RESUMEN
Parkinson's disease (PD) is one of the leading neurological disorders negatively impacting health on a global scale. Patients diagnosed with PD require frequent monitoring, prescribed medications, and therapy for extended periods as symptom severity worsens. The primary pharmaceutical treatment for PD patients is levodopa (L-Dopa) which reduces many symptoms experienced by PD patients (e.g., tremors, cognitive ability, motor dysfunction, etc.) through the regulation of dopamine levels in the body. Herein, the first detection of L-Dopa in human sweat using a low-cost 3D printed sensor with a simple and rapid fabrication protocol combined with a portable potentiostat wirelessly connected to a smartphone via Bluetooth is reported. By combining saponification and electrochemical activation into a single protocol, the optimized 3D printed carbon electrodes were able to simultaneously detect uric acid and L-Dopa throughout their biologically relevant ranges. The optimized sensors provided a sensitivity of 83 ± 3 nA/µM from 24 µM to 300 nM L-Dopa. Common physiological interferents found in sweat (e.g., ascorbic acid, glucose, caffeine) showed no influence on the response for L-Dopa. Lastly, a percent recovery of L-Dopa in human sweat using a smartphone-assisted handheld potentiostat resulted in the recovery of 100 ± 8%, confirming the ability of this sensor to accurately detect L-Dopa in sweat.
Asunto(s)
Levodopa , Enfermedad de Parkinson , Humanos , Sudor , Teléfono Inteligente , Enfermedad de Parkinson/tratamiento farmacológico , Impresión TridimensionalRESUMEN
This technical note describes a method for fabricating ion-selective membranes (ISMs) for use in potentiometric sensing by using 3D printing technology. Here, we demonstrate the versatility of this approach by fabricating ISMs and investigating their performance in both liquid-contact and solid-contact ion-selective electrode (ISE) configurations. Using 3D printed ISMs resulted in highly stable (drift of â¼17 µV/h) and highly reproducible (<1 mV deviation) measurements. Furthermore, we show the seamless translation of these membranes into reliable, carbon fiber- and paper-based potentiometric sensors for applications at the point-of-care. To highlight the modifiability of this approach, we fabricated sensors for bilirubin, an important biomarker of liver health; benzalkonium, a common preservative used in the pharmaceutical industry; and potassium, an important blood electrolyte. The ability to mass produce sensors using 3D printing is an attractive advantage over conventional methods, while also decreasing the time and cost associated with sensor fabrication.