Insights into the effect mechanism of acidic pH condition on the in vitro starch digestion of black highland barley semi-dried noodles.

In this study, black highland barley semi-dried noodles (BHBSNs) were adjusted to acidic pH (5.0, 4.5, 4.0) with an acidity regulator (monosodium fumarate) for obtaining low glycemic index (GI) BHBSNs, and the changes in the in vitro starch digestion, free phenolic content, and α-amylase activity in BHBSNs were investigated. The estimated glycemic index (eGI) of BHBSNs decreased from 59.23 to 52.59, 53.89 and 53.61, respectively, as the pH was adjusted from 6.0 to 5.0, 4.5, 4.0. As the pH of BHBSNs decreased, the equilibrium hydrolysis (C∞) decreased, and kinetic coefficient (k) decreased and then increased. Compared to the control, the pH of the digestive fluid decreased during digestion with decreasing pH, and the α-amylase inhibition of BHBSNs with pH 5.0, 4.5, and 4.0 increased by 56.54 %, 75.18 %, and 107.98 %, respectively. In addition, as the pH of BHBSNs decreased, the free phenolic content and the content of released phenolics during digestion increased. Pearson correlations analysis showed that the increase in α-amylase inhibition and phenolic release during digestion induced by acidic pH was negatively correlated with the eGI and C∞ of BHBSNs. This study indicated that acidic pH condition could modulate starch digestion for preparing low GI BHBSNs.

Effects of wheat protein on hot-extrusion 3D-printing performance and the release behaviours of caffeic acid-loaded wheat starch.

In this study, the effects of wheat protein (WP) on the hot-extrusion 3D-printing (HE-3DP) performance of wheat starch (WS) gels, as well as effects of such gels on the encapsulation of caffeic acid, were investigated for the first time. The HE-3DP results show that the addition of WP can reduce print-line width and improve printing accuracy and fidelity, and the best printing results were achieved when using gels with 10 % WP. The rheological results show that WP reduced the gels' linear viscoelastic region (LVR), yield stress (τy), flow stress (τf) and consistency factor (K) but increased their structural recovery rate, which facilitated smooth extrusion during 3D printing and, thus, improved printing accuracy. The analysis of X-ray diffraction and small-angle X-ray scattering indicates that adding WP to WS could increase the mass fractal dimension and lead to denser gel network structures. The results regarding release kinetics demonstrate that the maximum release of caffeic acid from gels decreased by 28 % with the addition of WP, indicating slow-release behaviour. This study provided valuable information about processing wheat products via 3D printing.