[Acute Postoperative Negative Pressure Pulmonary Edema Caused by the Compression of Brachiocephalic Artery].

We report a case of negative-pressure pulmonary edema occurring by tracheal obstruction caused by the brachiocephalic artery. The patient had deformed thorax with cerebral palsy, which deformed thorax placing the brachiocephalic artery high over the trachea, resulting in close and tight contact between the artery and trachea. Additional deformity of the thorax associated with myotonic attacks after general anesthesia might shorten the distance between the sternal notch and the vertebral body, resulting in the tracheal obstruction by the artery.

Silica-sol-based spin-coating barrier layer against phosphorous diffusion for crystalline silicon solar cells.

The phosphorus barrier layers at the doping procedure of silicon wafers were fabricated using a spin-coating method with a mixture of silica-sol and tetramethylammonium hydroxide, which can be formed at the rear surface prior to the front phosphorus spin-on-demand (SOD) diffusion and directly annealed simultaneously with the front phosphorus layer. The optimization of coating thickness was obtained by changing the applied spin-coating speed; from 2,000 to 8,000 rpm. The CZ-Si p-type silicon solar cells were fabricated with/without using the rear silica-sol layer after taking the sheet resistance measurements, SIMS analysis, and SEM measurements of the silica-sol material evaluations into consideration. For the fabrication of solar cells, a spin-coating phosphorus source was used to form the n(+) emitter and was then diffused at 930°C for 35 min. The out-gas diffusion of phosphorus could be completely prevented by spin-coated silica-sol film placed on the rear side of the wafers coated prior to the diffusion process. A roughly 2% improvement in the conversion efficiency was observed when silica-sol was utilized during the phosphorus diffusion step. These results can suggest that the silica-sol material can be an attractive candidate for low-cost and easily applicable spin-coating barrier for any masking purpose involving phosphorus diffusion.

Analysis of photodecomposition of gaseous chlorobenzene by KrF excimer laser.

Gaseous monochlorobenzene was irradiated with KrF excimer laser (248 nm) under reduced pressure. The photodecomposition was an apparent first order reaction. When the system contained no additive gas, the photolysis was found to give benzene (conversion yield: 49%) in the gas phase and many unidentified products in the solid phase. On the other hand, in the presence of oxygen, carbon dioxide (10%), carbon monoxide (16%), hydrogen chloride (52%) and acetylene (2%) are produced and the peaks shown on the gas chromatogram of the solid phase were effectively suppressed.