Altered motor cortical plasticity in patients with hepatic encephalopathy: A paired associative stimulation study.

OBJECTIVE: Hepatic encephalopathy (HE) is a potentially reversible brain dysfunction caused by liver failure. Altered synaptic plasticity is supposed to play a major role in the pathophysiology of HE. Here, we used paired associative stimulation with an inter-stimulus interval of 25 ms (PAS25), a transcranial magnetic stimulation (TMS) protocol, to test synaptic plasticity of the motor cortex in patients with manifest HE. METHODS: 23 HE-patients and 23 healthy controls were enrolled in the study. Motor evoked potential (MEP) amplitudes were assessed as measure for cortical excitability. Time courses of MEP amplitude changes after the PAS25 intervention were compared between both groups. RESULTS: MEP-amplitudes increased after PAS25 in the control group, indicating PAS25-induced synaptic plasticity in healthy controls, as expected. In contrast, MEP-amplitudes within the HE group did not change and were lower than in the control group, indicating no induction of plasticity. CONCLUSIONS: Our study revealed reduced synaptic plasticity of the primary motor cortex in HE. SIGNIFICANCE: Reduced synaptic plasticity in HE provides a link between pathological changes on the molecular level and early clinical symptoms of the disease. This decrease may be caused by disturbances in the glutamatergic neurotransmission due to the known hyperammonemia in HE patients.

Influence of High Pass Filter Settings on Motor Evoked Potentials.

OBJECTIVE: Motor evoked potentials (MEP), obtained by transcranial magnetic stimulation (TMS) are a common tool in clinical research and diagnostic. Nevertheless, reports regarding the influence of filter settings on MEP are sparse. Here, we compared MEP amplitudes and signal to noise ratio (SNR) using multiple high pass filter (HPF) and notch filter settings. MATERIALS AND METHODS: Twenty healthy subjects were enrolled in the study. Recruitment curves were obtained with HPF settings varied at 10, 20, 50, and 100 Hz. The four HPF settings were tested both with and without 50 Hz active notch filter. Low pass filter was kept constant at 5 kHz. RESULTS: MEP amplitudes with HPF at 10 and 20 Hz were significantly higher than at 100 Hz, regardless of the notch filter. However, SNR did not differ among HPF settings. An active notch filter significantly improved SNR. CONCLUSION: The reduction in MEP amplitudes with HPF above 20 Hz may be due to noise reduction, since the different HPF conditions did not alter SNR. Thus, higher HPF above 50 Hz may be an option to reduce noise, the use of a notch filter may even improve SNR. SIGNIFICANCE: Our findings are relevant for the selection of filter settings and might be of importance to any researcher who utilizes TMS-MEP.

Impact of the number of conditioning pulses on motor cortex excitability: a transcranial magnetic stimulation study.

Conditioning transcranial magnetic stimulation (TMS) with subthreshold conditioning stimulus followed by supra-threshold test stimulus at inter-stimulus intervals (ISI) of 1-5 ms results in inhibition (SICI), while ISI at 10-15 ms results in facilitation (ICF). One concerning issue, applying ICF/SICI protocols on patients is the substantial protocol variability. Here, we hypothesized that increasing the number of CS could result in more robust ICF/SICI protocols. Twenty healthy subjects participated in the study. Motor-evoked potentials (MEP) were obtained from conditioning TMS with a varying number of conditioning stimuli in 3, 4, 10, and 15 ms ISI over the primary motor cortex. MEP amplitudes were then compared to examine excitability. TMS with 3, 5, and 7 conditioning stimuli but not with one conditioning stimulus induced ICF. Moreover, 10 ms ISI produced stronger ICF than 15 ms ISI. Significant SICI was only induced with one conditioning stimulus. Besides, 3 ms ISI resulted in stronger SICI than 4 ms ISI. Only a train of conditioning stimuli induced stable ICF and may be more advantageous than the classical paired pulse ICF paradigm.

Computational modelling approach for the optimization of apple juice clarification using immobilized pectinase and xylanase enzymes.

Apple juice is typically marketed as a clear juice, and hence enzymatic treatments are common practices in juice industry. However, enzymatic treatments have been shown to face some challenges when process efficiency, and cost effectiveness are concerned. Therefore, it is necessary to optimize the enzymatic treatment process to maximize efficiency, and reuse enzymes to minimize the overall cost via immobilization. In this context, the present work features the immobilization of pectinase and xylanase from M. hiemalis on genipin-activated alginate beads, with subsequent evaluation of its efficacy in apple juice clarification. A central composite rotatable design (CCRD), coupled with artificial neural network (ANN) for modeling and optimization was used to design the experiments. Deploying a coupling time up to 120 min, and an agitation rate of 213 rpm (pectinase) - 250 rpm (xylanase), a maximum fractional enzyme activity recovered was observed to be about 81-83% for both enzymes. Optimum enzyme loading and genipin concentration were found to be 50 U/ml and 12% (w/v), respectively. The immobilized enzyme preparations were suitable for up to 5 repeated process cycles, losing about 45% (pectinase) - 49% (xylanase) of their initial activity during this time. The maximum clarity of apple juice (%T660, 84%) was achieved at 100 min when pectinase (50 U/ml of juice) and xylanase (20 U/ml of juice) were used in combination at 57 °C. The immobilized enzymes are of industrial relevance in terms of biocompatibility, recoverability, and operational-storage stability.

An evaluation of sonication pretreatment for enhancing saccharification of brewers' spent grain.

This paper deals with the investigation of ultrasound (US) pretreatment of brewer's spent grain (BSG) as a means of releasing fermentable sugars, and the subsequent production of ethanol from this lignocellulosic biomass. Using response surface methodology (RSM), the influence of US power, time, temperature and biomass loading on fermentable sugar yield from BSG was studied. The optimal conditions were found to be 20% US power, 60 min, 26.3 °C, and 17.3% w/v of biomass in water. Under these conditions, an approximate 2.1-fold increase in reducing sugar yield (325 ± 6 mg/g of biomass) was achieved, relative to untreated BSG (151.1 ± 10 mg/g of biomass). In contrast to acid or alkaline pretreatment approaches, the use of water obviated the need for neutralization for the recovery of sugars. The characterization of native and pretreated BSG was performed by HPLC, FTIR, SEM and DSC. Fermentation studies using S. cerevisiae growing on pretreated BSG resulted in a conversion of 66% of the total sugar content ininto ethanol with an ethanol content of 17.73 ± 2 g/ 100 g of pretreated BSG. These results suggest that ultrasound pretreatment is a promising technology for increased valorization of BSG as a feedstock for production of bioethanol, and points ton the need for further work in this area.

Cerebellar Involvement in DYT-THAP1 Dystonia.

DYT-THAP1 dystonia is known to present a variety of clinical symptoms. To the best of our knowledge, this is the first case with DYT-THAP 1 dystonia and clinical signs of cerebellar involvement studied with transcranial magnetic stimulation in vivo. We report a case of a 51-year-old male DYT-THAP1 mutation carrier with dystonia, who additionally developed ataxia 1.5 years ago. To study cerebellar involvement in our patient, we used a TMS protocol called cerebellar inhibition (CBI). The lack of CBI in our patient strongly suggests cerebellar involvement. According to our findings, cerebellar syndrome may be part of the phenotypical spectrum of DYT-THAP1 mutations.

Lignocellulosic Biorefineries in Europe: Current State and Prospects.

Lignocellulosic biorefining processes plant-derived biomass into a range of bio-based products. Currently, more than 40 lignocellulosic biorefineries are operating across Europe. Here, we address the challenges and future opportunities of this nascent industry by elucidating key elements of the biorefining sector, including feedstock sourcing, processing methods, and the bioproducts market.

A Review on Bioconversion of Agro-Industrial Wastes to Industrially Important Enzymes.

Agro-industrial waste is highly nutritious in nature and facilitates microbial growth. Most agricultural wastes are lignocellulosic in nature; a large fraction of it is composed of carbohydrates. Agricultural residues can thus be used for the production of various value-added products, such as industrially important enzymes. Agro-industrial wastes, such as sugar cane bagasse, corn cob and rice bran, have been widely investigated via different fermentation strategies for the production of enzymes. Solid-state fermentation holds much potential compared with submerged fermentation methods for the utilization of agro-based wastes for enzyme production. This is because the physical⁻chemical nature of many lignocellulosic substrates naturally lends itself to solid phase culture, and thereby represents a means to reap the acknowledged potential of this fermentation method. Recent studies have shown that pretreatment technologies can greatly enhance enzyme yields by several fold. This article gives an overview of how agricultural waste can be productively harnessed as a raw material for fermentation. Furthermore, a detailed analysis of studies conducted in the production of different commercially important enzymes using lignocellulosic food waste has been provided.

Emerging technologies for the pretreatment of lignocellulosic biomass.

Pretreatment of lignocellulosic biomass to overcome its intrinsic recalcitrant nature prior to the production of valuable chemicals has been studied for nearly 200 years. Research has targeted eco-friendly, economical and time-effective solutions, together with a simplified large-scale operational approach. Commonly used pretreatment methods, such as chemical, physico-chemical and biological techniques are still insufficient to meet optimal industrial production requirements in a sustainable way. Recently, advances in applied chemistry approaches conducted under extreme and non-classical conditions has led to possible commercial solutions in the marketplace (e.g. High hydrostatic pressure, High pressure homogenizer, Microwave, Ultrasound technologies). These new industrial technologies are promising candidates as sustainable green pretreatment solutions for lignocellulosic biomass utilization in a large scale biorefinery. This article reviews the application of selected emerging technologies such as ionizing and non-ionizing radiation, pulsed electrical field, ultrasound and high pressure as promising technologies in the valorization of lignocellulosic biomass.