Zinc detection in oil-polluted marine environment by stripping voltammetry with mercury-free nanoporous gold electrode.

Detection of Zn(II) in oil-polluted seawater via square-wave anodic stripping voltammetry (SW-ASV) utilizing thin gold electrodes sputtered onto nanoporous poly(acrylic acid)-grafted-poly(vinylidene difluoride) (PAA-g-PVDF) membrane is herein reported. Prior to SW-ASV, PAA grafted nanopores demonstrated to efficiently trap Zn(II) ions at open circuit. This passive adsorption followed a Langmuir law. An affinity constant of 1.41 L [Formula: see text]mol[Formula: see text] and a maximum Zn(II) adsorbed mass q[Formula: see text] of 1.21 [Formula: see text]mol g[Formula: see text] were found. Applied SW-ASV protocol implied an accumulation step (- 1.2 V for 120 s) followed by a stripping step (- 1.2 to 1 V; 25 Hz; step: 4 mV; amplitude: 25 mV; acetate buffer (pH 5.5)). It revealed a Zn redox potential at - 0.8 V (Ag/AgCl pseudo-reference). Multiple measurements in synthetic waters close to the composition of production waters exhibited a decreasing precision with the number of readings R (1.65[Formula: see text] (R = 2) and 6.56[Formula: see text] (R = 3)). These membrane-electrodes should be used as disposable. The intra-batch mean precision was 14[Formula: see text] (n = 3) while inter-batches precision was 20[Formula: see text] (n = 15). Linear and linear-log calibrations allow exploitation of Zn(II) concentrations ranging from 10 to 500 [Formula: see text]g L[Formula: see text] and 100 to 1000 [Formula: see text]g L[Formula: see text] respectively. The LOD was 4.2 [Formula: see text]g L[Formula: see text] (3S/N). Thanks to obtained calibration, a detected Zn(II) content of 1 ppm in a raw production water from North Sea oil platform was determined.

An uranyl sorption study inside functionalised nanopores.

Sorption mechanism of uranyl by poly(bis[2-(methacryloyloxy)ethyl] phosphate) (PB2MP) functionalised polyvinylidene fluoride (PVDF) track-etched membranes, PB2MP-g-PVDF, was investigated. It was found that uranyl sorption obeyed Langmuir isotherm model giving a maximum U(VI) membrane uptake of 6.73 µmol g-1 and an affinity constant of 9.85 â‹… 106 L mol-1. XPS and TRPL measurements were performed to identify sorbed uranyl oxidation state and its environment. Uranyl was found to be mainly in its hexavalent state, i.e. U(VI), showing that the trapping inside the PB2MP-g-PVDF nanoporous membranes did not change the ion speciation. Two sorbed uranyl life-times (τ1 = 8.8 µs and τ2 = 102.8 µs) were measured by TRPL which pointed out different complexations taking place inside the nanopores. Uranyl sorption by PB2MP-g-PVDF membranes was also found to be pH dependent demonstrating the highest performance at circumneutral pH. In addition, TRPL was demonstrated to be not only a remarkable technique for U(VI) characterization, but also an alternative to voltammetry detection for trace on-site uranyl monitoring using PB2MP-g-PVDF nanoporous membranes.

Early warning sensors for monitoring mercury in water.

Poly-4-vinylpyridine grafted poly(vinylidene difluoride) (P4VP-g-PVDF) nanoporous polymer electrodes were found to be sensitive for Hg(II) analysis. The fabrication and characterization of functionalized nanoporous membrane-electrodes by FESEM and FTIR are presented. Functionalized nanopore charge state versus a large range of pH (1-10) was investigated by registering the streaming potential. This isoelectric point is achieved at the pKa of P4VP (pH = 5). Mercury adsorption at solid-liquid interface obeys a Langmuir law. A protocol for accurate Hg(II) analysis at ppb level was established. Calibration curves were performed and different real water samples (mineral water, ground water, surface water) were spiked and analyzed. The resulting sensor is intended to be integrated into existing systems or used standalone as portable devices. A first generation prototype exhibiting its own integrated potentiostat, its software and set of membrane-electrode pads is presented.

The concept of entropic rectifier facing experiments.

The transport of molecules in confined media is subject to entropic barriers. So theoretically, asymmetry of the confinement length may lead to molecular ratchets with entropy as the only driving force for the biased transport. We address experimentally this question by performing alternative ionic current measurements on electrolytes confined in neutral conical nanopores. In case anions and cations widely differ in size, we show that rectification of ionic current can be obtained that depends on ions size and cycle frequency, consistently with the entropic ratchet mechanism.

Pink noise of ionic conductance through single artificial nanopores revisited.

We report voltage-clamp measurements through single conical nanopore obtained by chemical etching of a single ion track in polyimide film. Special attention is paid to the pink noise of the ionic current (i.e., 1/f noise) measured with different filling liquids. The relative pink-noise amplitude is almost independent of concentration and pH for KCl solutions, but varies strongly using ionic liquids. In particular, we show that depending on the ionic liquid, the transport of charge carriers is strongly facilitated (low noise and higher conductivity than in the bulk) or jammed. These results show that the origin of the pink noise can be ascribed neither to fluctuations of the pore geometry nor to the pore wall charges, but rather to a cooperative effect on ions motion in confined geometry.