Efficient composite chlorinated ethenes removal using gallic acid to enhance Fe/Ni nanoparticles activated persulfate.

As the representative volatile chlorinated hydrocarbons detected in wastewater, the removal of composite chlorinated ethenes is a major challenge in wastewater treatment. In the present study, an efficient removal system for composite chlorinated ethenes was reported, in which gallic acid was used to enhance the activation of persulfate by Fe/Ni nanoparticles. The influences of gallic acid-Fe/Ni and persulfate concentrations, initial pH value, reaction temperature, inorganic anions, and natural organic matters were evaluated in the composite chlorinated ethenes removal. Our results showed that the gallic acid-Fe/Ni-persulfate system with 9.0 mM of gallic acid-Fe/Ni and 30.0 mM of persulfate yielded about 100% trichloroethylene removal and 97.3%-98.6% perchloroethylene removal in the pH range of 3.0-12.0. Electron paramagnetic resonance analysis and radical quenching experiments indicated that SO4•- and •OH were the predominant radical species under acidic and alkaline conditions. Ultraviolet visible spectroscopy and inductively coupled plasma optical emission spectrometer tests revealed the Fe-gallic acid chelation could regulate the concentration of iron ions and improve the reactivity of gallic acid-Fe/Ni. These results demonstrated that the gallic acid-Fe/Ni-persulfate system was a promising strategy for treating composite chlorinated ethenes-containing wastewater.

Tannic acid promotes the activation of persulfate with Fe(ii) for highly efficient trichloroethylene removal.

Trichloroethylene (TCE) is an Environmental Protection Agency (EPA) priority pollutant that is difficult to be removed by some remediation methods. For instance, TCE removal using persulfate (PS) activated by ferrous iron (Fe(ii)) has been tested but is limited by the unstable Fe(ii) concentration and the initial pH of contaminated water samples. Here we reported a new TCE removal system, in which tannic acid (TA) promoted the activation of PS with Fe(ii) (TA-Fe(ii)-PS system). The effect of initial pH, temperature, and concentrations of PS, Fe(ii), TA, inorganic anions and humic acid on TCE removal was investigated. We found that the TA-Fe(ii)-PS system with 80 mg L-1 of TA, 1.5 mM of Fe(ii) and 15 mM of PS yielded about 96.2-99.1% TCE removal in the pH range of 1.5-11.0. Radical quenching experiments were performed to identify active species. Results showed that SO4˙- and ˙OH were primarily responsible for TCE removal in the TA-Fe(ii)-PS system. In the presence of TA, the Fe-TA chelation and the reduction of TA could regulate Fe(ii) concentration and activate persulfate for continuously releasing reactive species under alkaline conditions. Based on the excellent removal performance for TCE, the TA-Fe(ii)-PS system becomes a promising candidate for controlling TCE in groundwater.

Organohydrogels with cellulose nanofibers enhanced supramolecular interactions toward high performance self-adhesive sensing pads.

Gel materials with tailored functions and tissue-like properties have gained significant interest in emerging applications, including tissue engineering scaffolds, flexible electronics, and soft robotics. In this work, we developed a stretchable, flexible, adhesive, and conductive organohydrogel through physical cross-linking of the poly (N-[tris (hydroxymethyl) methyl] acrylamide-co-acrylamide) (denoted as P(THMA-AM)) network in the presence of cellulose nanofiber (CNF), sodium chloride, and glycerol. The gel matrix is rich in intermolecular interactions, including hydrogen bonding and ionic interactions, which contribute to a highly compact and cohesive structure without the requirement of any chemical crosslinkers. Moreover, the plasticizing effect of glycerol can mitigate the self-entanglement of CNFs, enhancing their mobility and ultimately conferring the organohydrogel with exceptional stretchability and flexibility. The resulting organohydrogel exhibited superior mechanical properties, self-adhesion, and ionic conductivity, making it an excellent candidate for strain-sensing applications, particularly in distinguishing and monitoring human movements.

A rapid removal of Phaeocystis globosa from seawater by peroxymonosulfate enhanced cellulose nanocrystals coagulation.

Cellulose nanocrystals (CNC) are recognized as promising bio-based flocculants for controlling harmful algal blooms (HABs). Due to the charge shielding effect in seawater and the strong mobility of algae cells, CNC can't effectively remove Phaeocystis globosa from seawater. To solve this problem, peroxymonosulfate (PMS) was used to enhance the coagulation of CNC for rapidly removal of P. globosa. The results showed that 91.7% of Chl-a, 95.2% of OD680, and 97.2% of turbidity of P. globosa were reduced within 3 h with the use of 200 mg L-1 of CNC and 20 mg L-1 of PMS. The removal of P. globosa was consisted of inactivation and flocculation. Notably, electron paramagnetic resonance (EPR) spectrums and quenching experiments revealed that the inactivation of P. globosa was dominated by PMS oxidation and 1O2. Subsequently, CNC entrained inactivated algal cells to settle to the bottom to achieve efficient removal of P. globosa. The content of total organic carbon (TOC) and chemical oxygen demand (COD) decreased significantly, indicating that a low emission risk of algal cell effluent was produced in the CNC-PMS system. In view of the excellent performance on P. globosa removal, we believe that the CNC-PMS system has great potential for HABs treatments.

Efficient removal of chloroform from groundwater using activated percarbonate by cellulose nanofiber-supported Fe/Cu nanocomposites.

Chloroform (CF) is a recalcitrant halogenated methane (HM) that has received widespread attention due to its frequent detection in groundwater and its potential carcinogenic risk. In this study, TEMPO-oxidized cellulose nanofiber-supported iron/copper bimetallic nanoparticles (TOCNF-Fe/Cu), a novel composite catalyst, was synthesized to activate sodium percarbonate (SPC) for the removal of CF from groundwater. The results showed that over 96.3% of CF could be removed in a neutral reaction medium (pH 6.5-9) within 180 min using 0.66 g L-1 of TOCNF (0.32)-Fe/Cu (1) and 1 mM of SPC, which outperforms typical advanced oxidation processes. The reaction mechanism of the TOCNF-Fe/Cu-SPC system for the CF removal was elucidated. As demonstrated through electron paramagnetic resonance and quenching experiments, the TOCNF-Fe/Cu-SPC system was found to include •OH and O2•-, where the latter played a dominant role in the CF removal. DFT calculations indicated that TOCNF improved the electron transport capability of Fe/Cu and reduced the transition state energy. The Fe species on the surface of TOCNF-Fe/Cu were identified as the primary active sites for SPC activation, whereas the Cu species were beneficial to the regeneration of the Fe species. Additionally, TOCNF-Fe/Cu was found to have good recyclability and stability. The feasibility of the TOCNF-Fe/Cu-SPC system was further confirmed by applying it for the efficient removal of composite HMs from actually contaminated groundwater. Overall, the TOCNF-Fe/Cu-SPC system is an attractive candidate for the treatment of HM-contaminated groundwater.

Efficient removal of Phaeocystis globosa from seawater with the persulfate activation by arbutin-modified cellulose nanocrystals.

Harmful algal blooms (HABs) from seawater have a severe threat to human health, aquaculture, and coastal nuclear power safety. Thus, it is highly desirable to explore environmentally friendly, efficient, and economic methods for controlling HABs. Herein, the arbutin-modified cellulose nanocrystals (AT-CNC) activated persulfate (PS), as a novel heterogeneous Fenton-like process, was proposed to remove Phaeocystis globosa (P. globosa) from seawater. The AT-CNC was synthesized via the surface modification of AT on CNC. The effects of AT dosage, CNC dosage, and PS dosage on the removal performance of P. globosa were investigated. With the addition of 530 mg/L AT-CNC (6 wt% AT/CNC of AT loading) and 120 mg/L PS, the removal percentage of chlorophyll a (Rc), optical density at 680 nm (Ro) and turbidity (Rt) reached 97.7%, 91.9% and 85.2% at 24 h. According to electron paramagnetic resonance (EPR) spectra and radical quenching tests, the predominant free radicals inactivating P. globosa were hydroxyl radicals (•OH). Additionally, the flocculation of the inactivated algae cells by AT-CNC was also critical for removing P. globosa. Moreover, a positive environmental impact was achieved in the AT-CNC-PS system due to the reduction of nitrogen, phosphorus and organic carbon contents. Based on the excellent removal performance for P. globosa, we believe that the AT-CNC activated persulfate is a promising option for HABs control.