the type 1 treatment, which is much lower than that under the type 2 of 1.1581 kg/m3. Emissions from both processes were lower than that from the tap water production. Wastewater reclamation and reuse should be promoted as it not only saves the water resources but also can reduce the GHG emissions. Energy consumption was the most significant source of GHG emissions. Biogas recovery should be employed as it can significantly reduce the GHG emissions, especially under the type 2 treatment process. Considering the wastewater treatment and reclamation process as a whole, the type 2 treatment process has advantages in reducing the GHG emissions per unit of pollutant. This paper provides scientific basis for decision making.

Trace Elements in Dominant Species of the Fenghe River, China: Their Relations to Environmental Factors.

The distribution of trace elements (TEs) in water, sediment, riparian soil and dominant plants was investigated in the Fenghe River, Northwestern China. The Fenghe River ecosystem was polluted with Cd, Cr, Hg and Pb. There was a high pollution risk in the midstream and downstream regions and the risk level for Cd was much higher than that of the other elements. The average values of bioconcentration coefficient for Cd and Zn were 2.21 and 1.75, respectively, indicating a large accumulation of Cd and Zn in the studied species. With broad ecological amplitudes, L. Levl. et Vant. Trin., and L. had the greatest TE concentrations in aboveground and belowground biomass of the studied species and were potential biomonitors or phytoremediators for the study area. Multivariate techniques including cluster analysis, correlation analysis, principal component analysis, and canonical correspondence analysis were used to analyze the relations between TE concentrations in plants and various environmental factors. The soil element concentration is the main factor determining the accumulation of TEs in plants. The co-release behavior of common pollutants and TEs drove the accumulation of Hg, Cd, and As in the studied plants. Significant enrichment of some elements in the Fenghe River has led to a decline in the biodiversity of plants.

Regional Variations of Public Perception on Contaminated Industrial Sites in China and Its Influencing Factors.

Public involvement is critical in sustainable contaminated site management. It is important for China to improve public knowledge and participation, foster dialogue between urban managers and laypeople, and accelerate the remediation and redevelopment processes in contaminated site management. In this study, we collected 1812 questionnaires from nine cities around China through face-to-face interviews and statistically analyzed the perception of residents concerning contaminated sites. The results show that respondents' concern about soil pollution was lower than for other environmental issues and their knowledge of soil contamination was limited. The risks posed by contaminated industrial sites were well recognized by respondents, but they were unsatisfied with the performance of local agencies regarding information disclosure, publicity and education and public participation. Respondents believed that local governments and polluters should take the primary responsibility for contaminated site remediation. Most of them were unwilling to pay for contaminated site remediation and preferred recreational or public service redevelopment. Moreover, our research indicated that public perception varied among different cities. This variation was mainly determined by implementations of policy instruments and additionally affected by remediation technology, pollutant type, regional policy response and living distance.

[Land Use Pattern Change and Regional Sustainability Evaluation of Wetland in Jiaogang Lake].

Changes in land use and sustainability evaluation of wetland in Jiaogang Lake from 1995 to 2013 were analyzed, based on the land use change models and an index system, supported by RS, GIS, and social statistical data. The results showed: (1) dry land, paddy field, and building land were the predominant landscape in the study area. The arable land was mainly converted during 1995-2000, which was driven by the extension of agriculture, and the building land increased significantly during 2010-2013, which was driven by the tourism development. (2) Compared to the beginning research area, the building land increased by 123.3%, and the wetland decreased by 23.15%. The land system was at risk for a low proportion of wetland, scarcity of unused land, and the fragmented landscape. (3) The regional sustainability results were bad level, bad level, poor level, good level, and poor level during the different periods, with some room for improvement. (4) The fitness of regional sustainability in study area yielded satisfactory results in 2010, owing to the rapid growth of regional productivity and the regional stability. Since 2010, with the increasing environmental load, the regional sustainability fell down to the poor level. The obstruction of sustainable development is necessary to be addressed in the study area.

A GIS technology based potential eco-risk assessment of metals in urban soils in Beijing, China.

Ecological risks of heavy metals in urban soils were evaluated using Beijing, China as an example. Cadmium, Cu, Zn, Pb, Cr and Ni contents of 233 surface soils sampled by 1 min latitude × 1 min longitude grid were used to identify their spatial distribution patterns and potential emission sources. Throughout the city, longer the duration of urbanization greater was the accumulations of heavy metals especially, Cd, Cu, Pb, and Zn. The soil Zn mainly came from the wears of vehicular tires. Point source emissions of heavy metals were few and far in the downwind south-east quadrant of Beijing. The calculated risk indices showed potential median eco-risks in the ancient central city. No potential high eco-risk due to soil-borne heavy metals was found. The potential medium eco-risk areas in Beijing would expand from the initial 24 to 110 km(2) if soil pH were to reduce by 0.5 units in anticipation.

Uptake of metals by food plants grown on soils 10 years after biosolids application.

Potentially hazardous trace elements such as Cd, Cu, Cr, Ni and Zn are expected to accumulate in biosolids-amended soil and remain in the soil for a long period of time. In this research, uptake of metals by food plants including cabbage, carrot, lettuce and tomato grown on soils 10 years after biosolids application was studied. All the five metals were significantly accumulated in the biosolids-amended soils. The accumulation of metal in soil did not result in significant increase in concentrations of Cu, Cr and Ni in the edible plant tissues. However, the Cd and Zn concentrations of the edible tissues of plants harvested from the biosolids receiving soils were significantly enhanced in comparison with those of the unaffected soils. The plant uptake under Greenfield sandy loam soil was generally higher than those under the Domino clayey loam soil. The metal concentration of edible plant tissue exhibited increasing trends with respect to the concentrations of the ambulated metals. The extents of the increases were plant species dependent. The indigenous soil metals were absorbed by the plants in much higher rates than those of the biosolids-receiving soils. It appeared that the plant uptake of the indigenous soil-borne metal and the added biosolids-borne metals are independent of one another and mathematically are additive.

[Application and development of terrestrial biogeochemical model].

Biogeochemical modeling plays a role as important as experimental measurement in ecosystem research. This paper analyzed the development of biogeochemical model using TEM and DNDC model as cases. Current biogeochemical models were classified according to modeling method, application purpose, element concerned, ecosystem type, and spatial scale. The basic framework (three component: plant, air and soil, and three interface: plantair, plant-soil, and soil-air) and interior fundamental processes (physical, chemical and biological processes) of biogeochemical models were reviewed, and some important problems concerning biogeochemical modeling, such as scale upping, integrating GIS and remote sensing, involved human activity, and comparison study were focused.