High-performance coded aperture gamma camera based on monolithic GAGG:Ce crystal.

A 50 × 50 × 10 mm3 monolithic gadolinium aluminum gallium garnet (Gd3Al2Ga3O12; GAGG):Ce crystal coupled to a 8 × 8 silicon photomultiplier (SiPM) array was developed; it showed very good system uniformity and a high energy resolution of 7.4% at 662 keV. By using a convolutional neural network-based positioning algorithm and a fan-beam calibration method, the detector achieved a position resolution of ∼1.4 mm and a depth of interaction resolution of ∼2 mm. Based on this high-performance monolithic detector, we developed a coded aperture gamma camera. A 1-mCi Cs-137 source centered at a 2-m distance from the mask could be reconstructed with a signal-to-noise ratio of 6.5 in 1 s. Furthermore, the imaging ability of a low-energy Am-241 source and a low-activity Cs-137 source when the background-to-signal ratio was approximately 1:1 and a double low-activity source (Cs-137 and Na-22) was demonstrated. It is shown that the monolithic-crystal-based coded aperture gamma camera can achieve high performance and has a large potential for further improvement.

A scintillating plastic fiber array and multiplexer based 384-channel fast neutron spectrometer.

A fast neutron detection system based on a scintillating plastic fiber array and multiplexer was designed to measure the spectrum of fast neutrons ranged 10 MeV-100 MeV. With the method of nuclear recoil, the energy of incident neutron was determined by measuring the recoil proton track and deposited energy in scintillating plastic fibers. The detection system was composed of a scintillating plastic fiber array, 6 position sensitive photomultiplier tubes, and a high-density readout electronics based on the multiplexer. The scintillating plastic fiber array was made as a staggered structure with two kinds of fibers in different sizes (0.5 mm-square fiber and 3 mm-square fiber). The structure provided a wider detection energy range and better detection efficiency than arrays made with uniform plastic fibers. A dedicated digital electronics system was well designed to control the whole readout system to provide 384-channel signal processing. The detector had a 48 mm × 48 mm effective detection area and a mechanical size of 34 cm × 34 cm × 27 cm. In the simulation of the detector model performance, the system gave an energy resolution of 23%-35% for neutrons ranged 10 MeV-100 MeV. Experimental results showed that the detector had a good energy linearity and energy resolutions were, respectively, 35.82% at 14.817 MeV, 36.84% at 21.264 MeV, 35.90% at 23.069 MeV, and 32.90% at 24.220 MeV. The optimized prototype model had potential in increasing fast neutron detection performance.

7T transmit/receive arrays using ICE decoupling for human head MR imaging.

In designing large-sized volume type phased array coils for human head imaging at ultrahigh fields, e.g., 7T, minimizing electromagnetic coupling among array elements is technically challenging. A new decoupling method based on induced current compensation or elimination (ICE) for a microstrip line planar array has recently been proposed. In this study, an eight-channel transmit/receive volume array with ICE-decoupled loop elements was built and investigated to demonstrate its feasibility and robustness for human head imaging at 7T. Isolation between adjacent loop elements was better than - 25 dB with a human head load. The worst-case of the isolation between all of the elements was about - 17.5 dB. All of the MRI experiments were performed on a 7T whole-body human MR scanner. Images of the phantom and human head were acquired and g-factor maps were measured and calculated to evaluate the performance of the coil array. Compared with the conventional capacitively decoupled array, the ICE-decoupled array demonstrated improved parallel imaging ability and had a higher SNR. The experimental results indicate that the transceiver array design with ICE decoupling technique might be a promising solution to designing high performance transmit/receive coil arrays for human head imaging at ultrahigh fields.

Depth discrimination method based on a multirow linear array detector for push-broom Compton scatter imaging.

A depth discrimination method is devised based on a multirow linear array detector for push-broom Compton scatter imaging. Two or more rows of detector modules are placed at different positions towards a sample. An improved parallel-hole collimator is fixed in front of the modules to restrict their fields of view. The depth information could be indicated by comparing the signal differences. In addition, an available detector and several related simulations using GEANT4 are given to support the method well.