Simple fabrication process for 2D ZnO nanowalls and their potential application as a methane sensor.

Two-dimensional (2D) ZnO nanowalls were prepared on a glass substrate by a low-temperature thermal evaporation method, in which the fabrication process did not use a metal catalyst or the pre-deposition of a ZnO seed layer on the substrate. The nanowalls were characterized for their surface morphology, and the structural and optical properties were investigated using scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), and photoluminescence (PL). The fabricated ZnO nanowalls have many advantages, such as low growth temperature and good crystal quality, while being fast, low cost, and easy to fabricate. Methane sensor measurements of the ZnO nanowalls show a high sensitivity to methane gas, and rapid response and recovery times. These unique characteristics are attributed to the high surface-to-volume ratio of the ZnO nanowalls. Thus, the ZnO nanowall methane sensor is a potential gas sensor candidate owing to its good performance.

Bending effects of ZnO nanorod metal-semiconductor-metal photodetectors on flexible polyimide substrate.

The authors report the fabrication and I-V characteristics of ZnO nanorod metal-semiconductor-metal photodetectors on flexible polyimide substrate. From field-emission scanning electron microscopy and X-ray diffraction spectrum, ZnO nanorods had a (0002) crystal orientation and a wurtzite hexagonal structure. During the I-V and response measurement, the flexible substrates were measured with (i.e., the radius of curvatures was 0.2 cm) and without bending. From I-V results, the dark current decreased, and the UV-to-visible rejection ratio increased slightly in bending situation. The decreasing tendency of the dark current under bending condition may be attributed to the increase of the Schottky barrier height.