RESUMEN
In this work, we demonstrate a full process for fabricating high aspect ratio diffraction optics for extreme ultraviolet lithography. The transmissive optics consists in nanometer scale tungsten patterns standing on flat, ultrathin (100 nm) and highly transparent (>85% at 13.5 nm) silicon membranes (diameter of 1 mm). These tungsten patterns were achieved using an innovative pseudo-Bosch etching process based on an inductively coupled plasma ignited in a mixture of SF6 and C4F8. Circular ultra-thin Si membranes were fabricated through a state-of-the-art method using direct-bonding with thermal difference. The silicon membranes were sputter-coated with a few hundred nanometers (100-300 nm) of stress-controlled tungsten and a very thin layer of chromium. Nanoscale features were written in a thin resist layer by electron beam lithography and transferred onto tungsten by plasma etching of both the chromium hard mask and the tungsten layer. This etching process results in highly anisotropic tungsten features at room temperature. The homogeneity and the aspect ratio of the advanced pattern transfer on the membranes were characterized with scanning electron microscopy after focus ion beam milling. An aspect ratio of about 6 for 35 nm size pattern is successfully obtained on a 1 mm diameter 100 nm thick Si membrane. The whole fabrication process is fully compatible with standard industrial semiconductor technology.
RESUMEN
We report modal phase matched (MPM) second harmonic generation (SHG) in high-index contrast AlGaAs sub-micron ridge waveguides, by way of sub-mW continuous wave powers at telecommunication wavelengths. We achieve an experimental normalized conversion efficiency of ~14%/W/cm2, obtained through a careful sub-wavelength design supporting both the phase matching requirement and a significant overlap efficiency. Furthermore, the weak anomalous dispersion, robust fabrication technology and possible geometrical and thermal tuning of the device functionality enable a fully integrated multi-functional chip for several critical areas in telecommunications, including wavelength (time) division multiplexing and quantum entanglement.
Asunto(s)
Compuestos de Aluminio/química , Arsenicales/química , Galio/química , Dispositivos Ópticos , Óptica y Fotónica/instrumentación , Láseres de Colorantes , Luz , Materiales Manufacturados , Modelos Teóricos , Óptica y Fotónica/métodos , SemiconductoresRESUMEN
Controlled laboratory studies have shown that a novel spot-on formulation containing 20% (w/v) metaflumizone (ProMeris for Cats, Fort Dodge Animal Health, Overland Park, KS) is effective for the treatment and control of fleas on cats. Two studies were conducted to determine the distribution of metaflumizone in the plasma and hair of cats following treatment at the minimum recommended dose of 40mg/kg. Six purpose-bred cats, three males and three females, were used in each study. Plasma or hair samples were collected from each cat just prior to dosing and periodically through 56 days after treatment. Samples were analyzed by HPLC methods validated for the determination of metaflumizone. Metaflumizone concentrations in plasma were below the method limit of quantification (<50ng/ml) in all samples but one, and were frequently not detectable (<1.1ng/ml). Plasma collected 3 days post-treatment from one cat had a metaflumizone concentration of 57.8ng/ml. The frequency of measurable levels of metaflumizone in the plasma was too low to allow the calculation of pharmacokinetic parameters. Analysis of hair samples indicated that metaflumizone was widely distributed in the hair coat of the cat within 1 day after administration, reaching maximum concentrations within 1 or 2 days post-treatment. Low but quantifiable levels were still present at the end of the 56-day study. Data from the present studies indicate that the ectoparasitic activity is due to exposure of the parasites to metaflumizone on the surface of the host (skin and hair), not to exposure via the circulatory system of the host.