Changes in the total ozone content over the period 2006 to 2100 and the effects on the erythemal and vitamin D effective UV doses for South America and Antarctica.

Recent studies show that the ozone layer will recover by the middle part of this century. This is a significant result arising from the Montreal Protocol, and highlights the success of this environmental protection agreement. Climate change projections show that Total Ozone Content (TOC) levels will increase significantly by the end of this century, mainly at higher latitudes. This increase may result in a reduction of the adverse effects of UV radiation overexposure. By contrast, reduced UV radiation levels at the surface of the Earth can result in reduced levels of vitamin D synthesis among the inhabitants of these regions. In this study we provide estimates for the UVI, erythemal, and vitamin-D weighted daily doses for ten different locations in South America and Antarctica. Our calculations were based on ozone projections provided by climate models set forth in the last IPCC report. Results show that the increase of TOC levels in middle and high latitude regions may result in decreased UVI and UV doses throughout the century. In high latitudes, erythemal doses and vitamin D synthesis doses may be reduced by up to 22 and 39%, respectively, if anthropogenic emissions continue to rise throughout the century. Furthermore, there may be reductions of up to 9 and 12%, respectively, in mid-latitudes (20°S to 35°S). Significant variations at Equatorial sites were not observed. In most of South America, the attenuation in UVR caused by increases in TOC during the 21st century is neither enough to promote protective effects from this radiation, nor for the lack of UVR for vitamin D synthesis. The incidence of UVR in tropical and sub-tropical areas of the continent will continue to be a public health risk for the entire 21st century during all seasons, regardless of the climatic scenarios. Our results can be used as an important tool for health studies focusing on the excess and/or lack of sun exposure.

Análisis superficial de rugosidad (RA) en el mecanizado de Poli-Éter-Éter-Cetona (PEEK) para aplicación en implantes individualizados / Surface roughness analysis (RA) in the machining of Poly-Ether-Keton (PEEK) for tailored implants

RESUMEN El objetivo de esta investigación es determinar los valores de velocidad de corte, avance y trayectoria (estrategia de mecanizado) en el mecanizado del PEEK que permitan obtener una rugosidad (Ra) recomendada según la literatura para la adecuada diferenciación, proliferación y adhesión de células mesenquimales aplicables en implantes óseos[3,4,6,7,11]. De la revisión del estado del arte se determinó que dichos procesos celulares se obtienen cuando la rugosidad superficial Ra tiene un valor entre 1 μm a 3 μm[9,12], de igual forma, a mayor anisotropía superficial, mayor diferenciación celular se obtendrá[7,8]. Para determinar los parámetros de corte con los que se obtiene una rugosidad Ra óptima se realizó un diseño experimental de superficie de respuesta con rangos de exploración de: velocidad de corte: 60 m/min - 90 m/min y velocidad de avance: 900 mm/min - 1500 mm/min usados para ambas estrategias evaluadas: Raster y Espiral. La investigación concluyó que los parámetros de mecanizado con los cuales se obtiene una rugosidad recomendada Ra para la elaboración de implantes óseos son: velocidad de avance 1500 mm/min y velocidad de corte de 90 m/min mecanizando con una trayectoria (técnica de mecanizado) Raster, con la cual se obtiene una rugosidad Ra de 2,7 μm.

ABSTRACT The objective of this study is determinate the values of cutting speed, feed along and the machining strategy to get optimal values of roughness Ra for the machining of PEEK, polyetheretherketone, to get to get differentiation, proliferation and adhesion for mesenchymal for the development of individualized tailored prosthesis. According to literature to get those cellular process the superficial roughness must have a value Ra of 1 μm to 3 μm, also, if more anisotropic surface, more adhesion of cells. To determinate the recommended roughness Response Surface Methodology was used, the region of operability was: cutting speed 60 m/min to 90 m/min, feed along 900 mm/min to 1500 mm/min and a cutting strategy of Raster and Spiral. In this investigation the conclusion was that the cutting parameter to get the recommended roughness Ra for the elaboration of tailored prosthesis is feed along of 1500 mm/min and cutting speed of 90 m/min, machining with Raster strategy, for those parameters the roughness was of 2,7 μm.

Evaluation of tourists' UV exposure in Paris.

BACKGROUND: Ultraviolet (UV) exposure is one of the most important risk factor for skin cancers. If UV hazard has been evaluated in tropical countries or in some population - children, outdoor activities - little information is available about UV hazard in high latitude towns like Paris, considered as the most 'charismatic city' in the world. OBJECTIVE: To evaluate UV exposure in Paris in spring, in sun and shade, in real life conditions. METHODS: We evaluated erythemal UV exposure, during four sunny days in May-June in eight Paris touristic sites during peak hours (2 days), and during two walks in touristic downtown of Paris. Measures were performed in sun and shade. UV radiation exposure was evaluated with UV index performed with a 'Solarmeter ultraviolet index (UVI)' and UV dose with 'standard erythema dose' (SED) and 'minimal erythema dose' (MED) calculations. RESULTS: Despite 'average' UVI in sunny conditions, a 4-h sun exposure reaches 13-20 SED and 3-10 MED according to phototype. Clouds were inefficient to protect against UV. Shade of places reduces moderately UVI (50-60%) in forecourts. Exposure during 1-h walk reach at least one MED in real life conditions for skin phototypes I-IV. CONCLUSIONS: UV risk for tourist is quite high in spring in Paris. UVI remains high despite high cloud fraction. Shade reduces UVI, but UV protection factor is only 2-3 in large places such as Place Notre Dame and Place Charles de Gaulle. So sun protection campaigns should be proposed, and sun protective strategies could be integrated in urban planning.

An overview of the ultraviolet index and the skin cancer cases in Brazil.

This study relates regional and seasonal UV index (UVI) variations, number of skin cancer cases and population skin-color distribution in Brazil. UVI calculations were performed using the UV Global Atmospheric Model (UVGAME), whose characteristics and validations are provided in thiis article. Health and racial data sets are based on the health and census data collected by Brazilian governmental agencies in the past. The discussion covers cultural customs and details of health and educational campaigns in Brazil. Despite lower UV levels in the South and Southeast regions, the results show a number of nonmelanoma skin cancer (NMSC) cases regions, where the white population is predominant. In general, in the southern regions about 50 new NMSC cases per 100000 inhabitants have been diagnosed each year. These rates decrease almost 40% in the Central-North regions and more than 80% in Northeast region, where miscegenation is common. In addition, the UVI evaluation is extended to other South American sites with singular characteristics, e.g. populous cities located in high altitudes or those affected by the Antarctic ozone hole in the extreme south of the continent.