Thermogelling properties of purified poloxamer 407.

Poloxamers are triblock copolymers with a center block of hydrophobic polypropylene oxide (PPO) flanked by two hydrophilic polyethyleneoxide (PEO) blocks. Among this family of copolymers, poloxamer 407 is a non-ionic surfactant with reversible gelation properties above a particular polymer concentration and a particular temperature. Easy preparation of poloxamer 407 based sterile injectable formulations have made this copolymer a good candidate for drug delivery, specifically when controlled release of the drug is required. Previously, the applications of compendial poloxamer 407 preparations were demonstrated; however, low viscosity, poor elasticity, and sol-to-gel transition temperature (Tsol-gel) over a wide temperature range were observed. A purification process was introduced to eliminate impurities and low molecular weight copolymer molecules from the compendial poloxamer 407 resulting in higher viscosity values with Tsol-gel in a narrow temperature range. Here, poloxamer 407 was purified based on the proposed process and the rheological and analytical evaluation of the purified poloxamer 407 was conducted and compared to unpurified, compendial poloxamer 407. Then, the impact of poloxamer 407 concentration on gel formation was evaluated. For drug delivery applications, the effect of relevant buffer salts and the effect of addition of ethanol to the poloxamer 407 solutions were rheologically evaluated.

Thermosensitive Gel-Based Formulation for Intratumoral Delivery of Toll-Like Receptor 7/8 Dual Agonist, MEDI9197.

Toll-like receptor (TLR) agonists TLR 7/8, MEDI9197, is a imidazoquinoline analogue that can be used for cancer immunotherapy based on its efficacy toward a variety of tumors. Systemic administration of TLR agonists results in stimulation of the immune system throughout the entire body causing undesirable side effects. To minimize these adverse events, local administration of TLR agonists including intratumoral (IT) delivery has been introduced. Here, a poloxamer 407 thermogel formulation for IT delivery of a TLR 7/8 dual agonist, MEDI9197, is described in which the combination of the aqueous thermogel and the ethanolic TLR 7/8 dual agonist, MEDI9197, solution leads to precipitated drug particles within the gel. The in vitro release profile showed an initial burst followed by sustained release. A B16-OVA mouse tumor model was used to assess the in vivo pharmacokinetics, efficacy, and systemic cytokine and chemokine (cytokine) production of the poloxamer 407-based thermogel formulation. The pharmacokinetic evaluation showed that the agonist level within the tumor was reduced by ∼70% over 14 days while serum agonist levels indicated an initial burst at the 6-h time point followed by a drop in serum drug levels over the 14 days of the experiment. The tumor growth inhibition, survival, and serum cytokines for post-IT injection of the poloxamer 407 formulation showed that it slowly released TLR 7/8 agonist, MEDI9197, resulting in more efficacious tumor growth inhibition compared with control groups. In addition, the cytokine levels in circulation indicated that a dose increase led to a decrease in the serum inflammatory and interferon-inducible cytokines levels. This observation could be due to a reduction of drug diffusion and escape from the tumor site due to the precipitation of the drug inside the tumor leading to sustained release. IT delivery of TLR 7/8 dual agonist, MEDI9197, via a thermosensitive gel-based formulation was efficacious and could offer an alternate method of local drug delivery.

Influence of Arginine Salts on the Thermal Stability and Aggregation Kinetics of Monoclonal Antibody: Dominant Role of Anions.

Thermal stability of the CH2 domain for an IgG1 monoclonal antibody and its aggregation kinetics were systematically studied at pH 4.8, below its pI of 8.8 in individual solutions of arginine salts with acetate, glutamate (Glu-), chloride, and sulfate as the anion, in comparison to sodium chloride and sodium sulfate. Thermal unfolding temperature, Tm, an indicator of thermal stability, was measured by both differential scanning calorimetry (DSC) and differential scanning fluorimetry (DSF). The aggregation kinetics was determined by assessing reversibility for the CH2 domain in the DSC repetitive scans and then cross-examined by the isothermal aggregation study measured by size exclusion chromatography. The effect of Arg+ on the thermal stability and aggregation kinetics of the antibody is shown to be strongly anion-dependent: both ArgAceate and ArgGlu improve the stability, while both Arg2SO4 and ArgCl decrease it. Furthermore, the addition of ArgCl and Arg2SO4 accelerates the aggregation kinetic, but to a lesser extent than the respective Na+ salt, suggesting that Arg+ binds to the antibody more strongly than Na+. However, the binding of Arg+ did not lead to more destabilization of the CH2 domain by the Arg+ salts at low concentrations, comparing to the respective Na+ salt. This finding indicates that Arg+ prefers the protein surface, rather than the exposed backbone upon unfolding. Furthermore, the change in the ranking for affecting the thermal stability and aggregation kinetics as the salt concentration increases implies the presence of other multiple mechanisms, e.g., cluster formation through the homoion pairing between Arg+ molecules and their preferential exclusion from the protein surface, and heteroion pairing between Arg+ and SO42-.

Controlled Extraction Studies Applied to Polyvinyl Chloride and Polyethylene Materials: Conclusions from the ELSIE Controlled Extraction Pilot Study.

The effective management of leachables in pharmaceutical products is a critical aspect of their development. This can be facilitated if extractables information on the materials used in a packaging or delivery system is available to assist companies in selecting materials that will be compatible with the drug product formulation and suitable for the intended use. The Extractables and Leachables Safety Information Exchange (ELSIE) materials working group developed and executed a comprehensive extraction study protocol that included a number of extraction solvents, extraction techniques, and a variety of analytical techniques. This was performed on two test materials, polyethylene (PE) and polyvinyl chloride (PVC), that were selected due to their common use in pharmaceutical packaging. The purpose of the study was to investigate if the protocol could be simplified such that (i) a reduced number or even a single extraction technique could be used and (ii) a reduced number of solvents could be used to obtain information that is useful for material selection regardless of product type. Results indicate that, at least for the PVC, such reductions are feasible. Additionally, the studies indicate that levels of extractable elemental impurities in the two test materials were low and further confirm the importance of using orthogonal analytical detection techniques to gain adequate understanding of extraction profiles.

Characterization of the initial level and migration of silicone oil lubricant in empty prefilled syringes for biologics using infrared spectroscopy.

Glass prefillable syringes are lubricated with silicone oil to ensure functionality and a consistent injection for the end user. If excessive silicone is applied, droplets could potentially result in aggregation of sensitive biopharmaceuticals or clouding of the solution. Therefore, monitoring and optimization of the applied silicone layer is critical for prefilled syringe development. The hydrophobic properties of silicone oil, the potential for assay interference, and the very small quantities applied to prefilled syringes present a challenge for the development of a suitable assay. In this work we present a rapid and simple Fourier transform infrared (FTIR) spectroscopy method for quantitation of total silicone levels applied to prefilled syringes. Level-dependent silicone oil migration occurred over time for empty prefilled syringes stored tip-up. However, migration from all prefilled syringes with between 0.25 and 0.8 mg of initial silicone oil resulted in a stable limiting minimum level of between 0.15 and 0.26 mg of silicone in the syringe reached after 1 to 4 years of empty tip-up storage. The results of the FTIR assay correlated well with non-destructive reflectometry characterization of the syringes. This assay can provide valuable data for selection of a robust initial silicone oil target and quality control of prefilled syringes intended for biopharmaceuticals. LAY ABSTRACT: Glass prefillable syringes are lubricated with silicone oil to ensure functionality and a consistent injection for the end user. If excessive silicone is applied, droplets could potentially result in aggregation of sensitive biopharmaceuticals or clouding of the solution. Therefore, monitoring and optimization of the applied silicone layer is critical for prefilled syringe development. The hydrophobic properties of silicone oil, the potential for assay interference, and the very small quantities applied to prefilled syringes present a challenge for the development of a suitable assay. In this work we present a rapid and simple Fourier transform infrared (FTIR) spectroscopy method for quantitation of total silicone levels applied to prefilled syringes. Level-dependent silicone oil migration occurred over time for empty prefilled syringes stored tip-up. However, migration from all prefilled syringes with between 0.25 and 0.8 mg of initial silicone oil resulted in a stable limiting minimum level of between 0.15 and 0.26 mg of silicone in the syringe reached after 1 to 4 years of empty tip-up storage. The results of the FTIR assay correlated well with non-destructive reflectometry characterization of the syringes. This assay can provide valuable data for selection of a robust initial silicone oil target and quality control of prefilled syringes intended for biopharmaceuticals.

Chronic administration of belimumab, a BLyS antagonist, decreases tissue and peripheral blood B-lymphocyte populations in cynomolgus monkeys: pharmacokinetic, pharmacodynamic, and toxicologic effects.

The tolerability, pharmacodynamic effects, and pharmacokinetics of belimumab (LymphoStat-B) were evaluated in cynomolgus monkeys. Belimumab is a fully human IgG1lambda antibody directed against B-lymphocyte stimulator (BLyS) protein. BLyS is a TNF family member that supports B-lymphocyte maturation and survival and has been implicated in the pathogenesis of autoimmune diseases and B-lymphocyte malignancies. Belimumab was developed to antagonize BLyS activity in autoimmune diseases and B-lymphocyte malignancies, where undesirable effects of B-lymphocyte activity may cause or contribute to disease. Pharmacodynamic effects of belimumab were monitored by immunophenotyping of peripheral blood. Pathology end points, including tissue immunophenotyping, are described after 13 and 26 weeks of treatment and after a 34-week treatment-free (recovery) period. Belimumab was safe and well tolerated in repeat-dose toxicology studies at 5-50 mg/kg for up to 26 weeks. Monkeys exposed to belimumab had significant decreases in peripheral blood B lymphocytes by 13 weeks of exposure, continuing into the recovery period, despite total lymphocyte counts similar to the controls. There were concomitant decreases in spleen and lymph node B-lymphocyte representation after 13 or 26 weeks of treatment with belimumab. Microscopically, monkeys treated with belimumab for 13 or 26 weeks had decreases in the number and size of lymphoid follicles in the white pulp of the spleen. All findings were generally reversible within a 34-week recovery period. These data confirm the specific pharmacologic activity of belimumab in reducing B lymphocytes in the cynomolgus monkey. The favorable safety profile and lack of treatment-related infections also support continued clinical development of belimumab.

An IFN-beta-albumin fusion protein that displays improved pharmacokinetic and pharmacodynamic properties in nonhuman primates.

The long half-life and stability of human serum albumin (HSA) make it an attractive candidate for fusion to short-lived therapeutic proteins. Albuferon (Human Genome Sciences [HGS], Inc., Rockville, MD) beta is a novel recombinant protein derived from a gene fusion of interferon-beta (IFN-beta ) and HSA. In vitro, Albuferon beta displays antiviral and antiproliferative activities and triggers the IFN-stimulated response element (ISRE) signal transduction pathway. Array analysis of 5694 independent genes in Daudi-treated cells revealed that Albuferon beta and IFN-beta induce the expression of an identical set of 30 genes, including 9 previously not identified. In rhesus monkeys administered a dose of 50 microg/kg intravenously (i.v.) or subcutaneously (s.c.) or 300 microg/kg s.c., Albuferon beta demonstrated favorable pharmacokinetic properties. Subcutaneous bioavailability was 87%, plasma clearance at 4.7-5.7 ml/h/kg was approximately 140-fold lower than that of IFN-beta, and the terminal half-life was 36-40 h compared with 8 h for IFN-beta. Importantly, Albuferon beta induced sustained increases in serum neopterin levels and 2',5' mRNA expression. At a molar dose equivalent to one-half the dose of IFN-beta, Albuferon beta elicited comparable neopterin responses and significantly higher 2',5'-OAS mRNA levels in rhesus monkeys. The enhanced in vivo pharmacologic properties of IFN-beta when fused to serum albumin suggest a clinical opportunity for improved IFN-beta therapy.

Albutropin: a growth hormone-albumin fusion with improved pharmacokinetics and pharmacodynamics in rats and monkeys.

Growth hormone (GH) replacement therapy is used to treat GH deficiency. Treatment requires daily administration because of the short plasma t(1/2) of GH. Albutropin, human GH fused at its N-terminus with human serum albumin, should be cleared from the circulation more slowly than GH. Pharmacokinetic and pharmacodynamic studies of albutropin were conducted in rats and monkeys. After subcutaneous (s.c.) dosing in rats, a twofold decrease in clearance and a fourfold increase in plasma half-life were seen with albutropin compared to GH. In monkeys, s.c. administered albutropin (0.3 mg/kg) had a sixfold longer terminal half-life and an eightfold slower clearance than GH (0.3 mg/kg). A single subcutaneous administration of albutropin (0.3, 1.5 and 4 mg/kg) increased plasma insulin-like growth factor 1 (IGF-1) levels for up to 7 days. Seven consecutive daily s.c. injections of GH at 0.3 mg/kg resulted in an increase in IGF-1 equivalent to that induced by a single administration of albutropin at 4 mg/kg. Albutropin (1-20 microg/kg) dosed daily, every other day or every 4 days significantly increased cumulative body weight gain and tibial epiphyseal growth plate width in hypophysectomized rats compared to equimolar doses of GH. These results suggest that albutropin could be given less frequently than GH and achieve therapeutic effects in patients.