Enhanced Fano resonances in a silicon nitride photonic crystal nanobeam-assisted micro ring resonator for dual telecom band operation.

Silicon-based Micro Ring Resonators (MRR) are a powerful tool for the realization of label free optical biosensors. The sharp edge of a Fano resonance in a Silicon Nitride (Si3N4) platform can boost photonic sensing applications based on MRRs. In this work, we demonstrate enhanced Fano resonance features for a Si3N4 Micro Ring Resonator assisted by a Photonic Crystal Nanobeam (PhCN-MRR) operating in the TM-like mode at the O-band wavelengths. Our findings show that the fabricated PhCN-MRR results in increased asymmetric resonances for TM-like mode compared with TE-like mode operation in the C-band. As a result, a versatile and flexible design to realize Fano resonance with polarization dependent asymmetry in the C and O telecom bands is presented.

Compact angled multimode interference duplexers for multi-gas sensing applications.

A compact, low-loss 2 × 1 angled-multi-mode-interference-based duplexer is proposed as an optical component for integrating several wavelengths with high coupling efficiency. The self-imaging principle in multimode waveguides is exploited to combine two target wavelengths, corresponding to distinctive absorption lines of important trace gases. The device performance has been numerically enhanced by engineering the geometrical parameters, offering trade-offs in coupling efficiency ratios. The proposed designs are used as versatile duplexers for detecting gas combinations such as ammonia-methane, ammonia-ethane, and ammonia-carbon dioxide, enabling customization for specific sensing applications. The duplexers designed are then fabricated and characterized, with a special focus on assessing the impact of the different target wavelengths on coupling efficiency.

Polarization Control in Integrated Graphene-Silicon Quantum Photonics Waveguides.

We numerically investigated the use of graphene nanoribbons placed on top of silicon-on-insulator (SOI) strip waveguides for light polarization control in silicon photonic-integrated waveguides. We found that two factors mainly affected the polarization control: the graphene chemical potential and the geometrical parameters of the waveguide, such as the waveguide and nanoribbon widths and distance. We show that the graphene chemical potential influences both TE and TM polarizations almost in the same way, while the waveguide width tapering enables both TE-pass and TM-pass polarizing functionalities. Overall, by increasing the oxide spacer thickness between the silicon waveguide and the top graphene layer, the device insertion losses can be reduced, while preserving a high polarization extinction ratio.

High-Q asymmetrically cladded silicon nitride 1D photonic crystals cavities and hybrid external cavity lasers for sensing in air and liquids.

In this paper we show a novel design of high Q-factor silicon nitride (SiN) 1D photonic crystal (PhC) cavities side-coupled to curved waveguides, operating with both silica and air cladding. The engineering of the etched 1D PhC cavity sidewalls angle allows for high Q-factors over a wide range of upper cladding compositions, and the achievement of the highest calculated Q-factor for non-suspended asymmetric SiN PhC structures. We show the employment of these type of SiN PhC cavities in hybrid external cavity laser (HECL) configuration, with mode-hop free single mode laser operation over a broad range of injected currents (from 25 mA to 65 mA), milliwatts of power output (up to 9 mW) and side-mode suppression ratios in the range of 40 dB. We demonstrate the operation of these devices as compact and energy efficient optical sensors that respond to refractive index changes in the surrounding medium the measurement of sodium chloride (from 0% to 25%) and sucrose (from 0% to 25%) in aqueous solution. In HECL configuration, the RI sensor exhibits a 2 orders of magnitude improvement in detection limit compared to the passive microcavity. We also discuss the possibility for applying these devices as novel transducers for refractive index changes that are induced by analyte specific absorption of infrared radiation by the target analytes present in gas or liquid phase.

Development and Characterization of Passivation Methods for Microneedle-based Biosensors.

Microneedles (MN) are short, sharp structures that have the ability to painlessly pierce the stratum corneum, the outermost layer of the skin, and interface with the dermal interstitial fluid that lies beneath. Because the interstitial fluid is rich in biomarkers, microneedle-based biosensors have the potential to be used in a wide range of diagnostic applications. To act as an electrochemical sensor, the tip or the body of the MN must be functionalized, while the substrate areas are generally passivated to block any unwanted background interference that may occur outside of the skin. This work presents four different passivation techniques, based on the application of SiO2, polymethyl methacrylate (PMMA), an adhesive film, and varnish to the substrate areas. Optical, SEM and electrochemical measurements were performed to quantitatively assess the performance of each film. The data shows that whilst manual application of varnish provided the highest level of electrical isolation, the spin-coating of a 5 µm thick layer of PMMA is likely to provide the best combination of performance and manufacturability. Clinical Relevance- Substrate passivation techniques will improve the performance of microneedle-based non-invasive continuous monitoring systems.

Thermo-optically induced transparency on a photonic chip.

Controlling the optical response of a medium through suitably tuned coherent electromagnetic fields is highly relevant in a number of potential applications, from all-optical modulators to optical storage devices. In particular, electromagnetically induced transparency (EIT) is an established phenomenon in which destructive quantum interference creates a transparency window over a narrow spectral range around an absorption line, which, in turn, allows to slow and ultimately stop light due to the anomalous refractive index dispersion. Here we report on the observation of a new form of both induced transparency and amplification of a weak probe beam in a strongly driven silicon photonic crystal resonator at room temperature. The effect is based on the oscillating temperature field induced in a nonlinear optical cavity, and it reproduces many of the key features of EIT while being independent of either atomic or mechanical resonances. Such thermo-optically induced transparency will allow a versatile implementation of EIT-analogs in an integrated photonic platform, at almost arbitrary wavelength of interest, room temperature and in a practical, low cost, and scalable system.