Towards European automatic bioaerosol monitoring: Comparison of 9 automatic pollen observational instruments with classic Hirst-type traps.

To benefit allergy patients and the medical practitioners, pollen information should be available in both a reliable and timely manner; the latter is only recently possible due to automatic monitoring. To evaluate the performance of all currently available automatic instruments, an international intercomparison campaign was jointly organised by the EUMETNET AutoPollen Programme and the ADOPT COST Action in Munich, Germany (March-July 2021). The automatic systems (hardware plus identification algorithms) were compared with manual Hirst-type traps. Measurements were aggregated into 3-hourly or daily values to allow comparison across all devices. We report results for total pollen as well as for Betula, Fraxinus, Poaceae, and Quercus, for all instruments that provided these data. The results for daily averages compared better with Hirst observations than the 3-hourly values. For total pollen, there was a considerable spread among systems, with some reaching R2 > 0.6 (3 h) and R2 > 0.75 (daily) compared with Hirst-type traps, whilst other systems were not suitable to sample total pollen efficiently (R2 < 0.3). For individual pollen types, results similar to the Hirst were frequently shown by a small group of systems. For Betula, almost all systems performed well (R2 > 0.75 for 9 systems for 3-hourly data). Results for Fraxinus and Quercus were not as good for most systems, while for Poaceae (with some exceptions), the performance was weakest. For all pollen types and for most measurement systems, false positive classifications were observed outside of the main pollen season. Different algorithms applied to the same device also showed different results, highlighting the importance of this aspect of the measurement system. Overall, given the 30 % error on daily concentrations that is currently accepted for Hirst-type traps, several automatic systems are currently capable of being used operationally to provide real-time observations at high temporal resolutions. They provide distinct advantages compared to the manual Hirst-type measurements.

Alternaria spore exposure in Bavaria, Germany, measured using artificial intelligence algorithms in a network of BAA500 automatic pollen monitors.

Although Alternaria spores are well-known allergenic fungal spores, automatic bioaerosol recognition systems have not been trained to recognize these particles until now. Here we report the development of a new algorithm able to classify Alternaria spores with BAA500 automatic bioaerosol monitors. The best validation score was obtained when the model was trained on both data from the original dataset and artificially generated images, with a validation unweighted mean Intersection over Union (IoU), also called Jaccard Index, of 0.95. Data augmentation techniques were applied to the training set. While some particles were not recognized (false negatives), false positives were few. The results correlated well with manual counts (mean of four Hirst-type traps), with R2 = 0.78. Counts from BAA500 were 1.92 times lower than with Hirst-type traps. The algorithm was then used to re-analyze the historical automatic pollen monitoring network (ePIN) dataset (2018-2022), which lacked Alternaria spore counts. Re-analysis of past data showed that Alternaria spore exposure in Bavaria was very variable, with the highest counts in the North (Marktheidenfeld, 154 m a.s.l.), and the lowest values close to the mountains in the South (Garmisch-Partenkirchen, 735 m a.s.l.). This approach shows that in our network future algorithms can be run on past datasets. Over time, the use of different algorithms could lead to misinterpretations as stemming from climate change or other phenological causes. Our approach enables consistent, homogeneous treatment of long-term series, thus preventing variability in particle counts owing to changes in the algorithms.

Environmental drivers of the seasonal exposure to airborne Alternaria spores in Spain.

Alternaria conidia have high allergenic potential and they can trigger important respiratory diseases. Due to that and to their extensive detection period, airborne Alternaria spores are considered as a relevant airborne allergenic particle. Several studies have been developed in order to predict the human exposure to this aeroallergen and to prevent their negative effects on sensitive population. These studies revealed that some sampling locations usually have just one single Alternaria spore season while other locations generally have two seasons within the same year. However, the reasons of these two different seasonal patterns remain unclear. To understand them better, the present study was carried out in order to determine if there are any weather conditions that influence these different behaviours at different sampling locations. With this purpose, the airborne Alternaria spore concentrations of 18 sampling locations in a wide range of latitudinal, altitudinal and climate ranges of Spain were studied. The aerobiological samples were obtained by means of Hirst-Type volumetric pollen traps, and the seasonality of the airborne Alternaria spores were analysed. The optimal weather conditions for spore production were studied, and the main weather factor affecting Alternaria spore seasonality were analysed by means of random forests and regression trees. The results showed that the temperature was the most relevant variable for the Alternaria spore dispersion and it influenced both the spore integrals and their seasonality. The water availability was also a very significant variable. Warmer sampling locations generally have a longer period of Alternaria spore detection. However, the spore production declines during the summer when the temperatures are extremely warm, what splits the favourable period for Alternaria spore production and dispersion into two separate ones, detected as two Alternaria spore seasons within the same year.