Adsorption of Ag (I) Ions at the Zirconium Phosphate/KNO3 Aqueous Solution Interface.

The paper presented the mechanical (MChT), microwave (MWT), and hydrothermal (HTT) methods of zirconium phosphate samples modification in order to improve its adsorption affinity for the Ag (I) ions. The FTIR studies proved that the modification of both gel and xerogel samples with the ultrasonic microwaves causes an increase in the concentration of phosphate groups on the surface of MWT-modified zirconium phosphate: the isoelectric point pHiep = 2.2-2.9 for these samples against 3.9 for the initial sample and pKa2 values were 4.7-5.6 and 6.3, respectively. As resulting from the Ag+ ion adsorption studies, the MWT treatment of zirconium phosphate samples caused the greatest affinity of Ag+ ions for the surface of MWT zirconium phosphate. Compared with the initial ZrP sample, the shift of the Ag (I) ion adsorption edge towards lower pH values was observed, e.g., with adsorption of Ag (I) ions from the solution with the initial concentration of 1 µmol/dm3 for the initial ZrP sample pH50% = 3.2, while for the sample MWT ZrPxero pH50% = 2.6.

Adsorption of the Tartrate Ions in the Hydroxyapatite/Aqueous Solution of NaCl System.

The research on the interaction of tartrate ions with the surface of hydroskyapatite was presented, including the measurements of the kinetics of tartrate ion adsorption and tartrate ion adsorption as a function of pH. The adsorption of tartrate ions was calculated from the loss of tartrate concentration in the solution as measured by a radioisotope method using C-14 labeled tartaric acid. In order to explain the mechanism of interaction of tartrate ions with hydroxyapatite, supplementary measurements were carried out, i.e., potentiometric measurements of the balance of released/consumed ions in the hydroxyapatite/electrolyte solution system, zeta potential measurements, FTIR spectrophotometric measurements and the hydroxyapatite crystal structure and particle size distribution were characterized. It was found that the adsorption of tartrate ions occurs as a result of the exchange of these ions with hydroxyl, phosphate and carbonate ions. Replacing the ions with the abovementioned tartrate ions leads to the appearance of a negative charge on the surface of the hydroxapatite. On the basis of XRD study and particle size distribution, a decrease in the size of crystallites and the diameter of hydroxyapatite particles in contact with a solution of 0.001 mol/dm3 of tartaric acid was found.

Synthesis, Structural, and Adsorption Properties and Thermal Stability of Nanohydroxyapatite/Polysaccharide Composites.

A series of composites based on nanohydroxyapatite (nHAp) and natural polysaccharides (PS) (nHAp/agar, nHAp/chitosan, nHAp/pectin FB300, nHAp/pectin APA103, nHAp/sodium alginate) was synthesized by liquid-phase two-step method and characterized using nitrogen adsorption-desorption, DSC, TG, FTIR spectroscopy, and SEM. The analysis of nitrogen adsorption-desorption data shows that composites with a nHAp: PS ratio of 4:1 exhibit a sufficiently high specific surface area from 49 to 82 m2/g. The incremental pore size distributions indicate mainly mesoporosity. The composites with the component ratio 1:1 preferably form a film-like structure, and the value of S BET varies from 0.3 to 43 m2/g depending on the nature of a polysaccharide. Adsorption of Sr(II) on the composites from the aqueous solutions has been studied. The thermal properties of polysaccharides alone and in nHAp/PS show the influence of nHAp, since there is a shift of characteristic DSC and DTG peaks. FTIR spectroscopy data confirm the presence of functional groups typical for nHAp as well as polysaccharides in composites. Structure and morphological characteristics of the composites are strongly dependent on the ratio of components, since nHAp/PS at 4:1 have relatively large S BET values and a good ability to adsorb metal ions. The comparison of the adsorption capacity with respect to Sr(II) of nHAp, polysaccharides, and composites shows that it of the latter is higher than that of nHAp (per 1 m2 of surface).

Silica-Supported Titania-Zirconia Nanocomposites: Structural and Morphological Characteristics in Different Media.

A series of TiO2-ZrO2/SiO2 nanocomposites were synthesized using a liquid-phase method and characterized by various techniques, namely, nitrogen adsorption-desorption, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), Raman spectroscopy, high-resolution transmission electron microscopy, and photon correlation spectroscopy (PCS). It was revealed that the component ratio and calcination temperature affect the phase composition of nanocomposites. Composites TiZrSi1 (TiO2:ZrO2:SiO2 = 3:10:87) and TiZrSi2 (10:10:80) calcined at 1100 °Ð¡ demonstrate the presence of t-ZrO2 crystallites in TiZrSi1 and ZrTiO4 phase in TiZrSi2. The samples calcined at 550 °Ð¡ were amorphous as it was found from XRD data. According to the Raman spectra, the bands specific for anatase are observed in TiZrSi2. According to XPS data, Zr and Ti are in the highest oxidation state (+4). Textural analysis shows that initial silica is mainly meso/macroporous, but composites are mainly macroporous. The particle size distributions in aqueous media showed a tendency of increasing particle size with increasing TiO2 content in the composites.

Electrokinetic Properties of the Pristine and Oxidized MWCNT Depending on the Electrolyte Type and Concentration.

Electrostatic stabilization is reduced in its efficiency in an electrolyte-containing environment. The effect of electrolyte concentration is mostly described as negative factor for dispersion stabilization. Usually, zeta potential and physical stability decrease at increasing electrolyte concentration. The purpose of the present study was to measure the surface properties of nanotubes in aqueous solution of monovalent electrolytes at different concentration. Characteristics such as size distribution, surface chemistry, surface charge, and dispersability in aqueous phase have been identified. Hydrodynamic size and zeta potential in aqueous multiwalled carbon nanotube (MWCNT) suspensions were determined at different pH with the desired concentrations of electrolyte of the cationic group (NaCl, KCl, CsCl) and the anionic group (NaClO4). The correlations between the response of the surface functionality of pristine and oxidized multiwalled carbon nanotubes and electrical double layer (EDL) forming at different ionic environments in the vicinity of a nanotube surface were determined. The nanotube dispersion stabilization was found to be more affected by ion size and pH medium then electrolyte concentration. The data obtained confirms the predominant role of surface reactions. The most stable dispersion of nanotubes was achieved in KCl electrolyte solution at less negative charge of the surface.

Influence of the Modifier Type and its Concentration on Electroosmotic Flow of the Mobile Phase in Pressurized Planar Electrochromatography.

The aim of this work was to find a relationship between electroosmotic flow (EOF) velocity of the mobile phase in pressurized planar electrochromatography (PPEC) and physicochemical properties like zeta potential, dielectric constant, and viscosity of the mobile phase as well as its composition. The study included different types of organic modifiers (acetonitrile, methanol, ethanol, acetone, formamide, N-methylformamide and N,N-dimethylformamide) in the full concentration range. In all experiments, chromatographic glass plates HPTLC RP-18 W from Merck (Darmstadt) were used as a stationary phase. During the study we found that there is no linear correlation between EOF velocity of the mobile phase and single variables such as zeta potential or dielectric constant or viscosity. However, there is quite strong linear correlation between EOF velocity of the mobile phase and variable obtained by multiplying zeta potential of the stationary phase-mobile phase interface, by dielectric constant of the mobile phase solution and dividing by viscosity of the mobile phase. Therefore, it could be concluded that the PPEC system fulfilled the Helmholtz-Smoluchowski equation.

Effect of zeta potential value on bacterial behavior during electrophoretic separation.

The aggregation and/or adhesion of bacterial cells is a serious disadvantage of electrophoretic separations. In this study, physicochemical surface characteristics of bacteria were measured to establish their role in bacterial adhesion and aggregation on the basis of electrophoretic behavior of different clinical strains of Gram-positive Staphylococcus aureus and Gram-negative Escherichia coli bacteria. The number and the shape of peaks obtained on the electropherograms were connected with the zeta potential measurements and in-line microscope observation using specially designed CE fluorescence stereomicroscope setup. These results suggest that the lower the zeta potential, the higher the number of smaller peaks detected. The direct microscopic observation of electrophoretic movement proved the presence of many small aggregates originating from individual or clustered bacterial cells. On the other hand, lower zeta potential was also observed for dead bacterial cells, which suggested that some of the peaks can be attributed to viable cells while the other to the dead ones.

Effect of adsorption of Pb(II) and Cd(II) ions in the presence of EDTA on the characteristics of electrical double layers at the ion exchanger/NaCl electrolyte solution interface.

The main propose of this work was to describe the basic parameters of electrical double layer structures of the ion exchanger/NaCl before and after the sorption process of Pb(II) and Cd(II) ions from aqueous solutions in the presence of the complexing agent EDTA (ethylenediaminetetraacetic acid). In the studies the following ion exchangers were used: cation exchangers Micro-ionex (in the H(+) and NH(+)(4) forms), Dowex 50W x 4 (in the H(+) form), and Dowex 50W x 12 (in the H(+) form); anion exchangers Dowex 1 x 4 (in the Cl(-) form) and Dowex 1 x 8 (in the Cl(-) form). Study of the physicochemical properties of the sample surface was carried out. The influence of ionic strength, pH, and solution interface was investigated. Electrophoretic mobility, surface charge density, and parameters for different concentrations of the electrolytes under question were presented. pH was changed from 3 to 10. The studies were carried out for the M(II)-EDTA = 1:1 system. The effects of the concentration of the solution containing the above-noted complexes and of the ion exchange/solution phase contact time on sorption capacities of the ion exchangers under consideration were studied. Kinetic parameters of the sorption process were also determined.

Competitive adsorption of Ca2+ and Zn(II) ions at monodispersed SiO2/electrolyte solution interface.

A study of competitive adsorption of Ca(2+) and Zn(II) ions at the monodispersed SiO(2)/electrolyte solution interface is presented. Influence of ionic strength, pH, and presence of other ions on adsorption of Ca(2+) and Zn(II) in the mentioned system are investigated. zeta potential, surface charge density, adsorption density, pH(50%), and DeltapH(10-90%) parameters for different concentrations of carrying electrolyte and adsorbed ions are also presented. A high concentration of zinc ions shifts the adsorption edge of Ca(2+) ions adsorbed from solutions with a low initial concentration at the SiO(2)/NaClO(4) solution interface to the higher pH values. This effect disappears with a concentration increase of calcium ions. The presence of Ca(2+) ions in the system slightly affects the adsorption of zinc ions on SiO(2), shifting the adsorption edge toward lower pH values and thereby increasing the adsorption slope.

Multiinstrument study of the electrophoretic mobility of fumed silica.

Although silica is one of the most common adsorbents, the position of its isoelectric point (IEP) on the pH scale remains an open question. Different values from 1 to 4 have been published, and there is even a controversy about the very existence of the IEP. The discrepancies in the literature are at least partially due to application of different instruments. Different zetameters produce different zeta potentials of silica in the acidic range and different IEP.

Multiinstrument study of the electrophoretic mobility of quartz.

The electrophoretic mobility of quartz in 0.01 mol dm(-3) NaCl and NaNO3 over the pH range 2-8 was studied using five different commercial instruments. The mobilities over the pH range 4-8 were relatively consistent, but the mobilities over the pH range 2-4 and the position of the isoelectric point IEP varied from one instrument to another. This result suggests that the discrepancies in the apparent IEP of quartz (and other silicas) reported in the literature are due to the instrument artifacts.

Optical aspects of Na+ ions adsorption on sol-gel porous films used in optical fiber sensors.

Adsorption of Na+ ions from water solutions on the surface of a porous silica layer covering the optical fiber core was studied. It was shown that Na+ ions adsorbed on silica obtained by the sol-gel method influence optical signal transmitted by optical fiber. The dependence of optical signal intensity on pH was observed. The results of optical measurements are in good agreement with those obtained by the potentiometric titration and adsorption of Na+ cations with application of a radioactive isotope.