RESUMEN
Crop growth simulation models relate the soil-water-plant-atmosphere components to estimate the development and yield of plants in different scenarios, enabling the identification of efficient irrigation strategies. The aim of this study was to calibrate crop coefficients for a common bean cultivar (IAPAR 57) and assess the AquaCrop model's efficacy in simulating crop growth under different irrigation regimes (T0 - non-irrigated, T1-fully irrigated, and T2-deficit irrigated) and sowing dates (S1-March 21, S2-April 24, and S3-August 23). Successful calibration was achieved for crop seasons with suitable temperatures to crop growth (S1 and S3). However, during periods with suboptimal temperatures (April 24 season), coupled with reduced irrigation supply (T0 and T2), the AquaCrop model did not appropriately account for the combined effects of thermal and water stresses. Despite adjustments to stress coefficients, this led to an overestimation of crop growth and yield. In long-term simulations, the model successfully replicated the variability of crop water availability over cropping seasons, reflecting the impact of precipitation variations. It recommended irrigation strategies for the study region (irrigate at depletion of 120 and 170% of readily available water for sowing on March 21 and August 24, respectively) to achieve high crop yield (> 2,769 kg ha-1) and water productivity (1,050 to 1,445 kg m-3) with minimal application depths (< 150 mm). While acknowledging the need for improvements in thermal stress calculations, the AquaCrop model demonstrates promising utility in studies and applications where water availability significantly influences crop production.
RESUMEN
The use of phosphate-solubilizing bacteria (PSB) can be a sustainable strategy to increase phosphorus availability and promote satisfactory crop yields. The objective of this study was to evaluate whether inoculation with PSB in common bean increases (i) growth, (ii) nutrition, (iii) yield, and (iv) grain quality, and (v) reduces the chemical phosphorus application dose to obtain maximum yields. The experiment was conducted in an Oxisol using a randomized block design in a 4 × 4 factorial scheme, with four replicates, using the cultivar IAC 2051. The first factor was four doses of P2O5 (0, 20, 40 and 60 kg ha-1), and the second factor was four doses of PSB (0, 100, 200 and 300 mL ha-1). For leaf area and leaf chlorophyll content, the association of PSB inoculation with a P2O5 dose of 40 kg ha-1 promoted the best conditions for the common bean. P2O5 application increased yield by 79 kg ha-1 for each 10 kg ha-1 added. PSB inoculation at a dose of 192 mL ha-1 promoted P export of 15.3 kg ha-1, and the PSB dose of 159 mL ha-1 increased yield by 389 kg ha-1 (12%) compared to the control. Grain quality remained within the standards required by the consumer market, being little affected by the treatments. Improvements in common bean growth and nutritional and physiological status promoted by P2O5 application and PSB were essential in increasing yield, so these are sustainable production strategies.
RESUMEN
Introduction: The contrasting weather conditions throughout the sugarcane harvest period in south-central Brazil (April to November) influence fertilization management in sugarcane ratoon. Methods: Through field studies carried out over two cropping seasons, we aimed to compare the performance of sugarcane at sites harvested in the early and late periods of the harvest season as a function of fertilizer sources associated with application methods. The design used in each site was a randomized block in a 2 x 3 factorial scheme; the first factor consisted of fertilizer sources (solid and liquid), and the second factor consisted of application methods (above the straw, under the straw, and incorporated into the middle of the sugarcane row). Results: The fertilizer source and application method interacted at the site harvested in the early period of the sugarcane harvest season. Overall, the highest sugarcane stalk and sugar yields at this site were obtained with the incorporated application applying liquid fertilizer and under straw applying solid fertilizer, with increments of up to 33%. For the site harvested in the late period of the sugarcane harvest season, the liquid fertilizer promoted a 25% higher sugarcane stalk yield compared to the solid fertilizer in the crop season with low rainfall in the spring, while in the crop season with normal rainfall, there were no differences between treatments. Discussion: This demonstrates the importance of defining fertilization management in sugarcane as a function of harvest time, thereby promoting greater sustainability in the production system.
RESUMEN
The aim was to evaluate the agronomic and qualitative attributes of early-cycle common bean cultivars with different grains types grains in response to top-dressing nitrogen (N) doses. The experiment was carried out using a randomized block design, in a split-plot scheme, with 4 replicates. The plots consisted of the cultivars IAC Nuance, IAC 1849 Polaco and IAC Veloz, with speckled, Carioca and black grains, respectively. The subplots were formed by N doses applied as top-dressing: 0 kg ha-1, 60 kg ha-1 (applied in the stage of third trifoliate leaf), 120 kg ha-1 (1/2 applied at third trifoliate leaf stage + 1/2 applied at the floral bud stage) and 180 kg ha-1 (1/3 applied at the first trifoliate leaf stage + 1/3 applied at the third trifoliate leaf stage + 1/3 applied at the floral bud stage). IAC Veloz stood out for grain yield, showing the highest grain yield in the lowest N doses, being classified as efficient to the use of N. The cultivars IAC Nuance and IAC 1849 Polaco reached maximum yields with 155 and 163 kg ha-1 of N. The IAC Nuance was the most responsive, increasing grain yield by up to 25.3% due to nitrogen fertilization. Increasing N doses applied as top-dressing increased the sieve yield and crude protein content of the common bean cultivars, with IAC Nuance standing out. The cultivars showed good grain quality, and IAC 1849 Polaco and IAC Veloz had the shortest cooking time and IAC Veloz also had the fastest hydration.
Asunto(s)
Fitohemaglutininas , Genotipo , Nitrógeno , Productos AgrícolasRESUMEN
Studies on the use of deficit irrigation and application of models for estimating agronomic performance of crops can help in more sustainable agricultural managements. The objective of this study was to evaluate the effect of irrigation levels on the agronomic performance of white oat (Avena sativa L.) and accuracy of the CERES-Barley model in simulating white oat growth and yield, as well as performing long-term simulation to identify the best sowing time for each irrigation management. The experiment consisted of five irrigation levels (11%, 31%, 60%, 87%, and 100%), being conducted in two agricultural years in southeastern Brazil. The model was calibrated with data of the treatment without water deficit (100%) of the first year and validated with the data of the other treatments in the 2 years. Long-term analyses, with a historical series of 16 years, were performed to recommend the best sowing dates for each irrigation management. Deficit irrigation linearly reduces the agronomic performance of white oat. The high accuracy of white oat yield estimation (R2 = 0.86; RMSE = 616 kg ha-1) using the CERES-Barley model allowed the long-term simulation for establishing the best sowing date for each irrigation level. For higher irrigation levels, sowing in periods with lower temperature (May and June) is more appropriate, as the 1 °C increment in the average temperature before flowering reduces crop yield by 600 kg ha-1. At irrigation levels with higher deficit, sowing in periods with higher rainfall (March and April) promotes higher crop yield.
Asunto(s)
Avena , Hordeum , Riego Agrícola , Agricultura , Productos Agrícolas , Grano ComestibleRESUMEN
In agriculture, wastewater is used as an alternative source to meet the water and nutritional requirements of plants. However, long-term application of wastewater may degrade soil attributes. This study aimed to evaluate the soil physical quality of Oxisol fertigated with treated sewage effluent (TSE). The experiment was conducted in an area under TSE application for 4 years in Oxisol (625 g kg-1 clay) cultivated with Urochloa brizantha. The treatments consisted of six levels of TSE in irrigation depth, 0%, 11%, 31%, 60%, 87%, and 100%, with four repetitions. Undisturbed and disturbed soils samples were collected in three layers (0.00-0.10 m; 0.10-0.20 m, and 0.20-0.30 m). Aggregation, porosity and water infiltration attributes were evaluated. This work concludes a long-term study on the effects of TSE application on soil properties and on the Urochloa brizantha crop. In other works, carried out in the experimental area of the present study, it was found that TSE fertigation increases the yield and quality of Urochloa brizantha, increases soil fertility and does not lead to soil heavy metal contamination. We note the TSE fertigation does not change the aggregation, porosity, water infiltration rate and organic carbon content in the soil. Irrigation with TSE is recommended in areas with clayey soil and those cultivated with perennial grasses as it does not cause any damage to the physical quality of the soil. Thus, the TSE fertigation can be used on many crops as a source of water and nutrients, reducing the environmental contamination potential.