RESUMEN
Future developments in micromanufacturing will require advances in micromanipulation tools. Several robotic micromanipulation methods have been developed to position micro-objects mostly in air and in liquids. The air-water interface is a third medium where objects can be manipulated, offering a good compromise between the two previously mentioned ones. Objects at the interface are not subjected to stick-slip due to dry friction in air and profit from a reduced drag compared with those in water. Here, we present the ThermoBot, a microrobotic platform dedicated to the manipulation of objects placed at the air-water interface. For actuation, ThermoBot uses a laser-induced thermocapillary flow, which arises from the surface stress caused by the temperature gradient at the fluid interface. The actuated objects can reach velocities up to 10 times their body length per second without any on-board actuator. Moreover, the localized nature of the thermocapillary flow enables the simultaneous and independent control of multiple objects, thus paving the way for microassembly operations at the air-water interface. We demonstrate that our setup can be used to direct capillary-based self-assemblies at this interface. We illustrate the ThermoBot's capabilities through three examples: simultaneous control of up to four spheres, control of complex objects in both position and orientation, and directed self-assembly of multiple pieces.
RESUMEN
This paper presents the theoretical and experimental development of an integrated position sensor for lab-on-a-chip devices. The interest for single cell analysis is growing. However, this requires monitoring and controlling cell displacements in real time during their journey in the chip. Due to the high number of cells that must be monitored at the same time, classical vision-based sensors are not suitable. This paper aims to present an alternative based on impedance measurement. The position of the cells is obtained from the variation of impedance measured between two electrodes. This technique presents several advantages: the sensor is integrated into the chip, the measurement electrodes are compatible with the fabrication process of actuation electrodes for dielectrophoresis, the sampling time of the sensor is high and the position of the cells can be obtained in real time. This article highlights the concept of position-sensitive impedance sensing. The design of the chip, and in particular of the electrodes, is discussed to improve the sensitivity and repeatability of the measurement. The issue of real-time detection in a noisy environment is solved by using an extended Kalman filter. As a first proof of concept, this article presents experimental validation on a 1D case to determine the longitudinal position of 8.7 µm diameter beads in a channel.
RESUMEN
Tiludronate is a non-nitrogen-containing biphosphonate drug approved in equine veterinary medicine for the treatment of navicular disease and bone sparvin in horse. Its hydrophilic properties and its strong affinity for the bone have made the control of its use quite difficult. After an initial step of method development in plasma and urine, due to a strong matrix effect and erratic detection in urine, the final method development was conducted in plasma. After addition of (3-trifluoromethylphenyl) thiomethylene biphosphonic acid as internal standard, automated sample preparation consisted of a filtration on a Nexus cartridge followed by a Solid Phase Extraction on an Oasis WAX cartridge with weak anion exchange properties. After methylation of the residue with trimethyl orthoacetate (TMOA), analysis was conducted by HPLC/ESI-MS(n) on a LTQ mass spectrometer. The method has been validated with a LOD and LOQ of respectively 1 and 2.5ng/mL. Using a weighting factor of 1/concentration(2), a linear model was suitable in the range of 2.5 up to 500ng/mL. Precision and accuracy data determined at two concentrations were satisfactory (i.e. less than 15%). Carryover would have been a problem but this has finally been fixed using the additional steps of washing during robotised SPE extraction and analysis on both the autosampler and the analytical column. The method was successfully employed for the first time to the quantification of tiludronate in plasma samples collected from horses treated with Tildren™ (Intravenous administration at the dose of 0.1mg/kg/day for 10 days).