RESUMEN
An acoustic propagation experiment was conducted in Currituck Sound to characterize low-frequency propagation in a very-shallow-water estuarine environment. The water column properties were homogeneous over the study area, and the emphasis of this work is on understanding the propagation effects induced by the estuarine bed. During the experiment, low-frequency sound propagation measurements of waterborne sound and interface waves were acquired, and direct measurements of the compressional and shear wave properties were obtained at high frequencies. The propagation data consist of signals from a Combustive Sound Source recorded on bottom mounted geophones and a vertical line array of hydrophones. A statistical inference method was applied to obtain an estimate of the sediment compressional and shear wave speed profiles as a function of depth within the estuarine bed. The direct measurements were obtained in situ by inserting probes 30 cm into the sediment. Sediment acoustics models were fit to the high-frequency in situ data to enable comparison with the inferred low-frequency wave speeds. Overall, good agreement was found between the directly measured and inferred wave speeds for both the compressional and shear wave data.
RESUMEN
In situ measurements of compressional and shear wave speed and attenuation were collected 30 cm below the water-sediment interface in Currituck Sound, North Carolina at two field locations having distinctly different sediment types: medium-to-fine-grained sand and fine-grained sand with approximately 10% mud content. Shear wave measurements were performed with bimorph transducers to generate and receive horizontally polarized shear waves in the 300 Hz to 1 kHz band, and compressional wave measurements were performed using hydrophones operated in the 5 kHz to 100 kHz band. Sediment samples were collected at both measurement sites and later analyzed in the laboratory to characterize the sediment grain size distribution for each field location. Compressional and shear wave speed and attenuation were estimated from the acoustic measurements, and preliminary comparisons to the extended Biot model by Chotiros and Isakson [J. Acoust. Soc. 135, 3264-3279 (2014)] and the viscous grain-shearing theory by Buckingham [J. Acoust. Soc. 136, 2478-2488 (2014)] were performed.
RESUMEN
Finite element methods are utilized to model and compare the use of both a remote loudspeaker and a vertical shaker in the generation of sound and shear and interface waves in an elastic solid containing an imbedded elastic scatterer, which is resonant. Results for steady state and transient insonification are presented to illustrate excitation, propagation, and scattering mechanisms and effects. Comparisons of acoustic and vibratory excitation of the solid interface are made, with a view towards remote sensing of induced vibratory motion through optical measurement of the ground interface motion above the imbedded inclusion. Some advantages of the acoustic excitation method for exciting plate mode resonances in the target are observed.
RESUMEN
The work described herein discusses the application of a frequency-wavenumber signal processing technique to signals from rectangular infrasound arrays for detection and estimation of the direction of travel of infrasound. Arrays of 100 sensors were arranged in square configurations with sensor spacing of 2 m. Wind noise data were collected at one site. Synthetic infrasound signals were superposed on top of the wind noise to determine the accuracy and sensitivity of the technique with respect to signal-to-noise ratio. The technique was then applied to an impulsive event recorded at a different site. Preliminary results demonstrated the feasibility of this approach.
