Assessment of the Feasibility of Converting the Liquid Fraction Separated from Fruit and Vegetable Waste in a UASB Digester.

Anaerobic digestion of food waste still faces important challenges despite its world-wide application. An important fraction of food waste is composed of organic material having a low hydrolysis rate and which is often not degraded in digesters. The addition of this less hydrolysable fraction into anaerobic digesters requires a longer hydraulic residence time, and therefore leads to oversizing of the digesters. To overcome this problem, the conversion of the highly biodegradable liquid fraction from fruit and vegetable waste in a up-flow anaerobic sludge blanket (UASB) digester is proposed and demonstrated. The more easily biodegradable fraction of the waste is concentrated in the liquid phase using a 2-stage screw press separation. Then, this liquid fraction is digested in a 3.5 L UASB digester at a high organic loading rate. A good and stable performance was observed up to an organic loading rate (OLR) of 12 g COD/(Lrx.d), with a specific methane production of 2.6 L CH4/(Lrx.d) and a degradation of 85% of the initial total COD. Compared to the conversion of the same initial waste with a continuously stirred tank reactor (CSTR), this new treatment strategy leads to 10% lower COD degradation, but can produce the same amount of methane with a digester that is twice as small. The scale-up of this process could contribute to reduced costs related to the anaerobic digestion of food waste, while reducing management efforts associated with digestate handling and increasing process stability at high organic loading rates.

Towards a standardization of biomethane potential tests.

Production of biogas from different organic materials is a most interesting source of renewable energy. The biomethane potential (BMP) of these materials has to be determined to get insight in design parameters for anaerobic digesters. Although several norms and guidelines for BMP tests exist, inter-laboratory tests regularly show high variability of BMPs for the same substrate. A workshop was held in June 2015, in Leysin, Switzerland, with over 40 attendees from 30 laboratories around the world, to agree on common solutions to the conundrum of inconsistent BMP test results. This paper presents the consensus of the intense roundtable discussions and cross-comparison of methodologies used in respective laboratories. Compulsory elements for the validation of BMP results were defined. They include the minimal number of replicates, the request to carry out blank and positive control assays, a criterion for the test duration, details on BMP calculation, and last but not least criteria for rejection of the BMP tests. Finally, recommendations on items that strongly influence the outcome of BMP tests such as inoculum characteristics, substrate preparation, test setup, and data analysis are presented to increase the probability of obtaining validated and reproducible results.

Acidogenic fermentation of Scenedesmus sp.-AMDD: Comparison of volatile fatty acids yields between mesophilic and thermophilic conditions.

This study compared the acidogenic fermentation of Scenedesmus sp.-AMDD at laboratory-scale, under mesophilic (35°C) and thermophilic conditions (55°C). Preliminary batch tests were performed to evaluate best conditions for volatile fatty acid (VFA) production from microalgal biomass, with respect to the inoculum, pH and nutrients. The use of bovine manure as inoculum, the operating pH of 4.5 and the addition of a nutrient mix, resulted in a high VFA production of up to 222mgg(-1) total volatile solid (TVS), with a butyrate share of 27%. Both digesters displayed similar hydrolytic activity with 0.38±0.02 and 0.42±0.03 g soluble chemical oxygen demand (COD)g(-1) TVS for the digesters operated at 35 and 55°C, respectively. Mesophilic conditions were more favorable for VFA production, which reached 171±5, compared to 88±12 mg soluble CODg(-1) TVS added under thermophilic conditions (94% more). It was shown that in both digesters, butyrate was the predominant VFA.

Harmonization of the quantitative determination of volatile fatty acids profile in aqueous matrix samples by direct injection using gas chromatography and high-performance liquid chromatography techniques: Multi-laboratory validation study.

The performance parameters of volatile fatty acids (VFAs) measurements were assessed for the first time by a multi-laboratory validation study among 13 laboratories. Two chromatographic techniques (GC and HPLC) and two quantification methods such as external and internal standard (ESTD/ISTD) were combined in three different methodologies GC/ESTD, HPLC/ESTD and GC/ISTD. Linearity evaluation of the calibration functions in a wide concentration range (10-1000mg/L) was carried out using different statistical parameters for the goodness of fit. Both chromatographic techniques were considered similarly accurate. The use of GC/ISTD, despite showing similar analytical performance to the other methodologies, can be considered useful for the harmonization of VFAs analytical methodology taking into account the normalization of slope values used for the calculation of VFAs concentrations. Acceptance criteria for VFAs performance parameters of the multi-laboratory validation study should be established as follows: (1) instrument precision (RSDINST≤1.5%); (2) linearity (R(2)≥0.998; RSDSENSITIVITY≤4%; REMAX≤8%; REAVER≤ 3%); (3) precision (RSD≤1.5%); (4) trueness (recovery of 97-103%); (5) LOD (≤3mg/L); and (6) LOQ (10mg/L).

Anaerobic co-digestion of dairy manure with mulched switchgrass for improvement of the methane yield.

The owners of farm-scale anaerobic digesters are relying on off-farm wastes or energy crops as a co-digestion feedstock with animal manure in order to increase their production of methane and thus revenues. Switchgrass represents an interesting feedstock for Canadian digesters owners as it is a high-yielding low-maintenance perennial crop, well adapted to northern climate. Methane potential assays in batch tests showed methane production of 19.4 ± 3.6, 28.3 ± 1.7, 37.3 ± 7.1 and 45.7 ± 0.8 L kg(-1), for raw manure, blended manure, manure and mulched switchgrass, manure and pretreated switchgrass, respectively. Two 6-L lab-scale anaerobic digesters were operated for 130 days in order to assess the benefit of co-digesting switchgrass with bovine manure (digester #2), at a 20% wet mass fraction, compared with a manure-only operation (digester #1) The digesters were operated at an hydraulic retention time of 37 ± 6 days and at loads of 2.4 ± 0.6 and 2.6 ± 0.6 kg total volatile solids (TVS) L(-1) day(-1) for digesters #1 (D1) and #2 (D2), respectively. The TVS degradation reached 25 and 39%, which resulted in a methane production of 1.18 ± 0.18 and 2.19 ± 0.31 L day(-1) for D1 and D2, respectively. The addition of 20% on a wet mass ratio of switchgrass to a manure digester increased its methane production by 86%. The co-digestion of switchgrass in a 500 m(3) manure digester could yield up to 10.2 GJ day(-1) of purified methane or 1.1 MWh day(-1) of electricity.

Integration of microalgae cultivation with industrial waste remediation for biofuel and bioenergy production: opportunities and limitations.

There is currently a renewed interest in developing microalgae as a source of renewable energy and fuel. Microalgae hold great potential as a source of biomass for the production of energy and fungible liquid transportation fuels. However, the technologies required for large-scale cultivation, processing, and conversion of microalgal biomass to energy products are underdeveloped. Microalgae offer several advantages over traditional 'first-generation' biofuels crops like corn: these include superior biomass productivity, the ability to grow on poor-quality land unsuitable for agriculture, and the potential for sustainable growth by extracting macro- and micronutrients from wastewater and industrial flue-stack emissions. Integrating microalgal cultivation with municipal wastewater treatment and industrial CO(2) emissions from coal-fired power plants is a potential strategy to produce large quantities of biomass, and represents an opportunity to develop, test, and optimize the necessary technologies to make microalgal biofuels more cost-effective and efficient. However, many constraints on the eventual deployment of this technology must be taken into consideration and mitigating strategies developed before large scale microalgal cultivation can become a reality. As a strategy for CO(2) biomitigation from industrial point source emitters, microalgal cultivation can be limited by the availability of land, light, and other nutrients like N and P. Effective removal of N and P from municipal wastewater is limited by the processing capacity of available microalgal cultivation systems. Strategies to mitigate against the constraints are discussed.

Comparison of treatment efficacy and stability of microbial populations between raw and anaerobically treated liquid pig manure, using PCR-DGGE and 16S sequencing.

The effects of adding an adapted inoculum to liquid pig manure (LPM) prior to anaerobic digestion were evaluated by standard analytical methods. In parallel, the phylogenetic diversity of the microbial community of raw and anaerobically digested pig manure was studied by both denaturing gradient gel electrophoresis (DGGE) and sequence analysis of 16S rRNA fragments amplified by polymerase chain reaction. Gas production, volative fatty acid production, removal of soluble chemical oxygen demand, and removal of volatile soluble solids were measured on raw and on inoculated liquid pig manure subjected to anaerobic digestion. DGGE profiles of 16S rRNA genes were used to compare the major elements of the bacterial community composition in raw LPM with those present under various incubation conditions. Major bands were excised and sequenced to gain insight into the identities of the bacterial populations from LPM treated under different conditions. The results show that the addition of an adapted inoculum did not have a major impact on the conversion of pig manure into soluble organic matter and did not significantly change the microbial populations present during anaerobic digestion of LPM. Bacterial composition also indicated that Clostridium species are important constituents of the LPM community.

Combining photolysis and bioprocesses for mineralization of high molecular weight polyacrylamides.

The influence of ultraviolet photolysis as a pretreatment to the aerobic and anaerobic biological mineralization of a 14C-polyacrylamide was assessed using a series of radiorespirometry bioassays. The polyacrylamide studied was non-ionic with molecular weights ranging between 100,000 and 1 million. Aerobic and anaerobic biomineralization of the unphotolysed (raw) polyacrylamide was found to be only 0.60% and 0.70%, respectively, after 6 weeks of incubation, and hence indicative of the natural recalcitrance of polyacrylamide to microbial degradation. The effectiveness of UV irradiation in the physical breakdown of the polyacrylamide chain into oligomers was demonstrated by the shift in the molecular weight distribution and the positive correlation between the time of irradiation and the degree of its biological mineralization. The molecular weight fraction below 3 kD, which represents only 2% of the raw polyacrylamide, was increased to 41, 60 and 80% after 12, 24 and 48 hours of photolysis, respectively. This in turn, yielded, after 6 weeks of incubation, an aerobic mineralization of 5, 17 and 29% of 150 mg/L polyacrylamide, respectively, and an anaerobic mineralization of 3, 5 and 17%, respectively. Biomass acclimation substantially improved the specific initial rate of biomineralization of the photolysed polyacrylamides, but not the overall percentage of polyacrylamides mineralized.