RESUMEN
In this paper, we present the results of mechanical measurement of single nanowires (NWs) in a repeatable manner. Substrates with specifically designed mechanical features were used for NW placement and localization for measurements of properties such as Young's modulus or tensile strength of NW with an atomic force microscopy (AFM) system. Dense arrays of zinc oxide (ZnO) nanowires were obtained by one-step anodic oxidation of metallic Zn foil in a sodium bicarbonate electrolyte and thermal post-treatment. ZnO NWs with a hexagonal wurtzite structure were fixed to the substrates using focused electron beam-induced deposition (FEBID) and were annealed at different temperatures in situ. We show a 10-fold change in the properties of annealed materials as well as a difference in the properties of the NW materials from their bulk values with pre-annealed Young modulus at the level of 20 GPa and annealed reaching 200 GPa. We found the newly developed method to be much more versatile, allowing for in situ operations of NWs, including measurements with different methods of scanning probe microscopy.
RESUMEN
The measurement method, which utilizes nanomanipulation of the nanowires onto a specially prepared substrate, was presented. It introduced a four-point resistance measurement setup on a chip suited for scanning probe microscopy measurements, integrating connectors and a nanowire specimen. A study on the resistance and resistivity of the thermally post-treated ZnO nanowires at 200 °C and 300 °C in air showed the dependence of these electrical parameters on the annealing temperature. The investigations of the electrical properties of blocks built on the basis of nanowires and their related devices could provide a useful guide not only for designing, fabricating and optimizing electromechanical nanodevices based on nanowires but also for their safe operation in future electronic applications.
RESUMEN
We have examined the influence of flake-substrate effects that affect one and few layers of MoS2 in terms of their electrical and optical properties. In the measurements, we used SiO2/Si substrates with etched cavities and aluminum electrodes. Suspended areas are easily identifiable both on images depicting the topography and on the surface potential maps measured with the Kelvin probe force microscopy. Compared to the SiO2/Si supported material, surface potential decrease is observable at the membrane. The surface potential value of the flakes located on the electrodes is the lowest. PL measurements prove that single MoS2 monolayer was obtained. Suspended regions are also correlated with maps obtained as a result of Raman spectroscopy.