RESUMEN
Organic radicals have been of interest due to their potential to replace nonradical-based organic emitters, especially for deep-red/near-infrared (NIR) electroluminescence (EL), based on the spin-allowed doublet fluorescence. However, the performance of the radical-based EL devices is limited by low carrier mobility which causes a large efficiency roll-off at high current densities. Here, highly efficient and bright doublet EL devices are reported by combining a thermally activated delayed fluorescence (TADF) host that supports both electron and hole transport and a tris(2,4,6-trichlorophenyl)methyl-based radical emitter. Steady-state and transient photophysical studies reveal the optical signatures of doublet luminescence mechanisms arising from both host and guest photoexcitation. The host system presented here allows balanced hole and electron currents, and a high maximum external quantum efficiency (EQE) of 17.4% at 707 nm peak emission with substantially improved efficiency roll-off is reported: over 70% of the maximum EQE (12.2%) is recorded at 10 mA cm-2 , and even at 100 mA cm-2 , nearly 50% of the maximum EQE (8.4%) is maintained. This is an important step in the practical application of organic radicals to NIR light-emitting devices.
RESUMEN
Perovskite light-emitting diodes (LEDs) have attracted broad attention due to their rapidly increasing external quantum efficiencies (EQEs)1-15. However, most high EQEs of perovskite LEDs are reported at low current densities (<1 mA cm-2) and low brightness. Decrease in efficiency and rapid degradation at high brightness inhibit their practical applications. Here, we demonstrate perovskite LEDs with exceptional performance at high brightness, achieved by the introduction of a multifunctional molecule that simultaneously removes non-radiative regions in the perovskite films and suppresses luminescence quenching of perovskites at the interface with charge-transport layers. The resulting LEDs emit near-infrared light at 800 nm, show a peak EQE of 23.8% at 33 mA cm-2 and retain EQEs more than 10% at high current densities of up to 1,000 mA cm-2. In pulsed operation, they retain EQE of 16% at an ultrahigh current density of 4,000 mA cm-2, along with a high radiance of more than 3,200 W s-1 m-2. Notably, an operational half-lifetime of 32 h at an initial radiance of 107 W s-1 m-2 has been achieved, representing the best stability for perovskite LEDs having EQEs exceeding 20% at high brightness levels. The demonstration of efficient and stable perovskite LEDs at high brightness is an important step towards commercialization and opens up new opportunities beyond conventional LED technologies, such as perovskite electrically pumped lasers.
RESUMEN
Fast diffusion of charge carriers is crucial for efficient charge collection in perovskite solar cells. While lateral transient photoluminescence microscopies have been popularly used to characterize charge diffusion in perovskites, there exists a discrepancy between low diffusion coefficients measured and near-unity charge collection efficiencies achieved in practical solar cells. Here, we reveal hidden microscopic dynamics in halide perovskites through four-dimensional (directions x, y and z and time t) tracking of charge carriers by characterizing out-of-plane diffusion of charge carriers. By combining this approach with confocal microscopy, we discover a strong local heterogeneity of vertical charge diffusivities in a three-dimensional perovskite film, arising from the difference between intragrain and intergrain diffusion. We visualize that most charge carriers are efficiently transported through the direct intragrain pathways or via indirect detours through nearby areas with fast diffusion. The observed anisotropy and heterogeneity of charge carrier diffusion in perovskites rationalize their high performance as shown in real devices. Our work also foresees that further control of polycrystal growth will enable solar cells with micrometres-thick perovskites to achieve both long optical path length and efficient charge collection simultaneously.
Asunto(s)
Compuestos de Calcio , Compuestos Inorgánicos , Óxidos , Microscopía ConfocalRESUMEN
In this work, perovskite solar cells (PSCs) with different transport layers were fabricated to understand the hysteresis phenomenon under a series of scan rates. The experimental results show that the hysteresis phenomenon would be affected by the dielectric constant of transport layers and scan rate significantly. To explain this, a modified Poisson and drift-diffusion solver coupled with a fully time-dependent ion migration model is developed to analyze how the ion migration affects the performance and hysteresis of PSCs. The modeling results show that the most crucial factor in the hysteresis behavior is the built-in electric field of the perovskite. The non-linear hysteresis curves are demonstrated under different scan rates, and the mechanism of the hysteresis behavior is explained. Additionally, other factors contributing to the degree of hysteresis are determined to be the degree of degradation in the perovskite material, the quality of the perovskite crystal, and the materials of the transport layer, which corresponds to the total ion density, carrier lifetime of perovskite, and the dielectric constant of the transport layer, respectively. Finally, it was found that the dielectric constant of the transport layer is a key factor affecting hysteresis in perovskite solar cells.
RESUMEN
We describe an unprecedented dual C-H functionalization of indolin-2-one via an oxidative C(sp3)-H/N-H/X-H (X = N, C, S) cross-coupling protocol, which is catalyzed by a simple iron salt under mild and ligand-free conditions and employs air (molecular oxygen) as the terminal oxidant. This method is readily applicable for the construction of tetrasubstituted carbon centers from methylenes and provides a wide variety of spiro N-heterocyclic oxindoles.
RESUMEN
To model the carrier transport in organic light-emitting diodes (OLEDs) with random dopant effects in the emitting layer, two-dimensional simulation was used. By including the Gaussian shape density of states and field-dependent mobility in the Poisson and drift-diffusion solver, the carrier transport, trapping in the dopant state, and radiative recombination were accurately modeled. To examine the model, the current-voltage characteristics of organic light-emitting devices were compared. The host material in the emitting layer was 2,2-bis(1-phenyl-1H-benzo[d]imidazol-2-yl)biphenyl (BImBP), which was doped with bis[2-(4,6-difluorophenyl)pyridinato-C2,N](picolinato)iridium(III) (FIrpic) at various concentrations. By including the random doping model, the trend of mobility was altered and the radiative efficiency fitted experimental values well.