RESUMEN
Nanocellulose has gained increasing attention during the past decade, which is related to its unique properties and wide application. In this paper, nanocellulose samples were produced via hydrolysis with ionic liquids (1-ethyl-3-methylimidazole acetate (EmimOAc) and 1-allyl-3-methylimidazolium chloride (AmimCl)) from microcrystalline celluloses (Avicel and Whatman) subjected to enzymatic pretreatment. The obtained material was characterized using Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), dynamic light scattering (DLS), scanning electron microscopy (SEM), and thermogravimetric analysis (TG). The results showed that the nanocellulose had a regular and spherical structure with diameters of 30-40 nm and exhibited lower crystallinity and thermal stability than the material obtained after hydrolysis with Trichoderma reesei enzymes. However, the enzyme-pretreated Avicel had a particle size of about 200 nm and a cellulose II structure. A two-step process involving enzyme pretreatment and hydrolysis with ionic liquids resulted in the production of nanocellulose. Moreover, the particle size of nanocellulose and its structure depend on the ionic liquid used.
RESUMEN
Lignocellulosic biomass, including that of energy crops, can be an alternative source to produce activated carbons (ACs). Miscanthus and switchgrass straw were used to produce ACs in a two-step process. Crushed plant material was carbonized at 600 °C and then obtained carbon was activated using NaOH or KOH at 750 °C. The content of surface oxygen groups was determined using Boehm's method. The porosity of ACs was assayed using the nitrogen adsorption/desorption technique, while their thermal resistance using the thermogravimetric method. The ACs derived from miscanthus and switchgrass were characterized by surfaces rich in chemical groups and a highly developed porous structure. The highest specific surface areas, over 1600 m2/g, were obtained after carbon treatment with NaOH. High values of iodine number, 1200-1240 mg/g, indicate an extensive system of micropores and their good adsorption properties. The type of activator affected the contents of oxygen functional groups and some porosity parameters as well as thermal stability ranges of the ACs. Among obtained carbons, the highest quality was found for these derived from M. sacchariflorus followed by switchgrass, after activation with NaOH. Hence, while these crop species are not as effective biomass sources as other energy grasses, they can become valuable feedstocks for ACs.
RESUMEN
Adsorption of 2,4-dichlorophenoxyacetic acid (2,4-D) and 4-chloro-2-metylphenoxyacetic acid (MCPA) from aqueous solution onto activated carbons derived from various lignocellulosic materials including willow, miscanthus, flax, and hemp shives was investigated. The adsorption kinetic data were analyzed using two kinetic models: the pseudo-first order and pseudo-second order equations. The adsorption kinetics of both herbicides was better represented by the pseudo-second order model. The adsorption isotherms of 2,4-D and MCPA on the activated carbons were analyzed using the Freundlich and Langmuir isotherm models. The equilibrium data followed the Langmuir isotherm. The effect of pH on the adsorption was also studied. The results showed that the activated carbons prepared from the lignocellulosic materials are efficient adsorbents for the removal of 2,4-D and MCPA from aqueous solutions.
