Comparison of shielding effects of over-glasses-type and regular eyewear in terms of occupational eye dose reduction.

Given the new recommendations for occupational eye lens doses, various lead glasses have been used to reduce irradiation of interventional radiologists. However, the protection afforded by lead glasses over prescription glasses (thus over-glasses-type eyewear) has not been considered in detail. We used a phantom to compare the protective effects of such eyewear and regular eyewear of 0.07 mm lead-equivalent thickness. The shielding rates behind the eyewear and on the surface of the left eye of an anthropomorphic phantom were calculated. The left eye of the phantom was irradiated at various angles and the shielding effects were evaluated. We measured the radiation dose to the left side of the phantom using RPLDs attached to the left eye and to the surface/back of the left eyewear. Over-glasses-type eyewear afforded good protection against x-rays from the left and below; the average shielding rates on the surface of the left eye ranged from 0.70-0.72. In clinical settings, scattered radiation is incident on physicians' eyes from the left and below, and through any gap in lead glasses. Over-glasses-type eyewear afforded better protection than regular eyewear of the same lead-equivalent thickness at the irradiation angles of concern in clinical settings. Although clinical evaluation is needed, we suggest over-glasses-type Pb eyewear even for physicians who do not wear prescription glasses.

Effect of backscatter radiation on the occupational eye-lens dose.

We quantified the level of backscatter radiation generated from physicians' heads using a phantom. We also evaluated the shielding rate of the protective eyewear and optimal placement of the eye-dedicated dosimeter (skin surface or behind the Pb-eyewear). We performed diagnostic X-rays of two head phantoms: Styrofoam (negligible backscatter radiation) and anthropomorphic (included backscatter radiation). Radiophotoluminescence glass dosimeters were used to measure the eye-lens dose, with or without 0.07-mm Pb-equivalent protective eyewear. We used tube voltages of 50, 65 and 80 kV because the scattered radiation has a lower mean energy than the primary X-ray beam. The backscatter radiation accounted for 17.3-22.3% of the eye-lens dose, with the percentage increasing with increasing tube voltage. Furthermore, the shielding rate of the protective eyewear was overestimated, and the eye-lens dose was underestimated when the eye-dedicated dosimeter was placed behind the protective eyewear. We quantified the backscatter radiation generated from physicians' heads. To account for the effect of backscatter radiation, an anthropomorphic, rather than Styrofoam, phantom should be used. Close contact of the dosimeter with the skin surface is essential for accurate evaluation of backscatter radiation from physician's own heads. To assess the eye-lens dose accurately, the dosimeter should be placed near the eye. If the dosimeter is placed behind the lens of the protective eyewear, we recommend using a backscatter radiation calibration factor of 1.2-1.3.

Basic Performance Evaluation of a Radiation Survey Meter That Uses a Plastic-Scintillation Sensor.

After the Fukushima nuclear power plant accident in 2011, many types of survey meters were used, including Geiger-Müller (GM) survey meters, which have long been used to measure ß-rays. Recently, however, a novel radiation survey meter that uses a plastic-scintillation sensor has been developed. Although manufacturers' catalog data are available for these survey meters, there have been no user reports on performance. In addition, the performance of commercial plastic-scintillation survey meters has not been evaluated. In this study, we experimentally compared the performance of a plastic-scintillation survey meter with that of a GM survey meter. The results show that the two instruments performed very similarly in most respects. The GM survey meter exhibited count losses when the radiation count rate was high, whereas the plastic-scintillation survey meter remained accurate under such circumstances, with almost no count loss at high radiation rates. For measurements at background rates (i.e., low counting rates), the counting rates of the plastic-scintillation and GM survey meters were similar. Therefore, an advantage of plastic-scintillation survey meters is that they are less affected by count loss than GM survey meters. We conclude that the plastic-scintillation survey meter is a useful ß-ray measuring/monitoring instrument.

[Temperature Dependence of Scintillation Survey Meter with and without Temperature Compensation Function].

PURPOSE: The objective of this study was to compare the temperature dependence of a scintillation survey meter with and without the temperature compensation function. Investigation of temperature dependence is important to make precise measurements in various environments. METHOD: The experiment was conducted using the NaI (Tl) scintillation survey meter with the temperature compensation function (TCS-1172) and the NaI (Tl) and CsI (Tl) scintillation survey meters without the temperature compensation function (TCS-171, PDR-111). In all, 1 cm dose equivalent rate (µSv/h) was measured by changing the room temperature from 10 to 40 degree Celsius. RESULT: The results showed that the scintillation survey meter with the temperature compensation function had almost no change in the measured values with changes in room temperature, whereas the 1 cm dose equivalent rate of the scintillation survey meter without the temperature compensation function changed by a maximum of -7.2 (%/10°C) as temperature increased. CONCLUSION: This study confirms that the scintillation survey meter with the temperature compensation function was less dependent on temperature, and stable measurement was possible. However, it was suggested that the scintillation survey meter without the temperature compensation function might cause a drop in the measured value as the temperature rises.

The 2024 Noto Peninsula Earthquake and the Strategy of Medical Assistance from the Tohoku University Hospital.

A moment magnitude (Mw) 7.5 earthquake (the Global IDentifire (GLIDE) number: # Q-2024-000001-JPN) struck the Noto Peninsula of Ishikawa Prefecture on 1 January 2024 at 16:10 (Japan Standard Time). The reversed fault, 150 km in length and subducting beneath the peninsula, resulted in maximum seismic intensity 7 shaking, triggered the tsunami, destroyed over 43 thousand buildings, and disrupted roads and lifelines. The disaster claimed 236 deaths, including 15 indirect disaster deaths as of Jan. 28, 2024. There were Disaster Base Hospitals (DBHs) in the region, which survived structurally but suffered from impaired functions and the surge of medical needs of affected people. The disaster medical system of Japan immediately responded and coordinated the hundreds of emergency medical teams (EMTs), i.e., the Japan Disaster Medical Assistance Team (DMAT), from all over the country. Tohoku University Hospital, which had the experience of the 2011 Great East Japan Earthquake (GEJE), joined the coordinated response, dispatching a chain of DMATs, which helped the medical and public health coordination in Wajima City. The medical and public health needs included injuries, non-communicable diseases, infectious diseases, mental health issues, and maternal and child health issues, which were similar in the affected communities in GEJE. Although the actual damage far exceeded expectations, the structural retrofitting and business continuity plans of DBHs and the coordinated response of the national disaster medical system enhanced the effectiveness of medical and public health response.