RESUMEN
Patellofemoral dysfunction, due to either a patellofemoral malalignment or patellar instability, is a complex and debilitating condition that significantly decreases the knee function. Conservative management may yield significant clinical outcomes; however, when morphologic anomalies are identified, the surgical approach should be employed. Hence, several surgical procedures have been described in the scientific literature aiming the correction of underlying extensor mechanism malalignments. Still, the rate of complications is higher than desirable. The described technique is based on the principles of transferring the tibial tubercle medially as described in the Elmslie-Trillat technique. However, a curvilinear horizontal cut is made prior to the vertical cut, which raises a thick osseous fragment and allows the formation of a gutter when the osseous fragment is moved medially. Whereas the horizontal gutter provides stability to the bone fragment, the thicker dimension of the osseous fragment and retention of the distal attachment significantly enhances the osteotomy union. Hence, adequate pain relief and stability with very low postoperative morbidity could be achieved. The purpose of this surgical note is to describe a modification to the Elmslie-Trillat technique to treat patellofemoral dysfunctions, achieving a higher osseous stability and decreased postoperative morbidity.
RESUMEN
Patellar tendon ruptures can lead to significant functional deficiency of the extensor mechanism of the knee. These injuries, because of their inherent nature and associated complications, may require a complex treatment and remains a challenge for orthopaedic surgeons. Current surgical techniques present significant complications, including patellar fracture, damage to patellar articular cartilage, and abnormal patella height. This note describes a surgical technique to provide an additional reinforcement to the patellar tendon repair with a semitendinous autograft, without the necessity to perform any transosseous tunnels at the patella bone. First, the patellar tendon is repaired with an end-to-end technique and the semitendinous tendon is harvested. A transosseous tunnel at the tibial tubercle is drilled and 2 rents are made, both medial and lateral to the retinaculum at the level of the intermedial segment of the patella close to the patellar margin. The graft is passed through the tunnel and rents in a U-shaped form. The graft is sutured along the length of the patellar tendon on both margins in tension at 30° of knee flexion. Fluoroscopy imaging is performed to assess the patella height. This technique provides a significant augmentation of patellar tendon, avoiding the potential patella bone tunnel complications.
RESUMEN
There are promising results in the use of platelet-rich plasma (PRP) for musculoskeletal tissue repair. However, the variability in the methodology for its obtaining may cause different and opposing findings in the literature. Particularly, the choice of the anticoagulant is the first definition to be made. In this work, blood was collected with sodium citrate (SC), ethylenediaminetetraacetic acid (EDTA), or anticoagulant citrate dextrose (ACD) solution A, as anticoagulants, prior to PRP obtaining. Hematological analysis and growth factors release quantification were performed, and the effects on mesenchymal stromal cell (MSC) culture, such as cytotoxicity and cell proliferation (evaluated by MTT method) and gene expression, were evaluated. The use of EDTA resulted in higher platelet yield in whole blood; however, it induced an increase in the mean platelet volume (MPV) following the blood centrifugation steps for PRP obtaining. The use of SC and ACD resulted in higher induction of MSC proliferation. On the other hand, PRP obtained in SC presented the higher platelet recovery after the blood first centrifugation step and a minimal change in MSC gene expression. Therefore, we suggest the use of SC as the anticoagulant for PRP obtaining.
